Doepfer A-111-5v Mini Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Doepfer A-111-5v Mini (22 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/22
DOEPFER
DOEPFER
DOEPFER
DOEPFERDOEPFER
System A-100 Synthesizer Voice A-111-5
1
Fig. 1: A-111-5 sketch
1. Introduction
Synthesizer Voice A-111-5
System A-100 DOEPFER
DOEPFER
DOEPFER
DOEPFERDOEPFER
2
Module A-111-5 is a complete monophonic synthesizer
module that includes these components:
VCO
manual tune control (with an internal jumper the range
can be set to ~ +/-1 half an octave or ~ +/-2.5 octaves)
range switch -1 / 0 / +1 octave
frequency range about 10Hz ... 12kHz
FM (frequency modulation) control with modulation
source switch (LFO1 / off / ADSR)
manual pulsewidth control for rectangle waveform
PWM control with modulation source switch (LFO2 / o
/ ADSR)
waveform switch (sawtooth / off / triangle)
the sum of the waveform chosen by this switch and the
rectangle is fed into the VCF (to turn the rectangle off
the PW control has to be set fully CCW)
external CV input for VCO frequency (1V/octave)
external CV input for external PWM of the rectangle
internal CV input for frequency (1V/octave) connected
to the A-100 bus via jumper, the jumper can be used to
interrupt this internal connection if not wanted
VCF
24 dB low pass
~ 12 octaves frequency range
manual frequency control
tracking switch half - off - full (internally connected to
the external frequency CV input of the VCO, i.e. the
VCF tracks to the VCO if the switch is set to "half" or
"full" position)
XM: exponential FM (frequency modulation) control
with modulation source switch (LFO2 / off / ADSR)
LM: linear FM (frequency modulation) control to
modulate the VCF by the triangle of the VCO in a linear
(!) manner
manual resonance control (up to self oscillation)
external audio input (this signal is added to the VCO
signal)
external CV input for filter frequency
1V/octave tracking for usage of the VCF as a sine
wave oscillator (not as precise as the VCO but much
better than most of the other filters)
DOEPFER
DOEPFER
DOEPFER
DOEPFERDOEPFER
System A-100 Synthesizer Voice A-111-5
3
VCA
manual amplitude control
AM (amplitude modulation) control with modulation
source switch (LFO1 / off / ADSR)
external CV input for VCA amplitude
special control scale: exponential scale in the range from
about -20dB to -80/90dB, linear scale from about -20dB
to 0dB
Remark: this special control scale results in a loudness
behaviour that is a bit different from pure linear or
exponential VCAs
LFO1 and LFO2
manual frequency control
waveform switch (triangle / off / rectangle)
range switch (low, audio, medium)
LED display (dual green/red color for positive/negative
share of the signal)
the inverted LFO1 signal is available as an additional
socket (to use the LFO1 signal for external modules)
an internal jumper can be used to select between the
LFO1 signal or the inverted LFO1 signal
ADSR
manual controls for Attack, Decay, Sustain, Release
range switch (long, short, medium)
blue LED display
ADSR signal is available as an additional socket (to use
the ADSR signal for external modules)
Gate input connected to the A-100 bus via jumper, the
jumper can be used to interrupt this internal connection if
not wanted


Product specificaties

Merk: Doepfer
Categorie: Niet gecategoriseerd
Model: A-111-5v Mini

Heb je hulp nodig?

Als je hulp nodig hebt met Doepfer A-111-5v Mini stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Doepfer

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd