Braun Saphir-Jet PV 1510 Handleiding

Braun Strijkijzer Saphir-Jet PV 1510

Lees hieronder de šŸ“– handleiding in het Nederlandse voor Braun Saphir-Jet PV 1510 (4 pagina's) in de categorie Strijkijzer. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Saphir-jet
PV 1502 Type 4685
PV 1505 Type 4315
PV 1510 Type 4684
PV 1512 Type 4687
Steam iron
English
Use Instructions
Guarantee
Service Centers
English
Super hard sole plate
Your Braun steam iron has a unique sole plate
made out of a special resistant alloy, polished
with sapphire particles. This process developed
by Braun makes the sole plate extremely durable
and scratch resistant. Even ironing over sharp-
edged fasteners, studs or zippers will not cause
scratches that may snag or damage sensitive
fabric. Thanks to its extra hardness, this sole
plate will maintain its easy gliding properties
throughout the life of the iron.
2 3
Our products are engineered to meet the
highest standards of quality, functionality
and design. We hope you thoroughly enjoy
your new Braun steam iron.
Notice: Should the sole plate of your model have
a protective plastic covering, take it oļ¬€ before
using the iron.
Important Safeguards
ā€¢ Read all instructions carefully before using the iron. Keep the use instructions during the
entire life of the iron.
ā€¢ Before ļ¬lling with water, always disconnect the plug from the socket ļ¬rst.
ā€¢ Always pull the plug and not the cord.
ā€¢ Electric irons reach high temperatures during operation that could lead to burns.
ā€¢ Keep the iron away from children, and when it is turned on, keep the unit under supervision.
ā€¢ Disconnect the plug when leaving the room where you are ironing, even if it is only brieļ¬‚y.
ā€¢ Never iron or dampen clothes while wearing them.
ā€¢ During ironing pauses, always place the iron upright in its heel rest.
ā€¢ Never immerse the iron in water or other liquids.
ā€¢ The cord should never come into contact with hot objects or the sole plate.
ā€¢ Check the cord periodically for possible damage.
ā€¢ Do not use a damaged iron.
ā€¢ Take it to a Braun Service Center for repair.
ā€¢ Braun electric appliances meet applicable safety standards.
ā€¢ This appliance can only be opened by an authorised Braun Service Centre for repairs.
ā€¢ The cord of this appliance may only be replaced by an authorised Braun Service Centre since
special tools are required.
ā€¢ Faulty, unqualiļ¬ed repair work may cause accidents or injury to the user.
ā€¢ Make sure your voltage corresponds to that printed on the iron. Connect the iron to an alternating
current (~) outlet only.
Table of features
for each model
Feature: Model:
Type: PV 1502
4685 PV 1505
4315 PV 1510
4684 PV 1512
4687
Jet of steam
ā—ā—ā—ā—
Shot of steam
ā— ā—
Extra steam
ā— ā—
Spray
ā—ā—ā—ā—
Speciļ¬cations
Voltage/wattage: See typeplate at the
bottom of the unit.
Water tank capacity: 215 cc (approximately
1 ļ¬lling beaker q
of water ļ¬lled up to the
mark = 1 tank ļ¬lling).
Description
1
Temperature selector
2
Water tank with sliding shutter opening
3
Water spray nozzle
4
Steam regulator / self-cleaning activator
and anti-calc. valve
5
Extra steam button
6
Jet of steam button
7
1- or 2-function button (water-spray/
shot of steam, see Ā«Table of featuresĀ»)
8
Pilot light
9
Swivel cord
j
Heel rest
k
Cord storage/typeplate
l
Transparent water tank
L
Maximum marking (Ā«max.Ā»)
m
Sole plate with 71 steam vents
n
Full-lenght button groove
o
Slim pointed tip
p
Jet of steam outlet
q
Filling beaker
proglide-jet
jet
jet
-jet
max
jet
max
min
sc
jet
max
min
sc
shot
spray
shot
spray
jet
shot
s
e
l
f
c
l
e
a
n
i
n
g
s
e
l
f
c
l
e
a
n
i
n
g
2
3
4
5
7
8
11
9
10
17
12
1
16
15 14
b
e
g h
f
c d
a
6
13
12a
Made in Spain 230 V ~ / 50 - 60 Hz / 1300 W
Type: 4 _ _ _ _ Model: PV 1 _ _ _ _
Saphir-jet
4
Praktical Guidelines
Type of Water to be Used
This iron is designed for tap water. However, if
you have hard water we recommend to use:
ā€“ ļ¬ltered water (household water ļ¬lters that also
de-mineralize water are commercially
available) or
ā€“ a mixture of 1/2 part tap water and 1/2 part
distilled water from drug stores or grocery
stores.
Important: Never use distilled water (battery
water). Do not add any additives (e. g. starch) to
the water.
To ļ¬ll iron
1. Pull the plug out of the wall outlet.
2. Put the steam regulator 4
in position Ā«
ā€¢
Ā»
(= steam oļ¬€).
3. Open sliding shutter 2
.
4. Place the iron in the upright position and ļ¬ll
with water slowly through the tank opening 2
to the Ā«max.Ā» marking L
(a), using the
beaker q
.
5. Close sliding shutter.
Selecting the temperature
Connect the iron to a safely located wall outlet
and select the ironing temperature with the
temperature selector 1
(b). As soon as the pilot
light 8
goes out, the iron has reached the
temperature selected. To avoid water dripping,
always rest the iron upright while heating it up
keep the steam regulator 4
in position Ā«
ā€¢
Ā»
(= steam oļ¬€) (c).
You will usually ļ¬nd the following symbols in your
garments:
The temperature selector 1
is marked with
these symbols:
min. The iron is connected
ā—
Synthetics (acrylic, acetate)
ā—ā—
Silk/rayon/nylon/polyester/
cotton blends/wool
ā—ā—ā—
Cotton/linen
max. Linen
Select the temperature you need according to
these symbols.
Spray, shot of steam, jet of steam
Before you start ironing, we recommend to press
the buttons 3 or 4 times, in order to activate
these functions.
Dry ironing
Set the steam regulator 4
in position Ā«
ā€¢
Ā»
(= steam oļ¬€) (c) for dry ironing. The water
spray 7
may be used at any temperature
setting to dampen the laundry. The jet of steam
6
and the shot of steam 7
buttons can be
activated during dry ironing, provided that the
temperature selector 1
is within the continuous
red area
Steam ironing
(see Ā«Table of featuresĀ»)
Temperature selection: Set the temperature
selector 1
within the red
range steam (b) and wait
until the iron has reached the selected
temperature (i. e. the pilot light 8
goes oļ¬€).
Steam ironing is possible in the entire red range.
Steam ironing at lower temperatures may cause
water drops instead of steam. Should this
happen, turn the steam regulator 4
to the
position Ā«
ā€¢
Ā» (= steam oļ¬€) (c).
Steam regulator 4
:
Select the quantity of
steam required (c) for
each garment with the
steam regulator 4
.
You can increase the
quantity by turning the
steam regulator clock-
wise (wide markings) to the end of the red
marking.
Caution: While ironing do not turn the steam
regulator further, otherwise hot water may
come out from the sole plate (see section
Ā«Decalcifying/Self-cleaningĀ»).
By turning the steam regulator anti-clockwise
you can reduce the quantity of steam or turn the
steam oļ¬€ Ā«
ā€¢
Ā» (= steam oļ¬€) (see Ā«Ironing
GuideĀ»).
Constant steam: Your Braun steam iron is
equipped with a special tank conļ¬guration to
provide constant steam even when the water
level in the tank is low.
Ā«Extra steamĀ»*
(coming from the
steam vents in the sole
plate): For stubborn
creases and wrinkles,
collars and cuļ¬€s.
When ironing within
the red range
area the extra steam function can
be used. You can press the button 5
(d) for 3
seconds at intervals of no less than 7 seconds.
5
Jet of steam*
(coming from the outlets
p
at the slim pointed tip)
o
): Caution: Keep chil-
dren away from the jet of
steam and do not hold
your ļ¬ngers in front of the
outlets p
when activating
this function.
When ironing within the red range
area the jet of steam function 6
can be used (e). To do so, press the button 6
at
intervals of no less than 5 seconds. The jet of
steam has been designed not only for steaming
hard to reach areas like pleats, inside of pockets
etc., but also for steaming hanging clothing (e. g.
velvet skirts, curtains, etc.) (g). The jet of steam
functions between horizontal and upright
positions. Be careful not to touch sensitive
textiles with the hot sole plate.
Shot of steam* (coming
from the vents in the sole
plate): When ironing
within the red
area the shot of
steam function can be
used. It gives an extra,
particular-ly powerful shot
of steam penetrating deep into the textiles in
order to straighten creases, collars and pleats.
The function Ā«shot of steamĀ» can be used in
normal ironing and also vertically for steaming
hanging clothing (e. g. velvet skirts, curtains etc.)
(g). Press the shot of steam button 7
at intervals
of no less than 5 seconds. When steaming be
careful not to touch sensitive textiles with the hot
sole plate.
* If pressed too frequently, it can drip. Should this
happen, wait a few seconds before using it
again.
Spray (coming from the
nozzle 3
): The spray
function can be used at
any temperature, to
dampen laundry. To do
so, press the button 7
(water spray = blue).
Spray / shot of steam
2-function button:
With the models 4684 and
4687 the functions Ā«water
sprayĀ» and Ā«shot of
steamĀ» can be activated
with a 2-function button.
The desired function can
be selected by turning the
button 7
as far as it will
go. The marking (blue =
water spray or red = shot
of steam) must point to
the respective function (f).
Turn the button from blue
(spray) to red (shot of
steam) anti-clockwise
and from red to blue clockwise (f).
Storage
After ironing, always pull the plug out of the wall
outlet. Set the temperature selector 1
to Ā«min.Ā»
(b) and the steam regulator 4
to Ā«
ā€¢
Ā» (= steam
oļ¬€) (c).
To empty the iron hold it with the open water tank
opening 2
downwards (h) and shake it 1 or 2
times. The swivel cord 9
conveniently winds up
around the cord storage k
.
IMPORTANT: Store the cool steam iron in a dry
place and always standing on its heel rest
j
.
The sole plate may be damaged by remaining
water if it is stored horizontally. The warranty
does not cover faults or damage resulting from
improper storage of the iron.
Maintenance and Cleaning
To remove residues of minerals/starch from the
sole plate always use steel wool. Never use a
scouring pad, vinegar or other chemicals. The
steam vents m
and jet of steam outlets p
may
be cleaned manually with a toothpick, if
necessary. Clean the sole plate regularly if you
use starch or other aids on the clothes for
ironing.
Decalcifying / Self-cleaning
Braun irons Saphir-jet have a built-in system
(anti-calc. valve) to prevent calciļ¬cation. It allows
you to clean residues from the steam chamber.
Do not use commercial decalciļ¬ers; they may
damage the sole plate. We recommend to use
the self-cleaning function every 3 months.


Product specificaties

Merk: Braun
Categorie: Strijkijzer
Model: Saphir-Jet PV 1510

Heb je hulp nodig?

Als je hulp nodig hebt met Braun Saphir-Jet PV 1510 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Strijkijzer Braun

Handleiding Strijkijzer

Nieuwste handleidingen voor Strijkijzer