Dimplex Q3TSNH Handleiding

Dimplex Heater Q3TSNH

Lees hieronder de 📖 handleiding in het Nederlandse voor Dimplex Q3TSNH (4 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

Q2TSNH, Q2TS & Q2TSO

Q3TSNH, Q3TS & Q3TSO

08/54677/0 Issue 1

This product complies with all the required European and UK Product Safety, Electromagnetic Compatibility and Environmental Standards. They are

fully compliant with the LVD, EMC, RoHS and Eco Design Directives and Regulations.

As with all portable heang appliances: This product is suitable only for well insulated spaces or occasional use.

Dimensions

(Millimetres)

IMPORTANT SAFETY ADVICE

DO NOT use the heater in the immediate surroundings

of a bath, a shower or a swimming pool.

DO NOT place the heater directly below a xed

socket outlet.

The socket-outlet must be accessible at all times to

enable the mains plug to be disconnected as quickly

as possible.

DO NOT operate the heater with the mains lead

overhanging the front outlet grille.

DO NOT COVER or obstruct the air inlet and outlet

openings in any way.

The Heater carries the warning symbol

indicating that it must not be covered.

WARNING: In order to avoid overheating, do not

cover the heater.

IMPORTANT: If the mains lead of this appliance is

damaged, it must be replaced by the manufacturer

or its service agent or a similarly qualied person in

order to avoid a hazard.

WARNING: In order to avoid a hazard due to

inadvertent resetting of the thermal cut-out, this

appliance must not be supplied through an external

switching device, such as a timer, or connected to

a circuit that is regularly switched on and o󰀨 by the

utility.

This appliance can be used by children aged from 8

years and above and persons with reduced physical,

sensory or mental capabilities or lack of experience

or knowledge if they have been given supervision

or instruction concerning the use of the appliance in

a safe way and understand the hazards involved.

Children shall not play with the appliance. Cleaning

and user maintenance shall not be made by children

without supervision.

Children of less than 3 years should be kept away

unless continuously supervised.

Children aged from 3 years and less than 8 years

shall only switch on/off the appliance provided

that it has been placed or installed in its intended

normal operating position and they have been given

supervision or instruction concerning the use of the

appliance in a safe way and understand the hazards

involved. Children aged from 3 years and less than

8 years shall not plug in, regulate and clean the

appliance or perform user maintenance.

IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

CAUTION: Some parts of this product can become

very hot and cause burns. Particular attention has

to be given where children and vulnerable people

are present.

WARNING: Risk of re – Do not use this appliance

connected through an extension lead or any external

switching device such as a plug in timer or remote

control plug in adaptor. All heating appliances draw

high current through the mains supply and any

weakness in the design, connections or components

in these devices can easily result in overheating of

the connection points resulting in melting, distortion

and even the risk of re.

WARNING: To avoid danger of su󰀨ocation please

remove all packaging materials particularly plastic

and EPS and keep these away from vulnerable

people, children and babies.

WARNING: To avoid the risk of accidental

strangulation from the supply cord all children and

vulnerable people must be supervised when in the

vicinity of the product whether it is working or not.

DO NOT use this heater if it has been dropped.

DO NOT use if there are visible signs of damage to

the heater.

DO NOT pull, carry or move the appliance using the

power cable

IMPORTANT: Use this heater on a horizontal and

stable surface.

DO NOT use the heater on deep pile carpets or the

long hair type of rugs, or less than 750mm (30”) away

from any overhanging surface. Keep combustible

materials such as drapes and other furnishings clear

from the front, sides and rear of the heater. Do not

use heater to dry your laundry.

WARNING: Do not use this heater in small rooms

when they are occupied by persons not capable

of leaving the room on their own, unless constant

supervision is provided.

WARNING: To reduce the risk of re, keep textiles,

curtains or any other ammable material a minimum

distance of 1m from the air outlet.

This instruction leaet belongs to the appliance and

must be kept in a safe place. If changing owners,

the leaet must be surrendered to the new owner.

Model(s) Specication

Q2TSNH, Q3TSNH 2.0kW & 3.0kW, Thermostat & Switch

Q2TS, Q3TS 2.0kW & 3.0kW, Thermostat, Switch & Handle

Q2TSO, Q3TSO 2.0kW & 3.0kW, Thermostat, Switch, Handle & Osclliation

H W D

253 235 155

289 251 155

327 251 189

InstallationandOperatingInstructions

Fig.1

3. 2.

This heater must be used on an supply only and the voltage A.C.~ marked

on the heater must correspond to the supply voltage. This heater is tted

with a plug incorporating a 13 amp fuse. When replacing the fuse, a 13

amp fuse approved by ASTA to BS 1362 must be used.

If the plug is not suitable for the socket outlets in your home, the plug must

be cut o󰀨 and an appropriate one tted. A plug cut o󰀨 from a mains lead

will give a shock hazard if inserted into a 13 amp socket elsewhere in the

house. To avoid this, it should be disposed of immediately.

NOTE: The fuse cover of a non-rewirable plug must be retted when

changing the fuse. Should the cover become lost, the plug must not be

used until the correct replacement fuse cover is obtained from your supplier

or by contacting our customer helpline.

IMPORTANT: The wires in this mains lead are coloured in accordance

with the following code:

BLUE: NEUTRAL

BROWN: LIVE

As the colours of the wires in the mains lead may not correspond with the

coloured markings in your plug, proceed as follows:

Connect the wire to the terminal marked ‘ ’ or coloured BROWN L RED.

