Naim StageLine Handleiding

Naim Receiver StageLine

Lees hieronder de 📖 handleiding in het Nederlandse voor Naim StageLine (12 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 99 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/12

NAPSC, i-SUPPLY, STAGELINE, HEADLINE

owNErS mANUAL

ENGLISH

SAFETY INSTRUCTIONS

In order to comply with current European

safety regulations it is essential that the

Naim loudspeaker connectors supplied

with amplifiers and loudspeakers are

used.

Do not under any circumstances

allow anyone to modify your Naim

equipment without first checking with the

factory, your retailer, or your distributor.

Unauthorised modifications will invalidate

your guarantee.

Equipment must not be exposed to

dripping or splashing and no objects

filled with liquid, such as vases, should be

placed on the equipment.

For your own safety do not under any

circumstances open Naim equipment

without first disconnecting it from the

mains.

Warning: an apparatus with CLASS I

construction shall be connected to a

mains socket outlet with a protective

earthing connection.

Where the mains plug or an appliance

coupler is used as the disconnect device,

the disconnect device shall remain

readily operable. To disconnect the

equipment from the mains remove the

mains plug from the mains outlet.

The following label is attached to the

NAPSC:

This equipment has been tested and

found to comply with the relevant EMC

and Safety Standards, and, where

applicable, also complies with the limits

for a class B digital device, pursuant to

Part 15 of the FCC Rules.

These limits are designed to provide

reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and

wa r n i n g

This apparaTus

musT be earThed

Page Section

1 1 Connections

2 Mains Power

2 3 General Installation

4 4 Product Introduction

5 NAPSC

5 6 i-Supply

7 Headline

6 8 Stageline

8 9 Declaration of Conformity

can radiate radio frequency and, if not

installed and used in accordance with

the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause

harmful interference to radio or television

reception, which can be determined by

turning off and on, the user is encouraged

to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving

antenna.

• Increase the separation between the

equipment and the receiver.

• Connect the equipment into an outlet

on a circuit different from that to which

the receiver is connected.

• Consult your Naim retailer or an

experienced radio/TV technician for

help.

Contents

Naim Audio products are conceived with

performance as the top priority. Careful

installation will help ensure that their full

potential is achieved. This manual covers

the NAPSC and i-Supply power supplies,

Headline headphone amplifier and Stageline

phono amplifier. It begins with general

installation notes and statutory safety

warnings. Product specific information

begins in Section 5.

1 Connections

It is important for both safety and

performance that any standard cables

supplied are not modified.

1.1 Analogue Audio

Interconnect Cables

If options are available with your equipment

and installation, DIN interconnect sockets

should be used in preference to Phono

sockets. One end of each Naim audio

interconnect cable is marked with a band

to establish its correct orientation. The band

denotes the end that connects to the signal

source. Naim Hi-Line interconnect cables will

provide the best results.

Audio interconnect plugs and sockets should

be kept clean and free from corrosion. The

easiest way to clean them is to switch off

the equipment, pull the plugs out of their

sockets, and push them back in again.

Contact cleaners and “enhancers” should

not be used as the film they deposit may

degrade the sound.

2 Mains Power

Where fused plugs are used 13 amp fuses

should be fitted (i-Supply 3 amp). Fuses of

a lower rating will fail after a period of use.

Do not wire voltage dependent resistors or

noise suppressors into mains plugs. They

degrade the mains supply and the sound.

2.1 M a ins Plug W iring

In some territories a mains plug may need to

be fitted to the supplied mains lead. As the

colours of the wires in the mains lead may

not correspond with the coloured markings

identifying the terminals in the plug proceed

as follows:

The wire coloured GREEN and YELLOW must

be connected to the terminal in the plug

marked by the letter or by the safety earth E

symbol or coloured or GREEN GREEN and

YELLOW.

The wire coloured BLUE must be connected

to the terminal in the plug marked with the

letter or coloured N BLACK.

The wire coloured must be BROWN

connected to the terminal in the plug

marked with the letter or coloured L RED.

2.2 Equip m ent Fuses

Mains powered Naim Audio equipment is

fitted with a mains fuse on the rear panel

adjacent to the mains input socket (not

i-Supply). Replace it if necessary only with

the spare fuse supplied or with an identical

fuse. Repeated failure of the fuse points to

a fault that should be investigated by your

retailer or Naim Audio.

2.3 Non-rewirable Mains

Plugs

If a non-rewirable plug is cut from a mains

lead (for whatever purpose) the plug MUST

be disposed of in a way to render it totally

useless. Considerable shock hazard exists

if the cut-off plug is inserted into a mains

outlet.

2.4 Mains Circuits a nd

Cab les

A hi-fi system usually shares a mains circuit

with other household equipment, some of

which can cause distortion of the mains

Accessories

Product specificaties

Merk:	Naim
Categorie:	Receiver
Model:	StageLine
Kleur van het product:	Zwart
Breedte:	121 mm
Diepte:	187 mm
Hoogte:	57 mm
Connectiviteitstechnologie:	Bedraad
DC voltage input:	24 V
Audio-uitgangskanalen:	- kanalen
Signaal/ruis-verhouding:	- dB
Totale harmonische vervorming (THD):	- procent
Input sensitiviteit:	2 mV
Piekvermogen per kanaal:	- W
Speakers connectiviteit type:	RCA