Danfoss TP5001Range installatie Handleiding

Danfoss Thermostaat TP5001Range installatie

Lees hieronder de 📖 handleiding in het Nederlandse voor Danfoss TP5001Range installatie (92 pagina's) in de categorie Thermostaat. Deze handleiding was nuttig voor 54 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/92
TP5001 Range
Installation Instructions
Installationsanleitung
Instrucciones de instalación
Monteringsvejledning
Electronic 5/2 day programmable room thermostat
Mains, Battery and RF versions
GB
D
ES
Installatiehandleiding
Instructions d’installation
Istruzioni per l’installazione
DK
NL
F
I
2
Installation Instructions
Important note RF products: Ensure that there are no large metal objects, such as boiler cases
or other large appliances, in line of sight between the transmitter and receiver as these will
prevent communication between thermostat and receiver.
Product Specifi cation
Please Note:
This product should only be installed by a qualifi ed electrician
or competent heating installer and should be in accordance
with the current edition of the IEEE wiring regulations.
Thermostat features TP5001 (A) TP5001-RF TP5001M (A)
Power supply 2 x AA/MN1500/LR
alkaline cells
230V, ±15%,
50Hz
Memory back-up Retained for life of product
Temperature Range
Sensing
5-30°C
Factory set calendar clock Automatic summer/winter time change
Switching action of
output relay
3(1)A,
10-230V
N/A 3(1)A, 10-230V,
Type 1B
Transmission frequency
(RF models)
N/A 433.92MHz N/A
Transmission range
(RF models)
N/A 30m max. N/A
Remote sensor inputs
(A models only)
Can be set by installer for remote temperature sensor,
limit sensor, window contact or telephone activated
switch contacts
Dimensions (mm) 110 wide, 88 high, 28 deep
Design standard EN60730-2-9 (EN300220 for RF)
Rated impulse voltage 2.5kV
Ball hardness test 75°C
Control pollution
situation
Degree 2
Temperature accuracy ±1°C
Time accuracy ±1 min. per month
Installation Instructions
GB
3
Installation Instructions
GB
Installation
First, remove the wallplate from the back of the unit.
From the top left hand corner of the wallplate, there must be
clearances of at least 15mm to the right, 15mm to the left, 30mm
above and 100mm below in order to mount the plug-in module.
Thermostat and Remote Room Sensor:
Fix at a height of approximately 1.5m from the fl oor, away from
draughts or heat sources such as radiators, open fi res or direct
sunlight.
Prior to mounting the unit the 2 DIL switches on the rear of the
unit have to be moved to the required position. The factory
presets are shown below.
1
2
Keyboard disabled
Reset disabled Reset enabled
Keyboard enabled
OFF ON
Sw. No.


Product specificaties

Merk: Danfoss
Categorie: Thermostaat
Model: TP5001Range installatie

Heb je hulp nodig?

Als je hulp nodig hebt met Danfoss TP5001Range installatie stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Thermostaat Danfoss

Handleiding Thermostaat

Nieuwste handleidingen voor Thermostaat