SilverStone Strider ST85F-PT Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor SilverStone Strider ST85F-PT (8 pagina's) in de categorie Oplader voor mobiel apparaat. Deze handleiding was nuttig voor 55 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
ST85F-PT
STRIDER PLATINUM SERIES
World’s smallest 80 PLUS Platinum,
full-modular ATX power supplies
High efficiency with 80 PLUS Platinum certification
Compact design with a depth of 140mm for easy integration
100% modular cables
24/7 continuous power output with 40 operating temperature
Class-leading single +12V rail
Strict ±3% voltage regulation and low ripple & noise
Ultra silent 120mm fan with intelligent semi-fanless operation
o
SPECIFICATION
SilverStone Strider Platinum
SST-ST85F-PT
ATX12V / EPS 12V Switching Power Supply
With Active PFC
80Plus Platinum
PS/2
01
1.1 Scope
This specification defines the performance characteristics of a single phase 750, 650, 550 watts, 5 output
power supply. This specification also defines worldwide safety and electromagnetic compatibility
requirements for the power supply which is intended for use in computer products.
Nominal Voltage
100-240 Vrms
Voltage Variation Range
90 - 264 Vrms
1. General
2.1 Input Voltage
2.2 Input Frequency
* The power supply must operate at above frequency with 90-264 VACrms input voltage range.
2. Input Characteristics
Nominal Frequency
50-60 Hz
Frequency Variation Range
47 Hz to 63 Hz
02
2.3 Max. Input AC Current
3.1 Normal Operation Output
3. Output characteristics
Max. Input Current
2.4 Inrush Current
The power supply must meet inrush requirements for any rated AC voltage, during turn on at any phase
of AC voltage, during a single cycle AC dropout condition, during repetitive ON/OFF cycling of AC, and
over the specified temperature range. The peak inrush current shall be less than the ratings of its critical
components (including input fuse, bulk rectifiers, and surge limiting device).
2.5 Eciency
ST85F-PT provides an efficiency of 90% minimum when measured at 20% load , provides an efficiency of 92%
minimum when measured at 50% load, provides an efficiency of 89% minimum when measured at 100% load,
under 115V/60Hz and 230V/50Hz condition.
Maximum continuous total DC output power should not exceed 850W.
Maximum continuous combined load on +3.3VDC and +5VDC outputs shall not exceed 120W.
Maximum combined load on +12V outputs shall not exceed 850W.
NOTE:
Noise test should be measured with 20 MHz bandwidth frequency oscilloscope. The output terminal shall
add a tantalum capacitor of 10uF in parallel with a ceramic capacitor of 0.1uF.
3.2 Remote On/O Controlled mode
The PSON# signal is required to remotely turn on/off the power supply, PSON# is an active low signal that
turns on the output power rails. When this is not pulled low by the system, or left open, the outputs (except
the +5VSB) turn off. This signal is pulled to a standby voltage by a pull-up resistor internal to the power
supply.
TTL level "H" 2.0 V – 5.25 V
"L" 0.0 V – 1.0 V
12A
Measuring Range
90 - 264 Vrms
Output Voltage
1. +5V
2. +12V
3. –12V
4. +5Vs
5. +3.3V
Load MIN
0.2A
0.0A
0.0A
0.0A
0.0A
Range MAX
22A
70.9A
0.3A
3.0A
22.0A
Regulation
±3%
±3%
±10%
±5%
±3%
Ripple & Noise P-P Max.
50mV
120mV
120mV
50mV
50mV


Product specificaties

Merk: SilverStone
Categorie: Oplader voor mobiel apparaat
Model: Strider ST85F-PT

Heb je hulp nodig?

Als je hulp nodig hebt met SilverStone Strider ST85F-PT stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Oplader voor mobiel apparaat SilverStone

Handleiding Oplader voor mobiel apparaat

Nieuwste handleidingen voor Oplader voor mobiel apparaat