Satel AOCD-250 Handleiding

Satel Bewegingsdetector AOCD-250

Lees hieronder de 📖 handleiding in het Nederlandse voor Satel AOCD-250 (7 pagina's) in de categorie Bewegingsdetector. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/7

aocd-250_en 04/18

WIRELESS OUTDOOR

DUAL TECHNOLOGY CURTAIN DETECTOR

AOCD-250

Firmware version 1.00

SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND

tel. +48 58 320 94 00

www.satel.eu

WARNING

The device should be installed by qualified personnel.

Read carefully this manual before proceeding to installation.

Changes, modifications or repairs not authorized by the manufacturer shall void your rights

under the warranty.

SATEL's goal is to continually upgrade the quality of its products, which may result in some

changes of their technical specifications and firmware. The current information on

the introduced modifications is available on our website.

Please visit us:

http://www.satel.eu

Hereby, SATEL sp. z o.o., declares that this detector is in compliance with the

essential requirements and other relevant provisions of Directive 2014/53/EU. The

declaration of conformity may be consulted at www.satel.eu/ce

The following symbols may be used in this manual:

- note;

- caution.

The AOCD-250 detector makes it possible to detect motion at the moment of crossing the

perimeter of protected area. It is designed for perimeter protection. The detector is designed

for use as part of the ABAX two-way wireless system. This manual applies to the detector

with firmware version 1.00, which is supported by:

 ACU-120 / ACU-270 controller with firmware version 5.02 2016-04-01 (or newer),

 ARU-100 repeater with firmware version 2.02 2015-06-01 (or newer),

 INTEGRA 128-WRL control panel with firmware version 1.15 2016-03-09 (or newer) and

firmware version of processor used to operate ABAX system 3.05 (or newer).

1. Features

 Passive infrared (PIR) sensor and microwave sensor.

 Adjustable detection sensitivity of both sensors.

 Remote configuration.

 Digital motion detection algorithm.

 Digital temperature compensation.

 Tricolor LED indicator.

 Supervision of detector signal path.

 Battery status control.

 Tamper protection against cover removal and tearing enclosure from the wall.

 Weatherproof enclosure featuring a very high mechanical strength.

 Angle-type mounting bracket included.

2. Description

Alarms

The detector reports alarm in the following cases:

 both sensors have detected motion within a time interval of less than 5 seconds. This

alarm can only be reported in the active mode (see: „Operating modes”).

 tamper switch has been opened (tamper alarm).

Operating modes

Switching between the operating modes is done remotely.

Active mode – motion detection alarm or tamper alarm can be triggered. The microwave

sensor activates after motion is detected by the infrared sensor.

Passive mode – tamper alarm only can be triggered. The microwave sensor is inactive.

During polling, the detector indicates whether motion has been detected by the infrared

sensor. The passive mode prolongs the battery life.

The alarm information is sent instantly.

Test mode

If you want to test the detector, you can remotely enter the test mode. When in the test mode,

the detector LED is working.

Product specificaties

Merk:	Satel
Categorie:	Bewegingsdetector
Model:	AOCD-250
Kleur van het product:	Wit
Breedte:	44 mm
Diepte:	105 mm
Hoogte:	40 mm
Connectiviteitstechnologie:	Draadloos
Type stroombron:	Batterij/Accu
Accu/Batterij voltage:	3 V
Ondersteund aantal accu's/batterijen:	1
Certificering:	EN50131-1, EN50130-4, EN50130-5
Type beeldsensor:	Passieve infraroodsensor (PIR)/Microgolfsensor
Aantal per verpakking:	1 stuk(s)
Frequentie:	868 - 868.6 MHz
Bedrijfstemperatuur (T-T):	-40 - 55 °C
Relatieve vochtigheid in bedrijf (V-V):	0 - 93 procent
Type batterij:	CR123A
Installatie hoogte (max):	2.4 m
HUE-dimmerschakelaar International Protection (IP) codering:	IP54