Hatco MC-15 Handleiding

Hatco Heater MC-15

Lees hieronder de 📖 handleiding in het Nederlandse voor Hatco MC-15 (60 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 20 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/60

Electric Booster Water Heaters

Réchauffeurs d'eau électriques

Imperial, Compact, Mini-Compact Series

Série Imperial, Compact, Mini-Compact

Installation and Operating Manual

Manuel d'installation et d'utilisation

P/N 07.04.111.00

(see page 2)

S'inscrire en ligne!

(voir page 31)

www.hatcocorp.com

Do not operate this equipment unless you

have read and understood the contents of

this manual! Failure to follow the

instructions contained in this manual may

result in serious injury or death. This

manual contains important safety

information concerning the maintenance,

use, and operation of this product. If

you’re unable to understand the contents

of this manual, please bring it to the

attention of your supervisor. Keep this

manual in a safe location for future

reference.

English = p 2

No opere este equipo al menos que haya

leído y comprendido el contenido de este

manual! Cualquier falla en el seguimiento

de las instrucciones contenidas en este

manual puede resultar en un serio lesión

o muerte. Este manual contiene

importante información sobre seguridad

concerniente al mantenimiento, uso y

operación de este producto. Si usted no

puede entender el contenido de este

manual por favor pregunte a su

supervisor. Almacenar este manual en

una localización segura para la referencia

futura.

Ne pas utiliser cet équipement sans avoir

lu et compris le contenu de ce manuel !

Le non-respect des instructions

contenues dans ce manuel peut entraîner

de graves blessures ou la mort. Ce

manuel contient des informations

importantes concernant l'entretien,

l'utilisation et le fonctionnement de ce

produit. Si vous ne comprenez pas le

contenu de ce manuel, veuillez le signaler

à votre supérieur. Conservez ce manuel

dans un endroit sûr pour pouvoir vous y

référer plus tard.

Français = p 31

WARNING

ADVERTENCIA

AVERTISSEMENT

2Form No. EBOOSTERM-0613

CONTENTS

English

INTRODUCTION

Hatco Electric Booster Water Heaters are designed

for use with commercial dish machines to boost the temperature

of the regularly available hot water, usually 110° 150°F –

(43° 66°C) up to 180°F (82°C). Water at 180°F (82°C) can be–

used as sanitizing rinse water in commercial dish machines in

accordance with Health Codes, NSF Standard #5 and plumbing

codes.

All Hatco Booster Heaters are ready for electrical and plumbing

service connections, with an adjustable ambient compensated

immersion thermostat(s) and a high temperature limit switch.

The service area is accessible from the front of the unit,

permitting easy access.

Hatco Electric Booster Water Heaters are products of extensive

research and field testing. The materials used were selected for

maximum durability, attractive appearance, and optimum

performance. Every unit is inspected and tested thoroughly prior

to shipment.

This manual provides the installation, safety, and operating

instructions for the Hatco Electric Booster Water Heaters. Hatco

recommends all installation, operating, and safety instructions

appearing in this manual be read prior to installation or

operation of the unit.

Safety information that appears in this manual is identified by

the following signal word panels:

WARNING indicates a hazardous situation which, if not

avoided, could result in death or serious injury.

CAUTION indicates a hazardous situation which, if not

avoided, could result in minor or moderate injury.

NOTICE is used to address practices not related to

personal injury.

NOTICE

CAUTION

WARNING

Important Owner Information ..............................................2

Introduction...........................................................................2

Important Safety Information...............................................3

Model Description.................................................................5

All Models...........................................................................5

Imperial Models “S” Series.................................................5

Compact Models “C” Series ...............................................5

Mini-Compact Models “MC” Series ....................................5

Specifications........................................................................6

Circuit Breaker and Fused Disconnect Switch Sizes .........6

Sizing Chart for Low-Temp Dish Machines ........................9

Booster Heater Sizing Chart ............................................10

Capacity Charts ................................................................14

Dimensions.......................................................................15

Installation ...........................................................................17

General.............................................................................17

Plumbing Installation ........................................................18

Electrical-All Sizes and Voltages......................................23

Operation.............................................................................24

General.............................................................................24

Maintenance ........................................................................25

General.............................................................................25

Thermostat Adjustment.....................................................25

High Temperature Limit Safety Switch .............................25

Options and Accessories...................................................26

Troubleshooting Guide ......................................................27

Limited Warranty.................................................................30

Authorized Parts Distributors............................Back Cover

IMPORTANT OWNER INFORMATION

Record the model number, serial number, voltage, and

purchase date of the unit in the spaces below (specification

label located on the unit). Please have this information available

when calling Hatco for service assistance.

Model No. __________________________________

Serial No. __________________________________

Voltage ____________________________________

Date of Purchase ____________________________

Completing online warranty registration will prevent delay in

obtaining warranty coverage. Access the Hatco website at

www.hatcocorp.com, select the Parts & Service pull-down

menu, and click on “Warranty Registration”.

Business

Hours: 8:00 to 5:00 Central Standard Time (CST)AM PM

(Summer Hours: June to September—

8:00 AM PMto 5:00 CST Monday Thursday–

8:00 AM PMto 2:30 CST Friday)

Telephone: 800-558-0607; 414-671-6350

e-mail: partsandservice@hatcocorp.com

Fax: 800-690-2966 (Parts and Service)

414-671-3976 (International)

Additional information can be found by visiting our web site at

www.hatcocorp.com.

24 Hour 7 Day Parts and Service

Assistance available in the United States

and Canada by calling 800-558-0607.

Form No. EBOOSTERM-0613 3

IMPORTANT SAFETY INFORMATION

English

ELECTRIC SHOCK HAZARD:

• Unit must be installed by qualified, trained installers.

Installation must conform to all local electrical and

plumbing codes. Installation by unqualified personnel

will void the unit warranty and may lead to electric

shock or burn, as well as damage to unit and/or its

surroundings. Check with local plumbing and electrical

inspectors for proper procedures and codes.

• Turn OFF power at fused disconnect switch/circuit

breaker and allow unit to cool before performing any

cleaning, adjustments, or maintenance.

• Consult a licensed electrical contractor for proper

electrical installation conforming to local electrical

codes and the National Electrical Code (N.E.C.).

• Unit is not weatherproof. Locate unit indoors where

ambient air temperature is a minimum of 70°F (21°C).

• Do not place aftermarket covers on or over booster

heater. Doing so can cause temperature and moisture

build-up resulting in premature failure and electrical

shock.

• This unit must be serviced by qualified personnel only.

Service by unqualified personnel may lead to electric

shock or burn.

• Use only Genuine Hatco Replacement Parts when

service is required. Failure to use Genuine Hatco

Replacement Parts will void all warranties and may

subject operators of the equipment to hazardous

electrical voltage, resulting in electrical shock or burn.

Genuine Hatco Replacement Parts are specified to

operate safely in the environments in which they are

used. Some aftermarket or generic replacement parts

do not have the characteristics that will allow them to

operate safely in Hatco equipment.

Valves supplied by Hatco are designed for high-

temperature commercial operation. Do not substitute Hatco

valves with valves designed for domestic water heaters.

Temperature/pressure protective equipment should not be

less than a combination temperature/pressure relief valve

certified by a nationally recognized testing laboratory that

maintains periodic inspection of the production of this

equipment and meets the requirements for Relief Valves

and Automatic Shutoff Devices for Hot Water Supply

Systems, ANSI Z21.22-1979. The temperature/pressure

relief valve must be marked with a minimum set pressure

not to exceed the marked hydrostatic test pressure of the

booster heater as noted on the unit specifications.

EXPLOSION HAZARD: Do not store or use gasoline or

other flammable vapors or liquids in the vicinity of this or

any other appliance.

WARNING

FOR INSTALLING PRESSURE AND TEMPERATURE

RELIEF VALVES IN ACCORDANCE WITH AMERICAN

NATIONAL STD. Z21.22-1979. Combination pressure and

temperature relief valves with extension thermostats must

be installed so that the temperature-sensing element is

immersed in the water within the top 6" (152 mm) of the

tank. They must be installed directly in a tank tapping.

Combination pressure and temperature relief valves that

do not have extension elements must be mounted directly

in a tank tapping located within the top 6" (152 mm) of the

tank, and shall be adequately insulated and located so as

to assure isolation from ambient conditions that are not

indicative of stored water temperature. TO AVOID WATER

DAMAGE OR SCALDING DUE TO VALVE OPERATION,

DRAIN PIPE MUST BE CONNECTED TO VALVE OUTLET

AND RUN TO A SAFE PLACE OF DISPOSAL. Discharge line

must be as short as possible and be the same size as the

valve discharge connection throughout its entire length.

Drain line must pitch downward from the valve and must

terminate between 1-1/2" (38 mm) and 6" (152 mm) above

the floor drain where any discharge will be clearly visible.

The drain line shall terminate plain, not threaded, with

material serviceable for temperatures up to 250°F (121°C)

or greater. Excessive length, over 30' (9.1 m), or use of

more than four elbows can cause a restriction and reduce

the discharge capacity of the valve. No shut-off valve shall

be installed between the relief valve and tank, or in the

drain line. Valve lever must be tripped periodically to

assure that waterways are clear. This device is designated

for emergency safety relief and shall not be used as an

operating control. The valves are set to relieve at 150 psi

(1034 kPa) or when water temperature reaches 210°F

(99°C). Read tag on valve for additional information.

Use only plumbing material suitable for a minimum water

temperature of 200°F (93°C). Materials used must meet

National Sanitation Foundation (NSF) specifications and all

local plumbing codes and regulations.

Units are equipped with a high temperature limit safety

switch that will shut off the power if the unit overheats.

Contact an Authorized Hatco Service Agent if the high

temperature limit safety switch cannot be reset or

continues to trip.

Install booster water heater in a horizontal position with the

base parallel to the floor and the inlet connection at the

lowest point. Improper installation could create an unsafe

condition.

Do not connect booster water heaters to domestic

(consumer) dish machines or other domestic utilized

equipment. This booster may damage domestic equipment.

WARNING

Read the following important safety information before using this equipment to avoid

serious injury or death and to avoid damage to equipment or property

Product specificaties

Merk:	Hatco
Categorie:	Heater
Model:	MC-15

Heb je hulp nodig?

Als je hulp nodig hebt met Hatco MC-15 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Heater Hatco

Hatco FR-4B Handleiding

18 November 2024

Hatco FR2-9B Handleiding

18 November 2024

Hatco S-40 Handleiding

9 Juli 2023

Hatco 3CS2-3 Handleiding

7 Juli 2023

Hatco 3CS-6B Handleiding

5 Juli 2023

Hatco FR-9B Handleiding

5 Juli 2023

Hatco 3CS-3B Handleiding

5 Juli 2023

Hatco 3CS2-4 Handleiding

4 Juli 2023

Hatco 3CS2-3B Handleiding

4 Juli 2023

Hatco FR2-4B Handleiding

3 Juli 2023

Handleiding Heater

Nieuwste handleidingen voor Heater

Trisa 9330.44 Handleiding

18 December 2024

Hortus 211-413 Handleiding

18 December 2024

Yamazen HF-L122 Handleiding

18 December 2024

Yamazen HF-D121 Handleiding

18 December 2024

Yamazen HF-L121 Handleiding

18 December 2024

Universal Blue UCRA9104-24 Handleiding

18 December 2024

Orava VL-203 Handleiding

18 December 2024

SHX HL20OSZ Handleiding

16 December 2024

Stanley ST-125T-KFA-ES Handleiding

16 December 2024

Perel PHS2000 Handleiding

14 December 2024