Ricatech RMC350 Handleiding

Ricatech Platenspeler RMC350

Lees hieronder de 📖 handleiding in het Nederlandse voor Ricatech RMC350 (21 pagina's) in de categorie Platenspeler. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/21

USER MANUAL

GEBRUIKERSHANDLEIDING

MODE D'EMPLOI

BEDIENUNGSANLEITUNG

MANUALE D'USO

RMC350 5 in 1 MUSIC CENTER

910-111041-0030-100

IMPORTANT SAFEGUARDS FOR AUDIO PRODUCTS

PLEASE READ CAREFULLY THE FOLLOWING IMPORTANT SAFEGUARDS THAT

ARE APPLICABLE TO YOUR EQUIPMENT.

1. Read Instructions - All the safety and operating instructions should be read before the

appliance is operated.

2. Retain Instructions - The safety and operating instructions should be retained for future

reference.

3. Heed Warnings - All warnings on the appliance and in the operating instructions should

be adhered to.

4. Follow Instructions - All operating and use instructions should be followed.

5. Water and Moisture - The appliance should not be used near water-for

example, near a bathtub,washbowl,kitchen sink,laundry tub, in a wet

basement, or near a swimming pooland the like.

6. Carts and Stands - The appliance should be used only with a cart

or stan that is recommendedby the manufacturer.

6A.An appliance and cart combination should be moved with care.

Quick stops, excessive force, and uneven surfaces may cause

the appliance and cart combination to overturn.

7. Wall or Ceiling Mounting - The appliance should be mounted to a

wall or ceiling only as recommended by the manufacturer.

8. Ventilation - The appliance should be situated so that its location or position does not interfere

with-its proper ventilation.For example, the appliance should not be situated on a bed, sofa,

rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation,

such as a bookcase or cabinet that may impede the flow of air through the ventilation

openings.

9. Heat - The appliance should be situated away from heat sources such as radiators,heat

registers, stoves,or other appliances (including amplifiers) that produce heat.

10. Power Sources - The appliance should be connected to a power supply only of the

type described in the operating instructions or as marked on the appliance.

11. Grounding or Polarization - Precautions should be taken so that the grounding or polarization

means of an appliance is not impeded.

12. Power - Cord Protection - Power-supply cords should be routed so that they are not likely

to be walked on or pinched by items placed upon or against them, paying particular attention

to cords at plugs, and the point where they exit from the appliance.

13. Cleaning - The appliance should be cleaned only as recommended by the manufacturer.

14. This product is designed for use with the antenna attached and should not be connected

to any other external antennas.

15. Nonuse Periods - The power cord of the appliance should be unplugged from the outlet

when left unused for a long period of time.

16. Object and Liquid Entry - Care should be taken so objects do not fall and liquids are not

spilled into the enclosure through openings

17. Damage Requiring Service - The appliance should be serviced by qualified service personnel

when:

A. The power-supply cord of the plug has been damaged;or

B. Objects have fallen, or liquid has been spilled into the appliance;or

C. The appliance has been exposed to rain;or

D. The appliance does not appear to operate normally or exhibits a marked change

inperformance;or

E. The appliance has been dropped, or the enclosure damaged.

18. Servicing - The user should not attempt to service the appliance beyond that described

in the operating instructions. All other servicing should be referred to qualified service

personnel.

POWER SOURCE

1 Untie the wire on the AC Adaptor

2 Plug the AC Adaptor into appropriate wall outlet.

3 Plug the small end of the adaptor into the ACADAPTOR JACK on the back of the unit.

UNPACKING THE TURNTABLE

1. Remove packing materials from unit.

Note: Save all packing materials.

2. Remove plastic bag covering radio.

3. Remove plastic safety cover from A/C plug.

4. Remove tie from A/C cord and untie antenna wire on back of radio

5. Open lid and remove styrofoam shipping material from turntable.

6. Remove black tie-wrap from under the tone arm.

7. Remove white protective needle cover by gently pulling towards the front of the unit.

8. Untie the FM antenna and allow it to hang down in a straight line for optimum FM reception. If you have

trouble tuning in an FM station, move the external FM antenna for best reception. Do no connect FM

antenna to outside antenna.

TURNTABLE OPERATION

Turn the unit on by rotating the ON/OFF-VOLUME ROTARY KNOB located on the front panel to the ON

position.

1. Rotate the FUNCTION SWITCH to select PHONO mode.

2. Set the SPEED CONTROL SWITCH to desire speed (33 1/3,45 or 78 rpm). Place the record on the

turntable.

3. Use the CUE LEVER to raise the tone arm off its rest. Pull the TONE ARM slightly to the right side until

hear the “click” sound to activate the turntable.

4. Move the TONE ARM by hand over the record and slowly lower it. Adjust the ON/OFF-VOLUME ROTARY

KNOB to the desired listening level.

