I-PRO WV-QDC509CN Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor I-PRO WV-QDC509CN (6 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/6
1
Before attempting to connect or install this product, please read these instructions carefully
and save this manual for future use.
• The external appearance and other parts shown in this manual may differ from the actual
product within the scope that will not interfere with normal use due to improvement of the
product.
• Read also the installation guide of the camera to be used.
i-PRO Co., Ltd. assumes no responsibility for injuries or property damage resulting
from failures arising out of improper installation or operation inconsistent with this
documentation.
“<Control No.: C****>” used in these documents should be used to search for
information on our technical information website (https://i-pro.com/products_
and_solutions/en/surveillance/learning-and-support/knowledge-base/
technical-information) and will guide you to the right information.
https://www.i-pro.com/
© i-PRO Co., Ltd. 2024
av0824-0
PGQP3730ZA
Installation Guide
Included Installation Instructions
Dome Cover
Model No. WV-QDC509CN
2
Caution:
Before attempting to connect or operate this product, please read these instructions carefully.
Precaution
Do not use this product except with suitable cameras.
Failure to observe this may cause a drop resulting in injury or accidents.
Refer installation work or dome cover replacement to the dealer.
Installation work requires technique and experiences.
Failure to observe this may cause fire, electric shock, injury, or damage to the product.
Be sure to consult the dealer.
The screws and bolts must be tightened to the specified torque.
Failure to observe this may cause a drop resulting in injury or accidents.
When using this product, also read the “Precautions” described in the operating
instructions for the camera to be attached.
3
Preface
This product is the clear type dome cover.
The latest information about the supported cameras
<Control No.: C0501>
Specifications
Ambient operating
temperature:
–50 °C to +60 °C {–58 °F to 140 °F}
Dimensions: ø111 mm × 38.5 mm (H)
{ø4-3/8 inches × 1-17/32 inches (H)}
Diameter of the dome: 48.5 mm {1-29/32 inches}
Mass: Approx.60 {0.13 lbs}g
Finish: PC resin Clear (with ClearSight coating),
Precaution for installation
Screw tightening
Do not use an impact driver. Use of an impact driver may damage the screws or cause
tightening excessively.
Cleaning of Dome cover
To clean the Dome cover, wash out hard sand grains and other adhered materials by
pouring fresh water containing no lubricant or silicone substance using a hose or spray. If
the stain is not removed, wipe with a soft sponge soaked with the above fresh water.
Do not wipe dry (e.g., spread oil on surfaces or damage the ClearSight coating).
Use neutral detergent for dishware and rinse thoroughly after use if dirt does not come off
after wiping. If detergents other than neutral (weakly alkaline or slightly acidic) are used, the
performance of the surface coating may deteriorate or the surface coating may peel off.
Do not use organic solvents such as benzene and thinner.
If spraying is used, use it after emptying to remove the initial impurities.


Product specificaties

Merk: I-PRO
Categorie: Niet gecategoriseerd
Model: WV-QDC509CN

Heb je hulp nodig?

Als je hulp nodig hebt met I-PRO WV-QDC509CN stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd I-PRO

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd