Dimplex Q3TSO Handleiding

Dimplex Heater Q3TSO

Lees hieronder de 📖 handleiding in het Nederlandse voor Dimplex Q3TSO (4 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Q2TSNH, Q2TS & Q2TSO
Q3TSNH, Q3TS & Q3TSO
08/54677/0 Issue 1
This product complies with all the required European and UK Product Safety, Electromagnetic Compatibility and Environmental Standards. They are
fully compliant with the LVD, EMC, RoHS and Eco Design Directives and Regulations.
As with all portable heang appliances: This product is suitable only for well insulated spaces or occasional use.
Dimensions
(Millimetres)
IMPORTANT SAFETY ADVICE
DO NOT use the heater in the immediate surroundings
of a bath, a shower or a swimming pool.
DO NOT place the heater directly below a xed
socket outlet.
The socket-outlet must be accessible at all times to
enable the mains plug to be disconnected as quickly
as possible.
DO NOT operate the heater with the mains lead
overhanging the front outlet grille.
DO NOT COVER or obstruct the air inlet and outlet
openings in any way.
The Heater carries the warning symbol
indicating that it must not be covered.
WARNING: In order to avoid overheating, do not
cover the heater.
IMPORTANT: If the mains lead of this appliance is
damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualied person in
order to avoid a hazard.
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external
switching device, such as a timer, or connected to
a circuit that is regularly switched on and o󰀨 by the
utility.
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
or knowledge if they have been given supervision
or instruction concerning the use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children
without supervision.
Children of less than 3 years should be kept away
unless continuously supervised.
Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been given
supervision or instruction concerning the use of the
appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than
8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
CAUTION: Some parts of this product can become
very hot and cause burns. Particular attention has
to be given where children and vulnerable people
are present.
WARNING: Risk of re Do not use this appliance
connected through an extension lead or any external
switching device such as a plug in timer or remote
control plug in adaptor. All heating appliances draw
high current through the mains supply and any
weakness in the design, connections or components
in these devices can easily result in overheating of
the connection points resulting in melting, distortion
and even the risk of re.
WARNING: To avoid danger of su󰀨ocation please
remove all packaging materials particularly plastic
and EPS and keep these away from vulnerable
people, children and babies.
WARNING: To avoid the risk of accidental
strangulation from the supply cord all children and
vulnerable people must be supervised when in the
vicinity of the product whether it is working or not.
DO NOT use this heater if it has been dropped.
DO NOT use if there are visible signs of damage to
the heater.
DO NOT pull, carry or move the appliance using the
power cable
IMPORTANT: Use this heater on a horizontal and
stable surface.
DO NOT use the heater on deep pile carpets or the
long hair type of rugs, or less than 750mm (30) away
from any overhanging surface. Keep combustible
materials such as drapes and other furnishings clear
from the front, sides and rear of the heater. Do not
use heater to dry your laundry.
WARNING: Do not use this heater in small rooms
when they are occupied by persons not capable
of leaving the room on their own, unless constant
supervision is provided.
WARNING: To reduce the risk of re, keep textiles,
curtains or any other ammable material a minimum
distance of 1m from the air outlet.
This instruction leaet belongs to the appliance and
must be kept in a safe place. If changing owners,
the leaet must be surrendered to the new owner.
Model(s) Specication
Q2TSNH, Q3TSNH 2.0kW & 3.0kW, Thermostat & Switch
Q2TS, Q3TS 2.0kW & 3.0kW, Thermostat, Switch & Handle
Q2TSO, Q3TSO 2.0kW & 3.0kW, Thermostat, Switch, Handle & Osclliation
H W D
253 235 155
289 251 155
327 251 189
InstallationandOperatingInstructions
Fig.1
3. 2.
7.
4.
8.
6.
9.
5.
1.
This heater must be used on an supply only and the voltage A.C.~ marked
on the heater must correspond to the supply voltage. This heater is tted
with a plug incorporating a 13 amp fuse. When replacing the fuse, a 13
amp fuse approved by ASTA to BS 1362 must be used.
