JL Audio Stealthbox SB-GM-CTRIP/10TW3/DG Handleiding

JL Audio Niet gecategoriseerd Stealthbox SB-GM-CTRIP/10TW3/DG

Lees hieronder de 📖 handleiding in het Nederlandse voor JL Audio Stealthbox SB-GM-CTRIP/10TW3/DG (3 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
I N S T A L L A T I O N G U I D E
for the
SB-GM-CTRIP/10TW3
SKU# 94602 - 94603
2010 & Up Chevrolet Camaro Coupe
Thank you for choosing a JL Audio Stealthbox ® for your automotive sound system. With proper installation, your new
vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio dealer. The
installation professionals employed by your dealer have the necessary tools and experience to disassemble and
reassemble your vehicle properly. Also, keep in mind that your warranty coverage extends to 2 years if your system is
installed or approved by your authorized JL Audio dealer. If you prefer to perform your own installation, please read
this installation guide completely before beginning the process.
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox ® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
S T E P 1
Empty the trunk of the vehicle.
Continued on Next Page
S T E P 2
Empty the rear seat area, and fold down the rear seat back.
S T E P 3
Connect speaker cable to the terminal cup on the
Stealthbo, and carefully place the enclosure face down in
the trunk as shown.
SB-GM-CTRIP/10TW3 INSTR_SKU# 011381
INSTALLATION
D I F F I C U L T Y :
15
OUT
OF
ESTIMATED TIME:
1/2 HOUR
Continued on Next Page
SB-GM-CTRIP/10TW3 INSTR_SKU# 011381
S T E P 7
Be sure the two L-Brackets grab the bottom lip of the trunk
as shown.
S T E P 6
Route the speaker cable as necessary, and tilt the Stealthbox®
up into position so the woofers face the rear of the vehicle.
S T E P 5
From the back seat area, secure each of the L-Brackets to the
threaded inserts on the bottom of the enclosure using a pair
of 1/4 - 20 x 1” Hex Head Bolts, 1/4” Lock Washers, and 1/4”
Flat Washers.
S T E P 4
Pictured is the Stealthbox® mounting hardware. The two
L-Brackets are used for bottom of the enclosure, and the
Center Bracket is used for the top of the enclosure.
Page 2 • JL Audio, Inc 2016
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
S T E P 8
Secure the Center Bracket to the threaded insert on the top
of the enclosure using a 1/4 - 20 x 1” Hex Head Bolt, 1/4” Lock
Washer, and 1/4” Flat Washer, and position it below the seat
latch hook as shown.
SB-GM-CTRIP/10TW3 INSTR_SKU# 011381
Page 3• JL Audio, Inc 2016
All specifications are subject to change without notice. JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011381 09.20.2016 • Printed in USA • ©2016 JL Audio, Inc.
For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
w w w . j l a u d i o . c o m
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y M I R A M A R , F L O R I D A 3 3 0 2 5 U S A
I N C L U D E D H A R D W A R E
(1) Center Bracket (1) Rectangular Cap
(2) L-Bracket (3) 1/4” Flat Washer
(3) 1/4 -20 x 1” Hex Head Bolt (3) 1/4” Lock Washer
S P E C I F I C A T I O N S
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 10TW3-D4
Nominal Impedance: 2.67 Ohms (woofers are wired in parallel)
Continuous Power Handling: 1200 watts
P O W E R R E C O M M E N D A T I O N
JL Audio recommends high quality amplifiers such as the JL Audio HD1200/1, HD750/1, 1200/1v3, XD1000/1v2, or the
JX1000/1D. The diagram below shows the recommended crossover settings for the HD750/1. If another amplifier is
being used, reference this illustration and use similar settings on that amplifier.
All JL Audio amplifiers are very versatile audio components. Please consult the owners manual for even more
detailed information about installing and tuning your amplifier.
C O N N E C T I O N S
Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbo.
JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your Stealthbox® amplifier. Other
kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium Audio
Interconnect Cables should be used to provide signal for both channels of the amplifier. JL Audio recommends
using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 6-1/2”- Front Doors
Fits JL Audio Models: TR650-CXi, TR650-CSi, C2-650x, C2-650,
C3-650, C5-650x, C5-650, & ZR650-CSi
Rear Speaker Size / Location: 6”x 9”- Rear Deck
Fits JL Audio Models: TR690-TXi, C2-690tx


Product specificaties

Merk: JL Audio
Categorie: Niet gecategoriseerd
Model: Stealthbox SB-GM-CTRIP/10TW3/DG

Heb je hulp nodig?

Als je hulp nodig hebt met JL Audio Stealthbox SB-GM-CTRIP/10TW3/DG stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd JL Audio

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd