Rio TANM Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Rio TANM (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
AIRBRUSH SETUP
MODE
L
M
H
1. Attach the holster (a) to the compressor (b).
2. Attach the hose to the airbrush making sure that it is fully
attached.
3. Attach the hose to the compressor, again, making sure that it is
fully attached.
4. Plug the mains adaptor into the compressor.
5. Screw the tanning dispenser, into the thread at the top of the
airbrush.
6. Pour the tanning solution into the tanning dispenser, and
firmly replace the lid.
7. Keep the airbrush and dispenser upright at all times to prevent
any solution leakage, if you need to set the airbrush down while
full, place it in the holster at the side of your compressor.
8. Place the compressor on a flat, steady surface.
9. Turn on the compressor.
10. To change the speed of the air flow, press ‘MODE’.
IMPORTANT NOTES ON THE USE AND STORAGE OF THE
COMPRESSOR:
l The compressor should be stored and used in a dry, clean, well
ventilated space.
l Do not store in direct sunlight
l The compressor should not be left running idle for longer than
10 minutes.
AIRBRUSH MAINTENANCE
To avoid blockages with your airbrush it is advised that as soon after
each tanning session as possible, you ‘flush clean’ your airbrush.
To do this. fill your tanning dispenser with clean warm water, and
spray through the airbrush.
Flow indicator lights,
show the speed of
airflow the compressor
is set to.
LOW
MEDIUM
HIGH
PREPARATION
Thoroughly preparing your skin prior to spray tanning is the key to
the perfect finish.
l Do NOT use deodorants, perfumes, lotions or make-up prior to
tanning. These products can affect the performance and colour
of your tan.
l Remove all jewellery.
l Pull up hair, away from face and neck with a hair tie and cover with
a hair cap, push the cap up about a quarter of an inch above the
hair line to prevent any white lines occurring.
TIPS TO ACHIEVE THE PERFECT RESULT:
HAIR REMOVAL
Although not strictly essential the best results will be on hair-free
skin. If you wax or use sugaring, allow 48 hours before tanning,
otherwise tiny speckles of concentrated colour may appear in the
hair follicle. These will fade with your tan. If shaving, leave 24 hours
before tanning.
EXFOLIATING
It is important to exfoliate thoroughly. Dead, dry skin cells absorb the
tanning solution much faster than young, new cells resulting in an
uneven, patchy tan which will quickly fade. Particular care should be
taken to exfoliate the ‘dry zones’ (such as knees, hands, elbows and
feet). The exfoliating glove provided, will aid with this. Shower after
exfoliating and dry thoroughly.
MOISTURISING
Do NOT moisturise your whole body prior to tanning. Moisturise
ONLY the ‘dry zones’ (knees, hands, elbows and feet) with a WATER
BASED moisturiser. Oil based moisturisers form a barrier which is
not easily penetrated by the tanning solution.
TOP TIPS
Apply a barrier cream (such as petroleum jelly or lip balm) to lips,
eyebrows, toenails and fingernails to prevent any discolouration.
SPRAY TANNING
Take care not to get any tanning solution in your eyes, should this
happen rinse thoroughly with clean water, should persistent irritation
occur, consult your doctor.
Choose an appropriate area; tanning solution can stain some
fabrics. Protect your immediate surroundings with an old towel.
Turn on the compressor. Moving the airbrush trigger backwards
starts the flow of tanning solution. The further you move the trigger
backwards, the greater the flow. As you spray, you will see the
coloured tanning solution on the skin. The colour is added bronzer
that will act as a guide for you to see where you have sprayed. You
can adjust the speed of the airflow by pressing the ‘MODE’ button.
TOP TIP
You may find it easier to spray the
first ‘burst’ of solution onto a tissue,
so to give you a feel for how it works,
before applying it to your skin.
As a guide, hold the airbrush 15-20
cm from your skin. Varying the
distance will increase/decrease the
amount of tanning solution on the
skin.
Spray using a circular motion. It is important to keep the airbrush
moving.
15-20cm
Take care not to kink the hose during use. Otherwise the spray
performance will be affected.
When refilling the tanning dispenser or not spraying, turn off the
compressor.
When spraying your whole body, work upwards from your feet. Move
onto your stomach, and then torso up to the neck area.
Then move onto the arms. For a natural effect apply lightly to the
underside of the arms - to achieve this, simply hold the airbrush
further away. Remember to include the underarm area.
NOTE: If drips occur, you are holding the airbrush too close, or
moving it too slowly.
When tanning the face, tilt your head
back slightly, close your eyes, take a
breath and spray using a downward
angle, keeping the airbrush moving at