If the plug is not suitable for the socket outlets in your home, the plug must
be cut o󰀨 and an appropriate one tted. A plug cut o󰀨 from a mains lead
will give a shock hazard if inserted into a 13 amp socket elsewhere in the
house. To avoid this, it should be disposed of immediately.
NOTE: The fuse cover of a non-rewirable plug must be retted when
changing the fuse. Should the cover become lost, the plug must not be
used until the correct replacement fuse cover is obtained from your supplier
or by contacting our customer helpline.
IMPORTANT: The wires in this mains lead are coloured in accordance
with the following code:
BLUE: NEUTRAL
BROWN: LIVE
As the colours of the wires in the mains lead may not correspond with the
coloured markings in your plug, proceed as follows:
Connect the wire to the terminal marked or coloured BROWN L RED.
Connect the wire to the terminal marked or coloured BLUE N BLACK .
Note:L or ‘ must not be connected to the terminal marked N EARTH E
or ‘ or coloured or . GREEN GREEN AND YELLOW
If in doubt, consult your electrician.
MainElements-See Fig 1.
HeatControl- see Fig. 2
ThermostatControl-see Fig. 3
The heat output is controlled by the thermostat, according to the room
temperature.
Turn the thermostat knob fully clockwise to
maximum setting initially. When the room is
warm enough, reduce the setting slowly until
the heater just clicks o󰀨.
The heater will now cycle on and o󰀨 to maintain
your selected room temperature. An audible click
may be heard when the thermostat operates - this
is normal.
Note: If the heater does not come on when the
thermostat is at a low setting, this is normally
because the room is warmer than the thermostat
setting and is not a fault.
1. Power Indicator Light
2. Switch Knob
3. Thermostat Control Knob
4. Air Outlet
5. Tip Switch
6. Inlet Grille
7. Handle (Q2TS, Q3TS, Q2TSO, Q3TSO)
8. Oscillating Base (Q2TSO, Q3TSO)
9. Oscillation Switch (Q2TSO, Q3TSO)
Fig.3
UsingtheHeate
Recycling
Cleaning
Safety-overhe
Electricalconn
OFF
Cool Blow*
Half Heat
Full Heat
Fig.2
Oscillation(Q2TS
Fig.4
ModelIdentier(s):
Q2TSNH
Q2TS
Q2TSO
Q3TSNH
Q3TS
Q3TSO
Heatoutput
Nominal heat output Pnom 2.0 3.0 kW
Minimum heat output (indicative) Pmin 0.8 1.5 kW
Maximum continuous heat output Pmax,c 2.0 3.0 kW
AuxiliaryelectricityConsumption
At nominal heat output 0.0 0.0 kWelmax
At minimum heat output elmin 0.0 0.0 kW
In standby mode elSB 0.0 0.0 kW
Typeofheatoutput/roomtemperaturecontrol
Mechanical thermostat room temperature control Yes
Contact details
Glen Dimplex Heating & Ventilation
Millbrook House, Grange Drive, Hedge
End, Southampton.
SO30 2DF
* When the heat control is set to for cool blow, set the thermostat
control to maximum.Position ‘ will turn the heater on and o󰀨 to maintain
a temperature of approximately 5°C.
The heater can be switched into oscillation mode by pressing the switch on
the rear of the oscillation base, see 9. - Fig1.Position will turn oscillation
on and position will turn oscillation o󰀨, see Fig.4. The heater oscillates
back and forth on its base through 90 degrees. Oscillation feature provides
Heating and Cooling e󰀨ect across a wide area. This is particularly useful
for providing maximum coverage for Heating or Cooling e󰀨ect quickly
and e󰀩ciently.
For your safety, this appliance is tted with a thermal cut-out. In the event
that the product overheats, the cut-out switches the heater o󰀨 automatically.
To bring the heater back into operation, remove the cause of overheating,
then turn o󰀨 the electrical supply to the heater for a few minutes.
When the heater has cooled su󰀩ciently reconnect and switch on the heater.
If the cut-out operates repeatedly, contact your supplier.
WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORECLEANINGTHEHEATER.
Do not use detergents, abrasive cleaning powders or polish of any kind
on the heater.
Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean
o󰀨 stains. Be careful not to allow moisture into the heater. This heater is
provided with an air lter. This is designed to remove large dust particles,
u󰀨 and hair to enhance air quality. It is recommended the lter be removed
regularly to clean to avoid overheating of the element. Use a vacuum
cleaner to remove any u󰀨 which does accumulate.
For electrical products sold within the European
Community.
At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice
in your country.


Product specificaties

Merk: Dimplex
Categorie: Heater
Model: Q3TSO

Heb je hulp nodig?

Als je hulp nodig hebt met Dimplex Q3TSO stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Heater Dimplex

Handleiding Heater

Nieuwste handleidingen voor Heater