Futaba 2PKA Handleiding

Futaba Radiografisch bestuurbaar speelgoed 2PKA

Lees hieronder de 📖 handleiding in het Nederlandse voor Futaba 2PKA (8 pagina's) in de categorie Radiografisch bestuurbaar speelgoed. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/8
FEATURES OF MAGNUM JUNIOR
The Magnum series are pistol grip type of AM 2 channel digital propor-
tional radio control sets and are the best in their class.
TRANSMITTER FP-T2PKA,
(FP-T2PK)_____________
• Newly panel designed cockpit type control
• Human-engineered size and design are easy to use.
•Steering rate adjuster The steering servo travel volume (right 81 left
evenly from neutral) can running. be adjusted simultaneously, while
•Throttle
ATV
The throttle
servo
travel
volume
can
be adjusted
and set with two trimmers, independently. FP-T2PKA
• Wheel angle adjuster. The turning angle can of the steering wheel
be increased and decreased. This allows operation at the best angle
• Neutral adjuster. The throttle trigger throttle stroke/brake deflection
stroke (back stroke) can be freely selected to match the application
•Servo reversing switch (steering and throttle) is standard Each servo
can be reversed from the outside. This is extremely convenient when
connecting the linkages.
• Since a level meter is provided, consumption be battery can seen at
a glance.
• Crystal can be changed from the outside. Crystal can be immediately
changed during competitions, etc. except 72 MHz and 75 MHz on
transmitter.
• Power supply can to battery be changed a nicad system. FP-T2PKA
RECEIVER
FP-R102GR_____________________
• BEC (Battery Eliminator system Circuitry) allows sharing the of
running Nicd eliminates battery and the need for a regulator and
diode.
•
Crystal socket
uses
a
new type
of
highly
reliable
subminiature
pins. Reliability is increased and the crystal can be changed from
the outside.
RECEIVER
FP-R104H_______________________
• High performance AM 4 channel receiver in which miniature size and
light weight have been achieved PC by using the board space to the
maximum.
• Short (50cm) antenna designed for miniature models is easy to mount.
(27MHz only)
•
Narrow
band
design using
a
narrow band ceramic filter
resists
adjacent
channel interference.
• Noise resistance achieved by using pulse a noise rejection circuit.
• New CMOS miniature 1C used in the data coder increases reliability
substantially.
• New type sub miniature, highly reliable pins used at the crystal socket
also increase reliability The crystal can be changed from the outside.
• Thick film gold-plated connector pins eliminate poor contact and
improve reliability against shock and vibration.
SERVO FP-S148, S129, S132H
•Motor
uses
the
newest helical type
rotor
for
improved
output
torque
and smooth S129) operation. (S148,
• These heavy-duty & water/dust tight servos are designed for use with
Futaba digital proportional
radio
control
sets
(S129)
• New indirect driver potentiometer improves vibration and shock re-
sistance and increases neutral precision tremendously.
• Futaba low-power custom 1C provides high starting torque, narrow
dead band, and excellent trackability.
• Fiberglass-reinforced PBT (polybutylene terephthalate) injection
molded servo case is mechanically strong and invulnerable against
glow fuel.
• Strong polyacetal resin ultra-precision servo gear features smooth
operation, positive neutral, and very little backlash.
• Fiberglass-reinforced epoxy resin board PC with thru-the-hole plating
improves servo amp and vibration shock resistance.
• Thick film gold-plated connector pins eliminate poor contact and
improve reliability against shock and vibration.
• Special grommet bushing simplifies servo mounting and improves the
cushioning effect.
• Six special adjustable horns splined are available.
• Maximum output torque of 48.7oz-in.(3.0kg-cm/3 5kg-cm) allows
use in (S148, almost any model S129)
• High operating speed of 0.13 sec/60° makes it perfect when especially
high speed is necessary. (S132H)
SET CONTENTS AND RATINGS
Transmitter
Receiver
Servo
Others
MAGNUM JUNIOR
FP-T2PKA
FP-R102GR or FP-R104H
FP-S148 x or 2 FP-S129 or
FP-S132H
Switch, battery holder, etc.
FP-T2PK
TRANSMITTER FP-T2PKA.
(FP-T2PK)_____________
Operating system : Pistol grip type, 2-channel
Transmitting frequency : 27MHz band 72/75MHz band
Modulation system : AM (amplitude modulation)
Power requirement 12V, AA penlight battery x 8
Receiver
PP-R102GR
________________________
Receiving frequency 75MHz
Intermediate frequency 455kHz
Selectivity :3kHz/-3dB
Receiving range 550 yards the (500m) on ground when
used with the FP-T2PKA (At best radio
wave condition of environment)
Power supply 4.8V to 8.4V
Current drain 7.2V/13mA, 4.8V/33mA
Dimensions 1.46 x 2.19 x x 0.75 x in. (37 55.5 19 mm)
Weight 1.34 oz (38g)
RECEIVER FP-R4H,
(FP-R104H)_________________
Miniature 4 channel AM receiver
Receiving frequency :2 MH7z band 72/75MHz
band
Intermediate frequency :455kHz
Power requirement :4.8V to 6.0V
Current drain :10mA