all times. Avoid breathing in or getting
any solution in your eyes, whilst spraying
the face.
NOTE: For some parts of the body, such
as the back, you may need to ask a
friend or partner to help.
AFTER TANNING
Wipe palms and soles of feet with a baby/wet wipe or damp flannel
to prevent dark patches.
Try not to move whilst the solution is drying. This usually takes
between 3-5 minutes, but may vary depending on the amount of
solution applied, the air temperature and humidity. You can use a
hair dryer if you wish.
Don’t get dressed until you are completely dry, you should wear
loose fitting, cotton clothes for the first 12 hours.
You should NOT shower for at least 12 hours after spray tanning,
your tan colour will develop quickly over the first 3-4 hours and reach
its deepest colour after 12 hours. Avoid physical exercise that might
induce sweating for the first 12 hours as this can cause streaking in
your tan.
When you shower, you will see some colour washing off, don’t worry,
this is normal, it is just the bronzer ‘guide’ colour that has been
added to the tanning solution, the bronzer will wash off but the tan
will remain. You may wish to use an old towel for the first shower
after tanning.
TOP TIPS
Your tan colour will develop quickly over the first 3-4 hours, and reach
its deepest colour after 12 hours. If you wish to deepen your tan,
respray after 24 hours, without exfoliating. To maintain you tan, apply
every 4-6 days.
l Exfoliate well - A long soak in a warm bath before exfoliating will
make the process more efficient.
l Moisturise the ‘dry zones’ well.
l Check that you are not too hot as perspiration may cause
streakiness.
l Moisturising thoroughly each night will prolong your tan.
l Long, hot baths speed up the natural exfoliation process, so
avoid these after tanning if you wish to prolong your colour.
l DO NOT shower for at least 12 hours after tanning.
l Don’t forget to wipe your hands and soles of feet straight after
tanning.
CUSTOMER C ARE
If you have any questions, or if you experience any difficulties
please call our Rio Careline on: or email us at: 01242 702345
online@riobeauty.com
To register your two year guarantee online visit:
www.riobeauty.com/warranty_online.htm
DISPOSAL
The Waste of Electrical and Electronic Equipment (WEEE)
Directive (2002/96/EC) has been put in place to recycle
products using best available recovery and recycling
techniques to minimise the impact on the environment, treat
any hazardous substances and avoid the increasing landfill.
The product is classed as Electrical or Electronic equipment so please
ensure that at the end of the life of this product it is disposed of in the
correct manner in accordance with local authority requirements. It must
NOT be disposed of with household waste.
INGREDIENTS
TANNING SOLUTION:
AqUA dIhydrOxyAceTONe eThOxydIGLycOL prOpyLeNe GLycOL, , , ,
GLycerIN dmdm hydANTOIN ALOe bArbAdeNSIS exTrAcT TOcOpheryL, , ,
AceTATe reTINyL pALmITATe pANTheNOL SOdIUm meTAbISULfITe pArfUm, , , , ,
pheNOxyeThANOL AmyL cINNAmAL beNzyL beNzOATe beNzyL SALIcyLATe, , , ,
bUTyLpheNyL meThyLprOpIONAL GerANIOL hexyL cINNAmAL LImONeNe , , ,
LINALOOL cI, +/-
16035
, cI
19140
, cI
42090.
12M
IMPORTANT
Double Insulated. Earthing not required.
Conforms with relevant European Directives.
Only use with the adaptor supplied with this product.
On/Off &
Mode buttons Tanning
Dispenser
ON/OFF
2.
3. 4.
Airbrush
Trigger
1.
a
b
Lid
5.
CELEBRITY
AIRBRUSH TANNING
TM
®
Rio, Dezac and Celebrity Airbrush Tanning
are trademarks of The Dezac Group Ltd
© The Dezac Group Ltd 2011
PO Box 17, Cheltenham Spa, England GL53 7ET
www.riobeauty.com
1-IN-TANM-UK/1.0
USER GUIDE
!
Please read all instructions thoroughly and retain for future
reference.
l For external use only, do NOT ingest.
l Avoid contact with the eyes. If contact occurs, rinse thoroughly
with water.
l Do NOT apply to open cuts or broken skin.
l Always cover your hair when tanning your face, especially if you
have bleached hair which can be stained by the tanning solution.
PATCH TEST
NOTE: Patch test the tanning solution on a small area of your skin
24 hours before spraying a large area. If irritation occurs, discontinue
use.
UV PROTECTION
It is important to understand that tanning solution, along with most
self tanning products, does not offer protection from the sun. Always
apply a sunscreen with an appropriate SPF (sun protection factor)
before exposing your skin to sunlight.
IMPORTANT
Choose an appropriate space; tanning solution can stain some
fabrics. Ideally use the airbrush inside your shower cubicle or protect
your area with an old towel.
PREC AUTIONS


Product specificaties

Merk: Rio
Categorie: Niet gecategoriseerd
Model: TANM

Heb je hulp nodig?

Als je hulp nodig hebt met Rio TANM stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Rio

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd