Shaws AUSH-4756 Handleiding
Lees hieronder de ๐ handleiding in het Nederlandse voor Shaws AUSH-4756 (8 pagina's) in de categorie Kraan. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8

COLD
IN
HOT
IN
๎๎๎mm
hole
G 1/2โ
๎๎๎ centres
G 1/2โ to suit
dual check valve
Con-Serv DC๎๎๎CFF
Hose Length ๎๎๎๎mm
๎๎๎mm
Hole
๎ ๎mm max
Hambleton
AUSH.4751 - BRIDGE MIXER
AUSH.4756 - BRIDGE MIXER WITH SPRAY RINSE
Please Note: This model does not suit incoming water pressure
below 100kPa or higher than 500kPa. The spray rinse model requires
a minimum inlet pressure of 100kPa to successfully divert the water
๏ฌow from the main tap to the spray rinse. The stop cocks provided
with this tap contain gauze ๏ฌlters. Please ensure your plumber is
advised of the minimum and maximum water pressure, and to install
the stop cocks as failure to do so voids the tap warranty.
Temperature Range Min 1ยฐC. Max 70ยฐC
Working Pressure Min 100kPa (14.5psi). Max 500kPa (72.5psi)
Flow Rates AUSH.4751
๎ Bar: ๎๎๎L/min
๎ Bar: ๎๎๎๎L/min
๎ Bar: ๎๎๎๎L/min
AUSH.4756
๎ Bar: ๎๎๎L/min
๎ Bar: ๎๎๎L/min
๎ Bar: ๎๎๎๎L/min
Ideal performance obtained with equal hot & cold pressures.
I M P OR T E R S & D I S T RI B UT OR S O F F I N E K I T C H E N A ND B AT H R O O M WA R E
๎๎ ๎๎6๎ ๎๎๎๎ | ๎๎ French Avenue, Brendale QLD 4500 | aftersales@luxebydesign.com.au | www.luxebydesign.com.au


Rinse
Black rubber
washer
Rinse unit
socket
Shank
Brass tube
Rinse connector
G 1/2โ
Dual check valve
Con-Serv DC055CFF
Flexible
hose
Hambleton | INSTALLATION AND USER GUIDE
1
Ensure the mixer is oriented correctly, levers should
rotate to point forward and the hot index should be
situated on the left.
๎ x ๎๎๎mm holes with 200mm hole centres are
required to mount the bridge mixer. For spray rinse
models, an additional ๎๎๎mm hole, located to the right
hand side of the tap is also required for the spray rinse
unit. Maximum counter top thickness is 40mm.
Secure the mixer with a suitable tap wrench or a 26 AF
spanner.
The kitchen tap with rinse is supplied with a brass tube
protruding out of the bottom of the shank. Please
be careful not to damage the end of this tube during
installation.
If your mixer has a rinse, please follow steps 2, 3 & 4 to
install correctly, otherwise please connect the hot &
cold water supplies to the shanks.
Ensure all connections are ๏ฌrmly tightened.
3Ensure the black rubber washers are situated inside positions A,
B, C, F and E on the rinse connector, including the double check
non-return valve as shown in the diagram.
Screw the rinse connector onto the end of the ๏ฌexible hose.
Ensure the connection is ๏ฌrmly tightened.
4IMPORTANT: Do not cut brass tube.
Carefully feed the rinse connector over the protruding
brass tube and secure tightly onto the shank.
Ensure the black rubber washer is in place before securing
the rinse to the ๏ฌexible hose.
Holding the rinse, screw the ๏ฌexible hose onto the end of
the rinse and place the rinse into the rinse unit socket. Make
sure the orientation of the rinse is correct.
Connect hot & cold water supplies to the shanks.
Ensure all connections are ๏ฌrmly tightened.
Please note: Ceramic disc valves are ๏ฌtted as standard
to this mixer. Flow from fully o๏ฌ to fully on is achieved by
rotating the handles a quarter turn.
2
Secure the rinse unit socket in a suitable position using a tap
wrench of a 36 AF spanner.
Place the ๏ฌexible hose through the top of the rinse unit socket as
shown in the diagram.
LUXEBYDESIGN.COM.AU
รธ30mm
Hole
WORK SURFACE
Base seal
Rinse unit
socket
Fibre washer
Backnut
Flexible hose
WORK SURFACE
Rinse
connector
Dual
check
valve
A
E
B
C
D
G 3/8โ
BEFORE USE ๎ Carefully check the installation for leaks
๎ If further building work is being carried out in the vicinity, cover the product to avoid damaging the ๏ฌnish.
๎ Please ensure the installation complies with the water supply by-laws.
๎๎๎
Base ring
WORK SURFACE
รธ๎๎mm
hole
Base seal
Fibre washer
Backnut
G 1/2โG 1/2โ
Congratulations on the purchase of your Shaws by Perrin & Rowe kitchen product. Correctly installed and with sensible care,
this product will give you many years of trouble-free service.
INSTALLATION REQUIREMENTS
Perrin & Rowe tapware must be installed by a Licensed Plumber in accordance with the installation instructions provided, best
trade practices and must comply to local plumbing regulations in your area. Incorrect installation may damage your tap and
could invalidate your warranty.
๎ Where the inlet water pressure exceeds 500kpa, pressure limiting valves must be installed.
๎ In-line gauze ๏ฌlters must be ๏ฌtted in the incoming water supply lines.
๎ Prior to installation, it is important to ๏ฌush all incoming water lines thoroughly. Failure to do so may result in issues caused
by debris in the water supply such as bits of metal or plastic, dirt, sand, rust, silt, and other unwanted materials. Any
problems that arise as a result of inadequate ๏ฌushing may not be covered by the warranty.
๎ Please take care of this product before, during and after installation as accidental damage to the tap ๏ฌnish is not covered
by the warranty. Please wear gloves when handling 'living ๏ฌnish' models. If further work is to be carried out in the vicinity of
the product, please cover it to protect from paint, plaster, adhesives, sealants and cleaning products.
๎ For ease of possible future servicing, we recommend the ๏ฌtting of conveniently placed isolating valves.
๎ Once unpacked, remove ๏ฌxing nuts, clamp plate, ๏ฌbre washer and plastic backnut from tap assembly, ready for installation.
DISTRIBUTED IN AUSTRALIA BY LUXE BY DESIGN ๎ ๎๎ ๎๎๎๎ ๎๎๎๎ ๎ AFTERSALES@LUXEBYDESIGN๎COM๎AU
Product specificaties
Merk: | Shaws |
Categorie: | Kraan |
Model: | AUSH-4756 |
Heb je hulp nodig?
Als je hulp nodig hebt met Shaws AUSH-4756 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Kraan Shaws