Dimensions :1.26 x 2.05 x x 0.77 in. (32 52 x 19.4 mm)
Weight :
1.06 oz (30g
)
Receiving range :
220
yards(200m) on when used the ground
with
the
FP-T2PKA(At
the
best
radio
wave
condition of environment)
SERVO
PP-S148__________________________
Control system :+pulse width control
Operating angle : One side 45° or more
Power
requirement
:
4.8V-6V
Current drain (IDLE)
: 6.0V, 8mA idle) (at
Output torque :
42 oz. in. (3 kg-cm)
Operating speed :
0.22 sec/60°
Dimensions
: 1.59 x x 0.77 1.4in. (40.4 x 19.8
x
36
mm)
Weight : 1.5 oz. (44.4g)
SERVO
FP-S129____________________________
Control system :+pulse control
Operating angle 45" :Rotary system, one-side or greater
(including trim)
Power :4 requirement .8V to 6.0V (shared with receiver)
Current drain :6.0V, 8mA (at idle)
Output torque
:48.7 oz-in (3.5kg-cm)
Operating speed
:0.25 sec /60"
Dimensions :1.79 x 0.9 x 1.71 in. (45.5 x 23
x
43
5
mm)
Weight :2.1 oz (60g)
SERVO
FP-S132H___________________________
Operating system :+pulse control
Operating angle :Rotary system, one-side 40" or greater
(including trim)
Power requirement :4.8V to 6.0V (shared with receiver)
Current drain :6.0V, 8mA (at idle)
Output torque :25.02 oz-in (1.8kg-cm)
Operating speed :0.13 sec/60°
Dimensions :1.46 x 0.71 x 1.20 in. (37 x 18 x mm) 30.5
Weight :1.13oz(32g)
TRANSMITTER FP-T2PKA (FP-T2PK)
HANDLING INSTRUCTIONS
The name of each part of the transmitter
is shown them in Fig. 1 and Fig. 2. Learn
before operating your set.
The servo reversing assumed switches are to be in the normal
position in the descriptions in this section. the servo When
switches are in the position, reverse operation the is opposite
of that described here.
(1) Steering wheel (rudder)
Steering (rudder) operation.
(2) Throttle trigger (throttle lever)
Engine control/motor control operation.
The throttle neutral position can be set one to of three position by
turning
the
8
throttle
neutral adjuster
with
a
coin
as
shown
in
Fig. 5. Set it to match the application.
When set to 1 ) the full deflection angle is 40°
When set to 2 ) the throttle throw is 27° and the
brake deflection angle is 13°.
When set to 3 ) the throttle and brake (reverse)
throws are both 20°.
• For engine cars, position 2 is recommended.
• For electric cars, position 3 is recommended when equipped
with reverse mechanism and recommended position 2 is when
equipped with a and brake forward only
(3) Steering trim
Steering (rudder) trim
(4) Steering rate adjuster
The steering servo steering angle can as be freely set shown in Fig. 6
with a ratcheted adjuster installed which enables you to adjust steer-
ing servo match travel volume to a the even while run- car to course,
ning.
Neutral
Fig.
5
(8) Throttle neutral adjuster
This adjuster
sets
the
throttle
trigger
neutral
point
as
described
in
(2)
throttle trigger. Set it to the point at which it stops with a click
with a screwdriver, coin, etc.
9 Steering (rudder) servo reversing switch
10 Throttle servo reversing switch
(11) Wheel
angle
adjuster
The wheel angle adjuster changes the operating angle of the (1) Steer-
ing wheel as in shown Fig. 8.
(12) Wheel tension adjuster
This is a phillips head screw which adjusts steering force the of the
steering wheel.
The steering can angle be
set within this range.
30%~100%
Steering servo Fig.
6
(13) Power switch
When set in the direction of the A mark (upper position), the switch
is turned pointer of the on the and level meter deflects.
(14) Level meter
When the is 13) power switch set to ON, the level meter pointer
should deflect to within the silver zone. If the pointer stops near the
boundary between the silver and red zones, the battery is low, and
the range of the radiowaves will be short. When the level meter
pointer drops to the boundary between the silver and red zones,
change the battery.
(15) Antenna
95cm antenna. as It screws in vertically shown in Fig. 10.
(5) Throttle trim knob
(6) Throttle ATV h e r hig sid trimme ATV... e Travel Volume. Adjustabl
(7) Throttle ATV low side trimmer
Throttle ATV is a device which permits independent adjustment of
the throttle servo left and sides shown right (from neutral) as in Fig.
7 with trimmers (6) and (7). (FP-T2PKA)
ATV is the abbreviation
for Adjustable Throttle
Volume and an is extreme-
ly convenient device by
which steering servo travel
volume can be adjusted
freely with two trimmers
preloaded.
The relationship between
two trimmers does not
change even when servo is
reversed.
(6)&(7):only
for
FP-T2PKA.
Throttle Servo
Fig.
7
Remove from
the holder and
screw in vertically.
Fig. 10
(16) Battery cover
When loading (or changing) the eight penlight batteries, remove this
cover as shown in Fig. 2.
(17) Transmitter crystal
When changing the frequency, replace Use crys- this crystal. the AM
tal set (transmit and receive 1 pair) sold Futaba. by The transmitter
crystal is marked TX and the receiver crystal is However, marked RX.
you are not change allowed to frequency replacing by merely crystal
on both 72 and 75MHz.

