GBC SureBind System 2 Handleiding

GBC Inbindmachine SureBind System 2

Lees hieronder de 📖 handleiding in het Nederlandse voor GBC SureBind System 2 (3 pagina's) in de categorie Inbindmachine. Deze handleiding was nuttig voor 56 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/3

SYSTEM TWO

OPERATING INSTRUCTIONS

Punching

1. Adjust the punch edge guide to the correct paper length. Check the punch

alignment by punching a sheet of paper and folding it in half along the

punched edge (See Figure 4-1). Match the holes up; if the corners of the

paper match with no overlap, the alignment is correct. If not, readjust the

guide and repeat the process until the edges are square.

2. Place the paper fully in the punch throat, slide the paper to the left against

the punch edge guide, and press the punch button.

3. To prevent jamming, only 22 sheets of 20 pound bond paper should be

punched at one time (fewer sheets if the paper is heavier). Punch one 22

sheet segment of your document at a time, and stack the punched sections

on the binding surface. Do not punch more than 4 composition covers or 3

plastic covers at one time.

4. If you try to punch too much paper the Jam-Stopper feature will sense the

high paper load, retract the punch pins, and you will hear a beeping sound.

Simply separate the paper stack, and punch fewer pages at a time.

Figure 4-1

SYSTEM TWO

OPERATING INSTRUCTIONS

Document Assembly

1. Check the bind edge guide alignment by inserting a receiving strip in the

strip recess area. Lay a sheet of correctly aligned punched paper on the

strip, matching up the holes and the strip so that the strip is not showing at

the top or the bottom of the paper. Adjust the bind edge guide if necessary

by sliding the guide to the edge of the paper.

2. Place the back cover (face down), the punched sheets (last page on the

bottom), and front cover (face up) on top of the receiving strip.

3. Place the receiving strip (bottom binding strip with holes), textured side

down in the strip recess, located in front of the backstop. Be sure the small

hole in the receiving strip is over the locating pin. The locating pin is

on the left hand side of the strip recess area in front of the backstop.

The locating pin fits into the small hole in the plastic strip. The strip is

positioned correctly over the locating pin when it is difficult to slide the

strip to the right. Failure to properly align the strip can cause machine

damage.

4. Now determine the correct size of the pin strip. Use the scale on the

backstop to determine the thickness of the document and the size of the

pins required. Insert the strip through the document's holes and the

receiving strip.

Figure 4-2

SYSTEM TWO

OPERATING INSTRUCTIONS

Binding

1. Begin the binding process by pulling the pressure bar toward you and lowering it

on top of the document. To prevent jamming problems, lower the bar onto the

document rather than "drop" it.

2. Press the bind button, and the ready indicator will flash. When the binding cycle

is complete, you will hear beeps and the ready indicator will be off.

3. Lift the pressure bar to its original position, and the ready indicator will

illuminate continuously. Remove the bound document.

4. IF THE BINDING CYCLE IS NOT COMPLETED, THE TRAY-FULL

AND READY INDICATORS WILL FLASH ALTERNATELY. Simply turn

the machine off and on, or, press either the Bind or Punch Button. Rebind the

document. If the binding cycle is incomplete again, call for service.

5. The Tray Full Indicator will flash after 50 binds. Remove the tray with the power

on, empty it, and reinsert it.

Product specificaties

Merk:	GBC
Categorie:	Inbindmachine
Model:	SureBind System 2
Soort bediening:	Drukknoppen
Kleur van het product:	Black, Grey
Gewicht verpakking:	32750 g
Breedte verpakking:	785 mm
Diepte verpakking:	633 mm
Hoogte verpakking:	540 mm
Land van herkomst:	Portugal
Formaat:	A4 & A5
Bindcapaciteit:	500 vel
Aantal perforatiegaten:	10
Perforatiecapaciteit:	22 vel
Aansturingsmethode:	Electrisch
Media gewicht:	80 g/m²
Maximale papier breedte:	210 mm
Bindtijd:	12 s
Hoekgeleiding:	Ja
Verstelbare hoekgeleider:	Ja