Dolgin TC40 Handleiding

Dolgin Batterij-oplader TC40

Lees hieronder de 📖 handleiding in het Nederlandse voor Dolgin TC40 (2 pagina's) in de categorie Batterij-oplader. Deze handleiding was nuttig voor 31 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/2
Battery Charger TC40-EX
Owner’s Manual
 Dolgin Engineering 1019 Massachusetts Ave. Lexington, MA 02420 • (781) 863-1813 • www.dolgin.net
1
Introduction
The TC40-EX Battery Charger is electrically compatible with BP-U60/U30 batteries (Sony EX camera
family).
Standard Features
• Four simultaneous charge positions for fast charging of 4 batteries.
• Fast, safe, and reliable charging. The battery pack can be left on the charger after the charge is complete.
• Dynamic Power Management (DPM) minimizes battery charge time. By dynamically adjusting battery
charge current, more current is allocated to the deeper discharged battery. Through this process all
batteries are ready to use at about the same time.
• Wide range input power compatibility (100-240VAC 50-60Hz).
• Compact, lightweight design for easy portability. Dimensions 10.5"x 4"x 1.5"
Batteries
The charger is capable of charging 4 batteries at the same time. It accepts Sony BP-U60/U30 style batteries.
Charging time
The time to full charge depends on the battery pack rated capacity, its state of charge prior to insertion, and
its age. A fully discharged new BP-U60 battery will be fully charged (more than 90%) in about 4 hours (4.5 -6
hours when 2 batteries in the same bank* are being charged). Since a depleted battery pack absorbs charge
current faster, than a partially charged one, most of the charge energy is absorbed during the initial stage of
charging and then the rate of charge levels off towards the end.
Charge channels
LEDs indicate each battery’s state of charge. Dynamic Power Management (DPM) minimizes battery charge
time. By dynamically adjusting battery charge current, more current is allocated to the deeper discharged of
the two batteries (in the same bank). Through this process both batteries are ready to use at about the same
time
Operation
Charging
Operation of the charger is fully automatic. Upon plugging the charger in into an electrical source the green
and red LEDs will blink every 3 seconds to indicate the charger is powered on. Mount a battery to an open
position on the charger and the charger will initiate the charge routine. While charging is in progress, the red
LED will illuminate. Approaching charge completion, the Green LED will blink at 90% readiness level, and
will be steady ON on completion.
Status LEDs
1. Red ON Battery is inserted; charge in progress
2. Green blinking Battery is charged over 90% 3. Green ON Ready
* Charging positions are grouped in 2 banks of 2 plates. In order to get the fastest charge time, when charging
2 batteries, place them in positions 1, 3.

Product specificaties

Merk: Dolgin
Categorie: Batterij-oplader
Model: TC40

Heb je hulp nodig?

Als je hulp nodig hebt met Dolgin TC40 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Batterij-oplader Dolgin

Dolgin

Dolgin TC200 Two Position Handleiding

22 Juni 2023
Dolgin

Dolgin TC40 Handleiding

31 Mei 2023
Dolgin

Dolgin TC200 Handleiding

31 Mei 2023
Dolgin

Dolgin TC400 Handleiding

31 Mei 2023

Handleiding Batterij-oplader

Nieuwste handleidingen voor Batterij-oplader

Scanstrut

Scanstrut SC-CW-05E Handleiding

28 Januari 2025
Scanstrut

Scanstrut SC-CW-01E Handleiding

28 Januari 2025
Scanstrut

Scanstrut SC-CW-06E Handleiding

28 Januari 2025
Scanstrut

Scanstrut SC-CW-04E Handleiding

27 Januari 2025
Scanstrut

Scanstrut SC-USB-01 Handleiding

27 Januari 2025
Schwaiger

Schwaiger QLS10S 513 Handleiding

6 Januari 2025
Schwaiger

Schwaiger LSET500 513 Handleiding

6 Januari 2025
Osram

Osram BATTERYcharge 405 ESSENTIAL Handleiding

28 December 2024
Anova

Anova E60CH80B Handleiding

24 December 2024
Alogic

Alogic QC10MSLV Handleiding

23 December 2024