Chauvet WELL POD 3 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Chauvet WELL POD 3 (20 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/20
English EN
Español ES
Français FR
Deutsch DE
Nederlands NL
Quick Reference Guide
Model ID: WELLPOD3X4
Scan the QR code to
access the product page,
warranty terms, and the
complete User Manual
1
EN
QUICK REFERENCE GUIDE
WELL POD 3 QRG Rev. 1
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the WELL POD 3.
• The luminaire is intended for professional use only.
• The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than
1.6 ft (0.5 m) is not expected.
• If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord
exclusively available from the manufacturer or its service agent.
• The light source contained in this luminaire shall only be replaced by the manufacturer or its service agent or
a similar qualified person.
• CAUTION:
• This product’s housing may be hot when operating. Mount this product in a location with adequate
ventilation, at least 20 in (50 cm) from adjacent surfaces.
• When transferring the product from extreme temperature environments, (e.g., cold truck to warm humid
ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure,
allow the product to fully acclimate to the surrounding environment before connecting it to power.
• Flashing light is known to trigger epileptic seizures. User must comply with local laws regarding notification
of strobe use.
• ALWAYS:
• Disconnect from power before cleaning the product or replacing the fuse.
• When using an IP65-rated product in an outdoor environment, use IP65- (or higher) rated power and data
cable.
• Replace and secure IP-rated protective covers to all power, data, USB, or other ports when not in use.
• Replace the fuse with the same type and rating.
• Use a safety cable when mounting this product overhead.
• Connect this product to a grounded and protected circuit.
• DO NOT:
• Open this product. It contains no user-serviceable parts.
• Look at the light source when the product is on.
• Leave any flammable material within 1.6 (0.5 m) of this product while operating or connected to power.
• Connect this product to a dimmer or rheostat.
• Operate this product if the housing, lenses, or cables appear damaged.
• Submerge this product (adhere to standards for the published IP rating). Regular outdoor operation is fine.
• Permanently install outdoors in locations with extreme environmental conditions. This includes, but is not
limited to:
• Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).
• Locations where normal temperatures exceed the temperature ranges in this manual.
• Locations that are prone to flooding or being buried in snow.
• Other areas where the product will be subject to extreme radiation or caustic substances.
• ONLY use the hanging/mounting bracket to carry this product.
• The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
• The minimum startup temperature is -14 °F (-10 °C). Do not start the product at lower temperatures.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
• In the event of a serious operating problem, stop using immediately.
EN
2
WELL POD 3 QRG Rev. 1
QUICK REFERENCE GUIDE
Battery Charge Notes
Rechargeable lithium-ion batteries are potentially hazardous and can present a serious FIRE HAZARD, SERIOUS
INJURY, and/or PROPERTY DAMAGE if damaged, defective, or improperly used.
FCC Statement of Compliance
This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
RF Exposure Warning for North America and Australia
Warning! This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm between the radiator and the user. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
What is Included
• ALWAYS:
• Charge using a manufacturer-provided charger while the product is powered off.
• Charge the battery in temperatures between 32°–95°F (0°–35°C).
• Allow a depleted battery to charge for a few minutes before turning on the product. If the battery is
completely discharged, the device cannot be turned on immediately when the charger is connected.
• Keep at least 3 ft (1 m) distance to any heat source and away from flammable materials.
• Keep the lid of any charging case open while charging.
• Keep batteries away from children.
• Store batteries between 40–60% charge.
• Follow local regulations when disposing of batteries.
• Replace with an authentic Chauvet battery.
• DO NOT:
• Continue charging if the battery becomes hot, smokes, swells, or gives off an odor during charging.
• Leave the product unattended while charging.
• Deplete the battery below 10%.
• Charge the battery in a closed container.
• Charge for more than 24 hours.
• (6) WELL POD 3
• (1) charging case
• (6) Omega brackets
• (6) detachable split yokes
• (6) white sleeves
• (1) RF controller
• Quick Reference Guide


Product specificaties

Merk: Chauvet
Categorie: Niet gecategoriseerd
Model: WELL POD 3

Heb je hulp nodig?

Als je hulp nodig hebt met Chauvet WELL POD 3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Chauvet

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

KDK

KDK RG30AHM1 Handleiding

18 December 2024
Girmi

Girmi ST12 Handleiding

18 December 2024
Girmi

Girmi ST11 Handleiding

18 December 2024
KDK

KDK TG3AE1 Handleiding

18 December 2024
KDK

KDK TG3BL1 Handleiding

18 December 2024
KDK

KDK RG20AHM1 Handleiding

18 December 2024
Viewsonic

Viewsonic EP5555 Handleiding

18 December 2024