Ctek MXS 10 Handleiding

Ctek Batterij-oplader MXS 10

Lees hieronder de 📖 handleiding in het Nederlandse voor Ctek MXS 10 (9 pagina's) in de categorie Batterij-oplader. Deze handleiding was nuttig voor 56 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/9
EN
EN • 3
MANUAL
SAFETY
•Thechargerisdesignedforchargingonlybat-
teriesaccordingtothetechnicalspecication.
Donotusethechargerforanyotherpurpose.
Alwaysfollowbatterymanufacturers'userand
safetyrecommendations.
•Nevertrytochargenon-rechargeablebatteries.
•Neverplacethechargerontopofthebattery
orcoverthechargerwhencharging.
•Neverchargeafrozenordamagedbattery.
•NeverchargeaLi-batterywithtemperature
below0°C(32°F)ifnotspeciedbythebattery
manufacturer.
•Neveruseachargerwithdamagedcables.
Ensurethatthecableshavenotbeendamaged
byhotsurfaces,sharpedgesorinanyother
way.
•Neverplaceafan-cooledchargersothatdust,
dirtorsimilarcanbesuckedintothefan.
•Adamagedcablemustbereplacedbya
CTEKrepresentativeusinganoriginalpart
suppliedbyCTEK.Adetachablecablecanbe
replacedbytheuserusinganoriginalpartsup-
pliedbyCTEK.
•Connectiontothemainssupplymustbein
accordancewiththenationalregulationsfor
electricalinstallations.
•Chargerswithgroundedmainsplugmustonly
beconnectedtoagroundedsocketoutlet.
•Duringcharging,Lead-Acidbatteriescould
emitexplosivegases.Preventsparkscloseto
thebattery.Provideforgoodventilation.
•ChargerswithIP-classlowerthanIPx4are
designedforindooruse.Seetechnicalspeci-
cation.Donotexposetorainorsnow.
•Connectthechargertothebattery´spositive
poleandthentothenegativepole.Forbatter-
iesmountedinsideavehicle,connectthenega-
CONGRATULATIONS
tothepurchaseofyournewprofessionalswitchmodebatterycharger.Thischargeris
includedinaseriesofprofessionalchargersfromCTEKSWEDENABandrepresentsthe
latesttechnologyinbatterycharging.
4 • EN
tiveconnectiontothevehiclechassisremote
fromthefuelpipe.Thenconnectthechargerto
mainssupply.
•Disconnectthechargerfromthemainssupply.
Nextremovethenegativeconnection(vehicle
chassis)andthenthepositiveconnection.
•Don’tleaveanybatteryunattendedfora
longerperiodoftimeduringcharging.Ifany
erroroccursdisconnectthechargermanually.
•(IEC 7.12 ed.5)Thisapplianceisnot
intendedforusebypersons(includingchildren)
withreducedphysical,sensoryormentalcapa-
bilities,orlackofexperienceandknowledge,
unlesstheyhavebeengivensupervisionor
instructionconcerninguseoftheapplianceby
apersonresponsiblefortheirsafety.Children
shouldbesupervisedtoensurethattheydonot
playwiththeappliance.
(EN 7.12)Thisappliancecanbeusedby
childrenagedfrom8yearsandaboveand
personswithreducedphysical,sensoryor
mentalcapabilities,orlackofexperienceand
knowledgeiftheyhavebeengivensupervi-
sionorinstructionconcerninguseoftheappli-
anceinasafewayandunderstandthehazards
involved.Childrenshallnotplaywiththeappli-
ance.Cleaningandusermaintenanceshallnot
bemadebychildrenwithoutsupervision.
EN
EN • 5
NORMAL
BAT TERY
PROGRAM
ERROR LAMP
AGM
BAT TERY
PROGRAM
fULLY ChARGEdREAdY TO USE
RECONd
PROGRAM
SUPPLY
PROGRAM
POWER
LAMP
hOW TO ChARGE
1. Connectthechargertothebattery.
2. Connectthechargertothewallsocket.Thepowerlampwillindicatethatthemains
cableisconnectedtothewallsocket.Theerrorlampwillindicateifthebatteryclamps
areincorrectlyconnected.Thereversepolarityprotectionwillensurethatthebattery
orchargerwillnotbedamaged.
3. PresstheMODE-buttontoselectchargingprogram.
4. Followthe8-stepdisplaythroughthechargingprocess.
ThebatteryisreadytostarttheenginewhenSTEP4islit.
ThebatteryisfullychargedwhenSTEP7islit.
5. Stopchargingatanytimebydisconnectingthemainscablefromthewallsocket.
MOdE-
BUT TON
TEMPERATURE
SENSO R
INdICATOR

Product specificaties

Merk: Ctek
Categorie: Batterij-oplader
Model: MXS 10

Heb je hulp nodig?

Als je hulp nodig hebt met Ctek MXS 10 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Batterij-oplader Ctek

Ctek

Ctek READY AUTOMOTIVE Handleiding

25 April 2024
Ctek

Ctek Smartpass 120T Handleiding

12 Juni 2023
Ctek

Ctek CS ONE Handleiding

4 Juni 2023
Ctek

Ctek CT5 Handleiding

4 Juni 2023
Ctek

Ctek MXT 14 Handleiding

15 Mei 2023
Ctek

Ctek M15 Handleiding

6 Mei 2023
Ctek

Ctek D250T Handleiding

6 Mei 2023
Ctek

Ctek Pro Battery Tester Handleiding

4 Mei 2023
Ctek

Ctek Bumper 120 Handleiding

1 Mei 2023
Ctek

Ctek XS 7000 Handleiding

27 April 2023

Handleiding Batterij-oplader

Nieuwste handleidingen voor Batterij-oplader

Yamaha

Yamaha CC-T1A Handleiding

2 December 2024
EMOS

EMOS N9361 Handleiding

2 December 2024
EMOS

EMOS N9341 Handleiding

2 December 2024
Vimar

Vimar ELVOX ZBA6 Handleiding

1 December 2024
Vimar

Vimar ELVOX ECB5 Handleiding

1 December 2024
Vimar

Vimar ELVOX ECB4 Handleiding

1 December 2024
Vimar

Vimar ELVOX ECB3 Handleiding

1 December 2024
StarTech.com

StarTech.com 160W-POWER-ADAPTER Handleiding

30 November 2024
Nitecore

Nitecore NES1200 Handleiding

30 November 2024
Nitecore

Nitecore D2 Handleiding

30 November 2024