Dimplex DXUF30T Handleiding

Dimplex Heater DXUF30T

Lees hieronder de 📖 handleiding in het Nederlandse voor Dimplex DXUF30T (2 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 13 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

Fan Heaters

Model(s) : DXUF20T & DXUF30T

Installation and Operating Instructions

Dimensions

(millimetres)

08/35113/0 Issue 0

Electrical connection

This heater must be used on an A.C.~ supply only and the voltage

marked on the heater must correspond to the supply voltage. This heater

is fitted with a plug incorporating a 13 amp fuse. When replacing the

fuse, a 13 amp fuse approved by ASTA to BS 1362 must be used.

If the plug is not suitable for the socket outlets in your home, the plug

must be cut off and an appropriate one fitted. A plug cut off from a

mains lead will give a shock hazard if inserted into a 13 amp socket

elsewhere in the house. To avoid this, it should be disposed of

immediately.

Using the Heater

Thermostat Control - see Fig. 3

The heat output is controlled by the

thermostat, according to the room

temperature.

Turn the thermostat knob fully clockwise

to maximum setting initially. When the

room is warm enough, reduce the setting

slowly until the heater just clicks off.

The heater will now cycle on and off to maintain your selected room

temperature. An audible click may be heard when the thermostat

operates - this is normal.

Note : If the heater does not come on when the thermostat is at a low

setting, this is normally because the room is warmer than the thermostat

setting and is not a fault.

* When the heat control is set to ‘ ‘ for cool blow, set the thermostat

control to maximum.

Position ‘*‘ will turn the heater on and off to maintain a temperature of

approximately 5°C.

- OFF

- Cool Blow*

- Half heat

- Full heat

Heat Control - see Fig. 2

(IP20)

H W D

236 242 175

Model(s) Specification

DXUF20T 2.0kW Thermostat & Switch

DXUF30T 3.0kW Thermostat & Switch

Fig. 2

Fig. 3

(see Fig. 3)

Fig. 1

(see Fig. 2)

IMPORTANT SAFETY ADVICE

READ THESE INSTRUCTIONS BEFORE USE.

DO NOT use the heater on deep pile carpets or the long hair

type of rugs, or less than 750mm (30") away from any

overhanging surface. Keep combustible materials such as

drapes and other furnishings clear from the front, sides

and rear of the heater. Do not use heater to dry your laundry.

DO NOT use the heater in the immediate surroundings of a

bath, a shower or a swimming pool.

DO NOT place the heater directly below a fixed socket outlet.

The socket-outlet must be accessible at all times to enable

the mains plug to be disconnected as quickly as possible.

DO NOT COVER or obstruct the air inlet and outlet openings

in any way.

The heater must be on a flat stable surface when in use.

DO NOT operate the heater with the mains lead overhanging

the front outlet grille.

NEVER leave the heater unattended when it is used by or

near the aged, infirm person’s or children.

The heater carries the Warning symbol indicating that

it must not be covered.

The instruction leaflet belongs to the appliance and must

be kept in a safe place. If changing owners, the leaflet

must be surrendered to the new owner.

IMPORTANT – If the mains lead of this appliance is damaged,

it must be replaced by the manufacturer or its service

agent or a similarly qualified person in order to avoid a

hazard.

WARNING: In order to avoid a hazard due to inadvertent

resetting of the thermal cut-out, this appliance must not be

supplied through an external switching device, such as a

timer, or connected to a circuit that is regularly switched on

and off by the utility.

IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

NOTE: The fuse cover of a non-rewirable plug must be refitted when

changing the fuse. Should the cover become lost, the plug must not be

used until the correct replacement fuse cover is obtained from your

supplier or by contacting our customer helpline.

IMPORTANT : The wires in this mains lead are coloured in accordance

with the following code :

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead may not correspond with

the coloured markings in your plug, proceed as follows :

Connect the BROWN wire to the terminal marked ‘L’ or coloured RED.

Connect the BLUE wire to the terminal marked ‘N’ or coloured BLACK.

Note : ‘L’ or ‘N’ must not be connected to the EARTH terminal marked

‘ .E’ or or coloured GREEN or GREEN AND YELLOW

If in doubt, consult your electrician.

The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)

EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336

Cleaning

WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE

CLEANING THE HEATER.

Do not use detergents, abrasive cleaning powders or polish of any kind

on the heater.

Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean

off stains. Be careful not to allow moisture into the heater.

Ensure that dust or fluff does not accumulate inside the heater as this

could lead to overheating of the element. Use a vacuum cleaner to remove

any fluff which does accumulate.

[c] Glen Dimplex UK Limited

UK customer help line (8.00AM – 6.00PM Mon-Fri; 8.30AM-1.00PM Sat)

Customer Services: Tel. 0870 7270101

Fax. 0870 7270102

e-mail customer.services@glendimplex.com

Republic of Ireland Tel. 01 8424833

Glen Dimplex UK Limited

Millbrook House

Grange Drive

Hedge End

Southampton

Hampshire. SO30 2DF

After Sales Service

Your product is guaranteed for three years from the date of purchase.

Within this period, we undertake to repair or exchange this product free

of charge provided it has been installed and operated in accordance

with these instructions.

Your rights under this guarantee are additional to your statutory rights,

which in turn are not affected by this guarantee.

Should you require after sales service you should contact our customer

services help desk on 0870 727 0101. It would assist us if you can

quote the model number, series, date of purchase, and nature of the fault

at the time of your call. The customer services help desk will also be able

to advise you should you need to purchase any spares.

Please do not return a faulty product to us in the first

instance as this may result in loss or damage and delay in providing you

with a satisfactory service.

Please retain your receipt as proof of purchase.

Recycling

For electrical products sold within the European

Community.

At the end of the electrical products useful life it should

not be disposed of with household waste. Please recycle

where facilities exist. Check with your Local Authority or

retailer for recycling advice in your country.

Safety - overheat protection

For your safety, this appliance is fitted with a thermal cut-out. In the

event that the product overheats, the cut-out switches the heater off

automatically. To bring the heater back into operation, remove the cause

of overheating, then turn off the electrical supply to the heater for a few

minutes.

When the heater has cooled sufficiently reconnect and switch on the

heater.

If the cut-out operates repeatedly, contact your supplier.

Product specificaties

Merk:	Dimplex
Categorie:	Heater
Model:	DXUF30T
Soort bediening:	Draaiknop
Kleur van het product:	Grijs
Gewicht:	1400 g
Breedte:	247 mm
Diepte:	184 mm
Hoogte:	238 mm
Soort:	Ventilator elektrisch verwarmingstoestel
Internationale veiligheidscode (IP):	IP20
Indicatielampje:	Ja
Instelbare thermostaat:	Ja
Oververhittingsbeveiliging:	Ja
Draagbaar:	Ja
Bevriezings beveiliging:	Ja
Verwarmingsvermogen:	3000 W
Plaatsingsopties:	Tafel
Verwarming power (min):	- W
Zomer-ventilatie:	Ja