Rupert Neve Designs Portico 542 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Rupert Neve Designs Portico 542 (11 pagina's) in de categorie Processor. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/11
By:
Serial #:
Operations Manual
Portico 542
500 Series Tape Emulator
2
PORTICO 542: 500 SERIES TAPE EMULATOR
Thank you for your purchase of the 542: 500 Series Tape Emulator. Everyone at
Rupert Neve Designs hope you enjoy using this tool as much as we have enjoyed
designing and building it. Please take note of the following list of safety concerns
and power requirements before the use of this or any Portico Series product.
SAFETY
It’s usual to provide a list of “do’s and don’ts” under this heading but mostly these
amount to common sense issues. However here are some reminders:
Don’t operate your Portico™ module in or around water! Electronic equipment and
liquids are not good friends. If any liquid is spilled such as soda, coffee, alcoholic
or other drink, the sugars and acids will have a very detrimental effect. Sugar
crystals act like little rectiers and can produce noise (crackles, etc.). SWITCH OFF
IMMEDIATELY because once current starts to ow, the mixture hardens, can get
very hot (burnt toffee!) and cause permanent and costly damage. Please contact
support as soon as possible at support@rupertneve.com for resolution.
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
8) Do not install near any heat source such as radiators, heat registers, stoves, or
other apparatus (including ampliers) that produce heat.
9) Refer all servicing to qualied service personnel. Servicing is required when the
apparatus has been damaged in any way, such as when power-supply cord or plug
is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
10) Do not expose this apparatus to rain or moisture.
542 DESCRIPTION
As a follow up to the Portico 5042, the 542 delivers a remarkable simulation of
true tape sound through the inclusion of genuine tape drive circuitry, while also
incorporating a number of new controls for adding analogue color and tone to
individual tracks or mixes. The Portico 542’s “True Tape” emulation circuit provides
the nostalgic rounding and compression usually only achieved by the use of
tape, and can offset the harshness often found in digital recordings. Unlike digital
emulations, the “True Tape” drive circuit works by feeding a tiny magnetic “record
head”, which in turn is coupled to a correctly equalized, replay amplier. As the
voltage rises on the “record head”, saturation increases, and a soft clip circuit
engages at higher levels to round off peak transients. The sound of the tape circuit
can be further modied with selectable 15 / 30 IPS modes and a pre / post tape
3
PORTICO 542: BLOCK DIAGRAM
PORTICO 542: FRONT PANEL
INPU T TR AN SFO RMER
INPUT STAGE OUTPUT STAGE
OU TPU T TR AN SFOR MER
OU TPU T
INPU T
-
SAT UR ATIO N TR AN SFO RMER
RECOVERY
DE-EMPHASIS
DRIVE
PRE-EMPHASIS / SOFT-CLIP
-
--
BLEND AMP
SAT ENGAGE
SAT ENGAGE
BLEND
IPS
15 IPS
30 IPS
SILK
RED
BLUE
TEXTURE
+/-12dB TRIM
Drive M eter
Level M eter
blend control. In addition to the tape circuit, the 542 also has the variable Silk /
Texture found in the Portico II series of modules, which allows the engineer to ne
tune the harmonic ratio and tonality on the output transformer.


Product specificaties

Merk: Rupert Neve Designs
Categorie: Processor
Model: Portico 542

Heb je hulp nodig?

Als je hulp nodig hebt met Rupert Neve Designs Portico 542 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Processor Rupert Neve Designs

Handleiding Processor

Nieuwste handleidingen voor Processor