E-flite UMX Yak 54 3D BNF Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor E-flite UMX Yak 54 3D BNF (18 pagina's) in de categorie Radiografisch bestuurbaar speelgoed. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/18
Instruction Manual
Bedienungsanleitung
Manuel d’utilisation
Manuale di Istruzioni
2
EN
WARNING: Read the ENTIRE instruction manual to become familiar with the features of the
product before operating. Failure to operate the product correctly can result in damage to the product,
personal property and cause serious injury.
This is a sophisticated hobby product. It must be operated with caution and common sense and requires
some basic mechanical ability. Failure to operate this product in a safe and responsible manner could
result in injury or damage to the product or other property. This product is not intended for use by
children without direct adult supervision. Do not use with incompatible components or alter this product
in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions
for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings
in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious
injury.
Age Recommendation: Not for children under 14
years. This is not a toy.
Safety Precautions and Warnings
• Always keep a safe distance in all directions
around your model to avoid collisions or injury.
This model is controlled by a radio signal subject
to interference from many sources outside your
control. Interference can cause momentary loss
of control.
• Always operate your model in open spaces away
from full-size vehicles, traf c and people.
• Always carefully follow the directions and
warnings for this and any optional support equip-
ment (chargers, rechargeable battery packs,
etc.).
• Always keep all chemicals, small parts and
anything electrical out of the reach of children.
• Always avoid water exposure to all equipment
not specifi cally designed and protected for this
purpose. Moisture causes damage to electronics.
• Never place any portion of the model in your
mouth as it could cause serious injury or even
death.
• Never operate your model with low transmitter
batteries.
• Always keep aircraft in sight and under control.
• Always use fully charged batteries.
• Always keep the transmitter powered on while
aircraft is powered.
• Always remove batteries before disassembly.
• Always keep moving parts clean.
• Always keep parts dry.
• Always let parts cool after use before touching.
• Always remove batteries after use.
• Always ensure failsafe is properly set before
ying.
• Never operate aircraft with damaged wiring.
• Never touch moving parts.
Meaning of Special Language:
The following terms are used throughout the product literature to indicate various levels of potential
harm when operating this product:
NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage
AND little or no possibility of injury.
CAUTION: Procedures, which if not properly followed, create the probability of physical property
damage AND a possibility of serious injury.
WARNING: Procedures, which if not properly followed, create the probability of property damage,
collateral damage, and serious injury OR create a high probability of superfi cial injury.
NOTICE
All instructions, warranties and other collateral documents are subject to change at the sole discretion
of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com and click on the
support tab for this product.
3
EN
To register your product online, go to www.e-fl iterc.com
19.6 in (497mm)
16.9 in (430mm)
1.3oz
(36 g)
Table of Contents
Specifi cations
Wing Area: 37.2 sq. in.
(472.3 cm2)
1. Charge flight battery.
2. Install flight battery in aircraft (once it
has been fully charged).
3. Bind aircraft to transmitter.
4. Make sure linkages move freely.
5. Perform Control Direction Test with
transmitter.
6. Set dual rates.
7. Adjust center of gravity.
8. Perform a radio system Range Check.
9. Find a safe and open area.
10. Plan flight for flying field conditions.
Prefl ight Checklist
Installed
Motor: Ultra Micro Brushed Motor
8.5mm x 23mm (EFLU5152)
Receiver : DSM2/DSMX UM AS3X®
Receiver/Servos/ESC (EFLU5164)
(2) 2.3-Gram Performance Linear Long
Throw Servo (SPMSA2030L)
Required to Complete
Battery: 150mAh 1S 3.7V 25C/45C
Li-Po, (EFLB1501S25 or EFLB1501S45)
Battery Charger:
Celectra™ 4-Port 1S 3.7V 0.3A DC
Li-Po Charger (EFLC1004)
Recommended Transmitter:
Full range Spektrum™ DSM2®/DSMX®
with dual-rates (DX4e and up)
Transmitter and Receiver Binding ..........................4
Low Voltage Cutoff (LVC) .......................................4
Alternate Flight Mode Programming ......................5
ESC/Receiver Arming, Battery Installation and
Center of Gravity ...................................................6
Control Direction Tests ..........................................7
Control Centering .................................................8
Trimming ..............................................................8
Control Horn Settings ............................................8
Dual Rates and Expos ...........................................8
Flying Tips and Repairs .........................................9
Post Flight Checklist .............................................9
Power Components Service ................................10
Troubleshooting Guide ........................................11
Limited Warranty ................................................12
Warranty and Service Contact Information ..........14
IC Information .....................................................14
FCC Information ..................................................14
Compliance Information for the European Union ..15
Replacement Parts ...............................................54
Optional Parts and Accessories ............................ 55


Product specificaties

Merk: E-flite
Categorie: Radiografisch bestuurbaar speelgoed
Model: UMX Yak 54 3D BNF
Kleur van het product: Black, Red, White
Merkcompatibiliteit: E-flite
Lengte: 497 mm
Constructietype: Bind-N-Fly (BNF)
Batterijen vereist: Ja
Aantal kanalen: 6 kanalen
Type product: Radiografisch bestuurd (RC) passagiersvliegtuig
Type motor: Elektromotor
Reproductie: Nee
Spanwijdte: 430 mm
Aantal servo's: 1
Gewicht servo: 2.3 g
Aanbevolen batterij: 150mAh 1S 3.7V 45C LiPo

Heb je hulp nodig?

Als je hulp nodig hebt met E-flite UMX Yak 54 3D BNF stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Radiografisch bestuurbaar speelgoed E-flite

Handleiding Radiografisch bestuurbaar speelgoed

Nieuwste handleidingen voor Radiografisch bestuurbaar speelgoed