Elektrobock BPT001 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Elektrobock BPT001 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 237 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Version 11.02
Wireless receiver for control of
electric heating devices
- UNDER SWITCH -
Operating instructions
Control of electric heating systems
Two-way radio communication at 433.92 MHz
The connected electric appliance is switched
according to the required temperature
Suitable transmitters (thermostats) for control are
BPT010 or BPT710
BPT001
BPT00
BPT00
BPT00
BPT001
1
1
1
INSTALLATION
The device can only be installed by a person with adequate qualification!
The installation must be executed in a voltage-free state!
Wiring diagram:
230 V/ 50 Hz
L
N
max.
16 A
L N
FUNCTION BUTTON (R) :
SHORT PRESS (for about 1.5 s)
- for coding.
LONG PRESS (for about 5 s)
- RESET deleting the code from the
memor y (the green and red LEDs
flash simultaneously).
BPT001 is used for switching the heating device in connec-
tion with the BPT010 or BPT710 thermostat. Its great
advantage is direct installation into the wiring box.
1. Switch off the main circuit breaker.
2. Connect the receiver according to the diagram.
3. Switch on the main circuit breaker; the green diode is
flashing on the receiver; the receiver is ready for
further setting.
4. Shortly press the FUNCTION BUTTON for about 1.5 s
(the green and red diode are flashing alternately).
5. Activate the receiver on the thermostat (transmitter)
according to the manual for the given transmitter (BPT010
or BPT710).
6. If the code has been learned correctly, the green and
red diodes flash simultaneously.
LED 2LED 1
empty memory, code not learned
code learned
FLASHING ALTERNATELY = code learning mode
FLASHING SIMULTANEOUSLY = code has been learned
SIMULTANEOUS LONG FLASH= code has been ERASED
relay switched
ERROR (if no signal is received from the transmit-
ter within approx. 6 hours, it switches to the 2-min-
ON / 8-min-OFF mode). LED 2 is only flashing if
the relay is on, i.e. for 2 minutes.
EXPLANATIONS: LIT UNLIT FLASHING
FUNCTION
ACTIVATION PROCEDURE
INDICATION DIODES


Product specificaties

Merk: Elektrobock
Categorie: Niet gecategoriseerd
Model: BPT001

Heb je hulp nodig?

Als je hulp nodig hebt met Elektrobock BPT001 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Elektrobock

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Festo

Festo VPPI Handleiding

21 November 2024
Festo

Festo SFAB Handleiding

21 November 2024
Festo

Festo SFAH Handleiding

21 November 2024
Festo

Festo DRRD-12 Handleiding

21 November 2024
Festo

Festo SDE3 Handleiding

21 November 2024
Festo

Festo SFTE Handleiding

21 November 2024
Festo

Festo CRVZS-5 Handleiding

21 November 2024