Heatit Z-RELAY Handleiding

Heatit Niet gecategoriseerd Z-RELAY

Lees hieronder de 📖 handleiding in het Nederlandse voor Heatit Z-RELAY (10 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/10

Ver 2018-C

2 yr

Heatit Controls AB, SE-Läkarvägen 4

454 31 BRASTAD, SWEDEN, Phone: +47 61 18 77 77

post@heatit.com – www.heatit.com

HEATIT

Z-RELAY Manual

01.01.2018

Multipurpose Relay Firmware version: 0.12

1. PRODUCT DESCRIPTION

2. INSTALLATION GUIDELINES

2.1 Inputs

2.1.1 Temperature inputs

2.1.2 Flood sensor input

2.2 Relay output

3. BEHAVIOR WITHIN THE Z-WAVE NETWORK

4. FACTORY RESET

5. ASSOCIATION GROUPS

6. SECURITY (S2)

7. CONFIGURATION PARAMETERS

8. COMMAND CLASSES

9. TECHNICAL SPECIFICATION

6-8

CONTENTS

1. PRODUCT DESCRIPTION

The Heatit Z-Relay is a Z-Wave module in a water-resistant housing equipped with 10 x membrane cable entries.

The Heatit Z-Relay is equipped with 1 relay output and 3 multi-purpose inputs, and a Z-Wave radio for interfacing to the

wireless Z-Wave network. The module must be power supplied from a 230V AC mains connection.

The Heatit Z-Realy high-duty relay output are able to be freely controlled from the Z-Wave network, and can be used for

several purposes, e.g. control of valve actuators, stoves etc.

Two of the Heatit Z-Relay inputs can be conﬁgured to function as either digital inputs or as analogue inputs for interfacing

simple NTC temperature sensors. When the inputs are used as digital inputs, they can be connected to potential free

contacts, open-collector outputs, and will be able to control other Z-Wave devices when the status of the inputs sent

to other Z-Wave devices on the Z-Wave network. The last input can be used as either digital input or be used to be

connected to a ﬂood detector.

It is possible to conﬁgure the level- and the indication of the status indicator LED on the modules circuit board.

2. INSTALLATION GUIDELINES

ATTENTION: Only authorized technicians under consideration of the country-speciﬁc installation guidelines/norms may

do works with 230 Volt mains power. Prior to the assembly of the product, the voltage network has to be switched oﬀ and

ensured against re-switching.

NTC 1 NTC 2

Water Leak Sensor

LOAD

Inclusion button

Product specificaties

Merk:	Heatit
Categorie:	Niet gecategoriseerd
Model:	Z-RELAY
Kleur van het product:	Wit
Stroom:	25 A
Afmetingen (B x D x H):	104 x 46 x 104 mm
Maximum indoorbereik:	40 m
AC-ingangsspanning:	230 V
AC-ingangsfrequentie:	50 - 60 Hz
Bedrijfstemperatuur (T-T):	5 - 40 °C