Connect the wire to the terminal marked ‘ ’ or coloured BLUE N BLACK .

Note: ‘L’ or ‘ ’ must not be connected to the terminal marked ‘N EARTH E’

or ‘ ’ or coloured or . GREEN GREEN AND YELLOW

If in doubt, consult your electrician.

MainElements-See Fig 1.

HeatControl- see Fig. 2

ThermostatControl-see Fig. 3

The heat output is controlled by the thermostat, according to the room

temperature.

Turn the thermostat knob fully clockwise to

maximum setting initially. When the room is

warm enough, reduce the setting slowly until

the heater just clicks o󰀨.

The heater will now cycle on and o󰀨 to maintain

your selected room temperature. An audible click

may be heard when the thermostat operates - this

is normal.

Note: If the heater does not come on when the

thermostat is at a low setting, this is normally

because the room is warmer than the thermostat

setting and is not a fault.

1. Power Indicator Light

2. Switch Knob

3. Thermostat Control Knob

4. Air Outlet

5. Tip Switch

6. Inlet Grille

7. Handle (Q2TS, Q3TS, Q2TSO, Q3TSO)

8. Oscillating Base (Q2TSO, Q3TSO)

9. Oscillation Switch (Q2TSO, Q3TSO)

Fig.3

UsingtheHeate

Recycling

Cleaning

Safety-overhe

Electricalconn

OFF

Cool Blow*

Half Heat

Full Heat

Fig.2

Oscillation(Q2TS

Fig.4

ModelIdentier(s):

Q2TSNH

Q2TS

Q2TSO

Q3TSNH

Q3TS

Q3TSO

Heatoutput

Nominal heat output Pnom 2.0 3.0 kW

Minimum heat output (indicative) Pmin 0.8 1.5 kW

Maximum continuous heat output Pmax,c 2.0 3.0 kW

AuxiliaryelectricityConsumption

At nominal heat output 0.0 0.0 kWelmax

At minimum heat output elmin 0.0 0.0 kW

In standby mode elSB 0.0 0.0 kW

Typeofheatoutput/roomtemperaturecontrol

Mechanical thermostat room temperature control Yes

Contact details

Glen Dimplex Heating & Ventilation

Millbrook House, Grange Drive, Hedge

End, Southampton.

SO30 2DF

* When the heat control is set to ‘ ’ for cool blow, set the thermostat

control to maximum.Position ‘ ’ will turn the heater on and o󰀨 to maintain

a temperature of approximately 5°C.

The heater can be switched into oscillation mode by pressing the switch on

the rear of the oscillation base, see 9. - Fig1.Position ‘ ’ will turn oscillation

on and position ‘ ’ will turn oscillation o󰀨, see Fig.4. The heater oscillates

back and forth on its base through 90 degrees. Oscillation feature provides

Heating and Cooling e󰀨ect across a wide area. This is particularly useful

for providing maximum coverage for Heating or Cooling e󰀨ect quickly

and e󰀩ciently.

For your safety, this appliance is tted with a thermal cut-out. In the event

that the product overheats, the cut-out switches the heater o󰀨 automatically.

To bring the heater back into operation, remove the cause of overheating,

then turn o󰀨 the electrical supply to the heater for a few minutes.

When the heater has cooled su󰀩ciently reconnect and switch on the heater.

If the cut-out operates repeatedly, contact your supplier.

WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY

BEFORECLEANINGTHEHEATER.

Do not use detergents, abrasive cleaning powders or polish of any kind

on the heater.

Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean

o󰀨 stains. Be careful not to allow moisture into the heater. This heater is

provided with an air lter. This is designed to remove large dust particles,

u󰀨 and hair to enhance air quality. It is recommended the lter be removed

regularly to clean to avoid overheating of the element. Use a vacuum

cleaner to remove any u󰀨 which does accumulate.

For electrical products sold within the European

Community.

At the end of the electrical products useful life it

should not be disposed of with household waste.

Please recycle where facilities exist. Check with

your Local Authority or retailer for recycling advice

in your country.

Product specificaties

Merk:	Dimplex
Categorie:	Heater
Model:	Q3TSNH
Kleur van het product:	Black, White
Ingebouwd display:	Nee
Gewicht:	1.9 g
Breedte:	235 mm
Diepte:	155 mm
Hoogte:	153 mm
Snoerlengte:	1.8 m
Wi-Fi-besturing:	Nee
Gewicht verpakking:	2.3 g
Breedte verpakking:	240 mm
Diepte verpakking:	160 mm
Hoogte verpakking:	300 mm
Soort:	Huishoudelijke ventilator met bladen
Gebruikershandleiding:	Ja
Materiaal behuizing:	Plastic, Steel
Aantal snelheden:	2
Type verpakking:	Doos
Aan/uitschakelaar:	Ja
Plaatsing:	Vloer
In hoogte verstelbaar:	Nee
Type stroombron:	AC
Ingebouwd licht:	Nee
Export Control Classification Number (ECCN):	8516299100
Ionic functie:	Nee
Afstandsbediening inbegrepen:	Nee
Stroomverbruik (typisch):	2000 W
Zwenkwieltjes:	Nee
Auto oscillatie:	Nee
Garantieperiode:	3 jaar