5. At the end of the record, the TONE ARM will stop automatically. You must return to TONE ARM to arm

rest by hand.

Accessory: ADAPTER FOR 45 RPM

1 Place the 45 RPM adaptor over the spindle.

2 Gently place your 45 RPM record onto the turntable.

3 Follow the steps under turntable operation to play your record.

ANTENNA

For FM reception, the unit is provided with a FM WIRE ANTENNA , move the wire until the reception is

clear and with no interferences. For AM reception, the unit is provided with a directional build-in ferrite

antenna. Rotate the set to find the position in which the best reception is obtained. Do not connect the

EXTERNAL FM ANTENNA to any outside antenna.

RADIO OPERATION

1. Rotate the FUNCTION SWITCH to select RADIO mode.

2. Set the AM/FM BAND SWITCH to the desired radio band (AM or FM).

3. Select the desired radio station by rotating TURNING ROTARY KNOB.

4. Adjust the ON/OFF-VOLUME ROTARY KNOB to the desired sound level.

USB & SD-CARD OPERATION

SD-Card operation:

1. Insert SD-Card into the SD Card slot.

2. Switch on by turning the ON/OFF-VOLUME ROTARY KNOB from the Off position.

3. Adjust the ON/OFF-VOLUME ROTARY KNOB to the desired volume level.

4. Rotate the FUNCTION SWITCH to SD/USB Mode.

5. Press the PLAY/PAUSE BUTTON (USB/SD) to play the music tracks stored on the SD-card.

6. The green ACC LED will flash whilst the music is playing.

7. To pause the music, press the PLAY/PAUSE BUTTON (USB/SD) again.

8. Press the SKIP+ (USB/SD) / SKIP- (USB/SD) BUTTON to go to the next file during Play Mode.

9. To stop playing the music files stored on the SD-Card , press the PLAY/PAUSE BUTTON (USB/SD).

Note: Power the unit off first before disconnecting the SD-Card. Turning the VOLUME CONTROL to

Off position.

GUÍA DE SOLUCIÓN DE PROBLEMAS

PLATO

No hay alimentación

1. El adaptador de CA no está bien conectado.

2. Compruebe que el botón de volumen ENCENDIDO/APAGADO está en la posición ENCENDIDO.

No hay sonido

1. Compruebe el nivel de volumen girando el botón de volumen.

El plato no funciona

1. Asegúrese de que el selector de función está ajustado a “phono”.

2. Pruebe a mover el brazo del tocadiscos hacia la derecha hasta que suene un clic.

3. Asegúrese de haber retirado la cubierta protectora de la aguja.

No se reproduce el CD

1. Asegúrese de haber introducido el CD correctamente (el lado del a etiqueta hacia arriba).

2. Compruebe que la superficie del CD está limpia

3. Asegúrese de que el selector de función está ajustado a CD.

USB - No se reproduce música si se pulsa REPRODUCCIÓN/PAUSA (USB).

1. Asegúrese de que la unidad Flash/dispositivo MP3 ha almacenado archivos de música.

2. La unidad solo reproducirá dispositivos Flash de hasta 4 GB.

3. Reinicie el USB/SD apagando o rotando el SELECTOR DE FUNCIÓN (2) para seleccionar otro modo.

Luego seleccione el modo SD/USB otra vez.

4. Compruebe si el/los archivo/s es/son archivo/s WMA. La unidad no reproduce el formato WMA, sólo

formato MP3.

Especificaciones USB

Interfaz

* USB2.0 Full Speed, host (no compatible con USB HUB)

Memoria Flash correspondiente

* Memoria Flash USB1.1

* Memoria Flash USB2.0 High speed

* Tamaño máximo de la memoria : 4 GByte

* Tamaño mínimo de la memoria : 512MByte (Solo FAT16).

Decodificador MP3

* Compatible con Audio MPEG 1, 2, 2.5

* Compatible con Layer 1, 2, 3

* Compatible con tasa de transferencia de Bit: 8 k ~ 320 kbps

* Subcarpetas anidadas: 8

* Compatible con tasa de muestreo: 8 k, 16 k, 32 k, 11,025 k, 22,05 k, 44,1 k, 12 k, 24 k, 48 kHz

* Número máximo de archivos para la reproducción: 999

* Formato de archivo para la reproducción: *.mp3. *.mp2, *.mp1; no es posible seleccionar el formato

Product specificaties

Merk:	Ricatech
Categorie:	Platenspeler
Model:	RMC350
Kleur van het product:	Hout
Gewicht:	6200 g
Breedte:	433 mm
Diepte:	376 mm
Hoogte:	457 mm
Compatibele geheugenkaarten:	SD
Peak Music Power Output (PMPO):	4 W
MP3 afspelen:	Ja
Ondersteunde frequentiebanden:	AM, FM
Cd-speler:	Ja