7 April 2025

7 April 2025

7 April 2025

7 April 2025

7 April 2025
Handleiding Kraan
- Kraan IKEA
- Kraan Etna
- Kraan Inventum
- Kraan Brita
- Kraan Delta
- Kraan Ernesto
- Kraan Franke
- Kraan Grohe
- Kraan Hansgrohe
- Kraan Hotto
- Kraan KitchenAid
- Kraan Livarno
- Kraan Lynx
- Kraan Miomare
- Kraan Quooker
- Kraan Smeg
- Kraan Stiebel Eltron
- Kraan Teka
- Kraan Concept
- Kraan Elba
- Kraan Blanco
- Kraan Caple
- Kraan CDA
- Kraan Curaqua
- Kraan Schรผtte
- Kraan Lamona
- Kraan Nodor
- Kraan Empire
- Kraan Brauer
- Kraan Elkay
- Kraan Oras
- Kraan Sloan
- Kraan Berg
- Kraan Mizzo
- Kraan Peerless-AV
- Kraan ZLine
- Kraan Moen
- Kraan Mueller
- Kraan Aloni
- Kraan WillieJan
- Kraan Everpure
- Kraan Sani-Lav
- Kraan Fala
- Kraan Neo
- Kraan Lomazoo
- Kraan American Standard
- Kraan Livarno Lux
- Kraan Billi
- Kraan SaniSupreme
- Kraan Deante
- Kraan InSinkErator
- Kraan Omnires
- Kraan Vola
- Kraan Zip
- Kraan The Galley
- Kraan Viidako
- Kraan Waltec
- Kraan Gessi
- Kraan Puretec
- Kraan Sussex
- Kraan Fantini
- Kraan Oliveri
- Kraan Rogerseller
- Kraan Axor
- Kraan Graff
- Kraan Zurn
- Kraan Karran
- Kraan Symmons
- Kraan Jacuzzi
- Kraan Rohl
- Kraan ProFlo
- Kraan Pfister
- Kraan BTI Aqua-Solutions
Nieuwste handleidingen voor Kraan

7 April 2025

7 April 2025

7 April 2025

7 April 2025

7 April 2025

7 April 2025

7 April 2025

7 April 2025

7 April 2025

6 April 2025