JL Audio MediaMaster 55-HR Handleiding

JL Audio Niet gecategoriseerd MediaMaster 55-HR

Lees hieronder de 📖 handleiding in het Nederlandse voor JL Audio MediaMaster 55-HR (37 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 20 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/37
HIDDEN MARINE SOURCE UN IT
OWNER ’S MANUAL
2
FCC COMPLIANCE STATEMENT
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must not accept any interference
received, including interference that may cause
undesired operation.These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, the user is encouraged to
try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase separation between the equipment and
the receiver.
- Connect the equipment to an outlet on a circuit
different
from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Any changes or modifications not expressly
approved by the party responsible
for compliance could void the user’s
authority to operate this equipment.
FCC RADIATION EXPOSURE STATEMENT
This device complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
a minimum distance of 20 cm between the radiator
and any part of your body.
CANADA STATEMENT
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
The device meets the exemption from the routine
evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure, users can
obtain Canadian information on RF exposure
and compliance. This equipment meets the
exemption from the routine evaluation limits
in section 2.5 of RSS-102. It should be installed
and operated with a minimum distance of 20cm
between the radiator and any part of your body.
SAFETY CONSIDERATIONS
• Only use this product in vehicles with 12 volt,
negative-ground electrical systems. This product is
not certified or approved for use in aircraft.
• Mount this product securely to prevent damage or
injury in severe conditions.
• Do not replace the power wire fuse with one of a
different value. Never bypass the fuse.
• Listen to your audio system at levels appropriate
for operating conditions and hearing safety.
INSTALLATION CONSIDERATIONS
• Installation requires appropriate tools and
safety equipment. Professional installation
is recommended.
• This product is water-resistant. Do not submerge
or subject to high-pressure water spray.
• Before installation, turn off the audio system
and disconnect the battery system from the
audio system.
• Install in a dry, well-ventilated location that does
not interfere with your factory-installed systems. If
a dry environment is not available, a location that
is not exposed to heavy splashing may be used.
• Before cutting or drilling, check for potential
obstacles behind mounting surfaces.
• Carefully route all system wiring away moving
parts and sharp edges; secure with cable ties or
wire clamps and use grommets and loom where
appropriate to protect from sharp edges.
4
GENERAL MOUNTING
7/64"
(2.78 mm)
NOTE: When connected to +12V DC, the source unit will automatically connect to any
previously paired device. If a paired device is out of range, or if there are no previously
paired devices, the source unit will enter pairing mode for sixty seconds.
BASIC CONTROLS
Control Function
Bluetooth®
Pairing -
Classic
Use to connect streaming audio devices
• Short press to enter pairing mode
• Fast blinking Blue LED until connection
• Blue LED for 10
seconds after
connection, then
returns to Green
• Times out after
60 seconds
Bluetooth®
Pairing -
Mobile App
Use to connect mobile application controllers
• Long press to enter pairing mode
• Fast blinking Red/Blue LED until connection
Reset • Short press to reboot the source unit
• LED blinks Green,
then returns to
Green
= Bootup
= Bluetooth® Pairing Mode - Classic
= Firmware Update in Progress
= ON
= Bluetooth® Pairing Mode - Mobile App
= Error Fault


Product specificaties

Merk: JL Audio
Categorie: Niet gecategoriseerd
Model: MediaMaster 55-HR

Heb je hulp nodig?

Als je hulp nodig hebt met JL Audio MediaMaster 55-HR stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd JL Audio

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd