Hamilton Beach Rio HBB250 Handleiding

Hamilton Beach Blender Rio HBB250

Lees hieronder de 📖 handleiding in het Nederlandse voor Hamilton Beach Rio HBB250 (32 pagina's) in de categorie Blender. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/32
www.commercial.hamiltonbeach.com
840142401
8/07
Modèles HBB250 et
HBB250S
Mélangeur de bar
Manuel d’utilisation
Page 12
Models HBB250 and
HBB250S
Bar blenders
Operation Manual
Page 2
Modelos HBB250 y
HBB250S
Licuadora para bar
Manual de uso
Página 22
READ BEFORE USE.
LIRE AVANT D’UTILISER.
LEA ANTES DE USAR.
2
Blender Safety
IMPORTANT: This operation manual should be reviewed with all equipment operators as part of your
operator training program.
1. Read the Operation Manual before using blender.
Keep Operation Manual handy.
2. Plug into a grounded 3-prong outlet.
3. Do not remove ground prong.
4. Do not use an adapter.
5. Do not use an extension cord.
6. Disconnect power before cleaning or servicing.
7. To reduce risk of personal injury, unplug cord from
outlet when not in use, and before putting on or
taking off parts.
8. To protect against electrical shock, do not immerse
cord, plug, or blender base in water or any other liquid.
9. Do not spray the base with a high-pressure spray gun.
10. Extreme caution must be used when moving an
appliance containing hot oil or other hot liquids.
11. Do not use appliance for other than intended use.
12. Not intended for use by or near children.
13. The use of accessory attachments not recommended
by the appliance manufacturer may cause injuries.
14. To reduce risk of personal injury and to prevent
damage to blender or container and cutter assembly,
DO NOT insert utensils into blender container while
operating blender.
15. Do not store any kitchen utensils in the container
because the blender would be damaged if
inadvertently turned on.
16. To prevent possibility of serious personal injury, keep
hands out of blender container while operating blender.
Always operate blender with container lid in place.
17. Avoid contacting moving parts.
18. Blades are sharp. Handle carefully.
SAVE THESE INSTRUCTIONS
19. If cutter assembly blades are loose, discontinue use
immediately and replace cutter assembly. Do not
attempt to repair or tighten cutter assembly.
20. Inspect container and cutter assembly daily. Do not use
broken, chipped or cracked container. Check cutter for
wear, nicks, or broken blades. Do not use broken or
cracked cutting blades.
21. Do not use outdoors.
22. This appliance is intended for short periods of
operation, with a rated operating time of 3 minutes.
23. Do not leave blender unattended while it is operating.
25. To prevent damage to blender, container, or cutter
assembly, DO NOT move or shake blender while in
operation. If blending action stops during operation,
turn blender OFF, remove jar from base, remove jar
cover, and use a thin rubber spatula to push mixture
toward cutters.
25. When blending hot liquids, remove center-piece of
two-piece lid. Hot liquids may push lid off jar during
blending. To prevent possible burns: Do not fill blender
jar beyond the 1 quart (1 liter) level. With the protection
of an oven mitt or thick towel, place one hand on top of
lid. Keep exposed skin away from lid. Start blending at
lowest speed.
26. Do not operate any appliance with a damaged cord
or plug or after the appliance malfunctions, or is
dropped or damaged in any manner. Call the Technical
Service number, 866-285-1087 910-693-4277or , for
instructions on examination, repair, or electrical
or mechanical adjustment.
IMPORTANT SAFETY INSTRUCTIONS
WARNING When using electrical appliances, basic safety precautions should be followed, including
the following:
3
For assistance or replacement parts, call our Technical Service number:
866-285-1087 910-693-4277or
8 a.m. 5:00 p.m. EST Monday Friday
www.commercial.hamiltonbeach.com
Technical Service
Cut Hazard
Always place lid on container when
blending.
Do not put hands, spoons, or other
utensils in container when blending.
Failure to follow these instructions can
result in broken bones, cuts, or other
injuries.
Burn Hazard
Always use caution when blending
hot contents.
Failure to follow these instructions can
result in burns.
Sanitize using 1 tablespoon (15 ml) of household
bleach per 1 gallon (3.8 liter) of clean, cool water
(60°F/16°C), mixed according to the instructions
on the bleach.
1. Fill container with sanitizing solution, replace lid
and filler cap and run on LOW speed for 2 min-
utes. Empty container.
2. Wipe exterior with soft cloth dampened with sani-
tizing solution.
3. Immerse lid and filler cap in sanitizing solution for
2 minutes.
4. Place empty container on base and run on HIGH
speed for 2 seconds to remove any moisture from
the cutter assembly.
5. When ready to use, rinse with clean water.
Sanitizing
Electrical Shock Hazard
Disconnect power before
cleaning blender base.
Failure to follow these
instructions can result in
death or electrical shock.
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Replacement Parts
44 oz. polycarbonate container 6126-250
32 oz. Stainless Steel container 6126-250S
Cutter assembly (Rubber Clutch) 98250
Part Description Part Number
The following components are subject to wear and should be replaced at least
yearly. We recommend keeping a replacement container and cutter on hand.
Safety Alert Symbols
The following safety alert symbols are used throughout
this manual to alert you to the safety hazards described
below.


Product specificaties

Merk: Hamilton Beach
Categorie: Blender
Model: Rio HBB250

Heb je hulp nodig?

Als je hulp nodig hebt met Hamilton Beach Rio HBB250 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Blender Hamilton Beach

Handleiding Blender

Nieuwste handleidingen voor Blender