Product specificaties

Merk: Futaba
Categorie: Radiografisch bestuurbaar speelgoed
Model: 2PKA

Heb je hulp nodig?

Als je hulp nodig hebt met Futaba 2PKA stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Radiografisch bestuurbaar speelgoed Futaba

Futaba

Futaba 6EXA Handleiding

2 Juni 2023
Futaba

Futaba FP2F Handleiding

23 Mei 2023
Futaba

Futaba FP7UAFS Handleiding

21 Mei 2023
Futaba

Futaba R3006SB Handleiding

17 Mei 2023
Futaba

Futaba 9CPsuper Handleiding

7 Mei 2023
Futaba

Futaba FP5UAP Handleiding

1 Mei 2023
Futaba

Futaba 14MZ Handleiding

1 Mei 2023
Futaba

Futaba 9ZHP Handleiding

1 Mei 2023
Futaba

Futaba FP2L Handleiding

29 April 2023
Futaba

Futaba R3004SB Handleiding

29 April 2023

Handleiding Radiografisch bestuurbaar speelgoed

Nieuwste handleidingen voor Radiografisch bestuurbaar speelgoed

Amewi

Amewi Hyper Go Handleiding

30 September 2024
Carson

Carson Drift Burner Handleiding

30 September 2024
Carson

Carson Micro X-Warrior 2.0 Handleiding

30 September 2024
Carson

Carson Toxic Spider 340 Handleiding

30 September 2024
Hobbywing

Hobbywing XeRun XR10 Pro WP Handleiding

24 September 2024
Hobbywing

Hobbywing XeRun XR10 Stock Spec G2 Handleiding

24 September 2024
Hobbywing

Hobbywing XeRun XR10 Justock G3S Handleiding

24 September 2024
Hobbywing

Hobbywing XeRun XR8 PRO G3 Handleiding

24 September 2024
Hobbywing

Hobbywing XeRun XR10 Justock G3 Handout Handleiding

24 September 2024
Hobbywing

Hobbywing XeRun XR8 Plus G2S Handleiding

24 September 2024