Boss CP-1X Handleiding

Boss Compressor CP-1X

Lees hieronder de 📖 handleiding in het Nederlandse voor Boss CP-1X (1 pagina's) in de categorie Compressor. Deze handleiding was nuttig voor 12 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

Owner’s Manual

Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate sheet). These

sections provide important information concerning the proper operation of the unit.

Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, this manual should be read in its

entirety. The manual should be saved and kept on hand as a convenient reference.

Precautions When Connecting

* To prevent malfunction and equipment failure, always turn

down the volume, and turn o all the units before making any

connections.

* Once the connections have been completed, turn on power

to your various devices in the order specied. By turning on

devices in the wrong order, you risk causing malfunction and/

or damage to speakers and other devices.

When powering up: Turn on the power to your guitar

amp last.

When powering down: Turn o the power to your guitar

amp rst.

* Immediately after the unit is powered-on, the eect is on.

Use of Battery

* A battery was installed in the unit before it left the factory. The

life of this battery may be limited, however, since its primary

purpose was to enable testing.

* If you handle batteries improperly, you risk explosion and uid

leakage. Make sure that you carefully observe all of the items

related to batteries that are listed in “USING THE UNIT SAFELY”

and “IMPORTANT NOTES” (supplied on a separate sheet).

* When operating on battery power only, the unit’s indicator will

become dim when battery power gets too low. Replace the

battery as soon as possible.

* Batteries should always be installed or replaced before

connecting any other devices. This way, you can prevent

malfunction and damage.

* The use of an AC adaptor is recommended as the unit’s power

consumption is relatively high. Should you prefer to use

batteries, please use the alkaline type.

Changing the Battery

1. Hold down the pedal and loosen the thumbscrew, then

open the pedal upward.

* The pedal can be opened without detaching the thumbscrew

completely.

Thumbscrew

Battery Housing

Pedal

Spring Base

Coil Spring

Guide Bush

Hole

Battery Snap

Cord

Battery

Snap

9 V Battery

2. Remove the old battery from the battery housing, and

remove the snap cord connected to it.

3. Connect the snap cord to the new battery, and place

the battery inside the battery housing.

* Be sure to carefully observe the battery’s polarity (+ versus -).

4. Slip the coil spring onto the spring base on the back of

the pedal, and then close the pedal.

* Carefully avoid getting the snap cord caught in the pedal, coil

spring, and battery housing.

5. Finally, insert the thumbscrew into the guide bush

hole and fasten it securely.

Specications

BOSS CP-1X: Compressor

Nominal Input Level -20 dBu

Input Impedance 1 MΩ

Nominal Output Level -20 dBu

Output Impedance 1 kΩ

Recommended Load

Impedance 10 kΩ or greater

Power Supply DC 9 V: Alkaline battery (9 V, 6LR61),

AC Adaptor (sold separately)

Current Draw

90 mA

* Expected battery life under continuous

use:

Alkaline: Approx. 3 hours

These gures will vary depending on

the actual conditions of use.

Dimensions 73 (W) x 129 (D) x 59 (H) mm

2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches

Weight 450 g/1 lb (including battery)

Accessories

Owner’s Manual,

Leaet (“USING THE UNIT SAFELY,”

“IMPORTANT NOTES,” and “Information”),

Alkaline battery (9 V, 6LR61)

Option

(sold separately) AC adaptor (PSA series)

* 0 dBu = 0.775 Vrms

* This document explains the specications of the product at the

time that the document was issued. For the latest information,

refer to the Roland website.

* 5 1 0 0 0 5 3 9 5 1 - 0 2 *

English

Main Features

Panel Descriptions

This is a compressor that utilizes cutting-edge “MDP” digital technology from BOSS to deliver optimal compression and response while perfectly preserving the nuances of your playing.

A gain reduction indicator is provided so that you can see the results of compression.

The internal operating voltage of 18 V means that you can condently connect even high-output guitars to this unit.

* An internal voltage boost circuit is used to provide 18 V operation. As the AC adaptor, you can use the standard PSA adaptor that’s common to the BOSS compact eect series.

OUTPUT jack

Connect this jack to your amp or to the

input of another eect unit.

Pedal switch

This switch turns the eect on/o.

Thumbscrew

When this screw is loosened, the

pedal will open, allowing you to

change the battery.

* For instructions on changing

the battery, refer to

“Changing the Battery.”

AC Adaptor

(PSA series: sold separately)

DC IN jack

Accepts connection of an AC Adaptor (PSA series; sold separately). By using an AC Adaptor, you can

play without being concerned about how much battery power you have left.

* Use only the specied AC adaptor (PSA series; sold separately), and connect it to an AC outlet

of the correct voltage. Do not use any other AC adaptor, since this may cause malfunction.

* If the AC adaptor is connected while a battery is installed, the

power supply is drawn from the AC adaptor.

* We recommend that you keep batteries installed in the unit even

though you’ll be powering it with the AC adaptor. That way, you’ll

be able to continue a performance even if the cord of the AC

adaptor gets accidently disconnected from the unit.

LEVEL knob

Adjusts the output level.

ATTACK knob

Adjusts the strength of the attack when picking.

Turning this knob toward the right allows an attack to be heard for each

individual note even during rapid playing, producing a crisp sound.

Gain Reduction Indicator

Indicates the amount of compression when the compressor is operating.

The greater the compression eect, the larger number of indicators are lit.

RATIO knob

Adjusts the amount of compression (compression ratio) that is applied

to the input signal. Turning this knob toward the right increases the

compression ratio, applying compression more deeply. Turning this knob

toward the left lessens the eect, providing a more natural compression.

Adjusts the signal level at which the compression begins to take eect. As

you turn this knob toward the right, the eect begins to apply at a lower

input signal level.

COMP knob

CHECK indicator

This indicator shows whether the eect is on or o, and also doubles as the battery check

indicator. The indicator lights when the eect is on.

* If you’re powering the unit with a battery and the CHECK indicator goes dim— or

doesn’t light at all—when you try to turn the eect on, the battery is near depletion

and should be replaced. For instructions on changing the battery, refer to “Changing

the Battery.”

* The CHECK indicator shows whether the eect is being applied or not. It does not

indicate whether the power to the device is on or not.

Guitar Amplier

Electric Guitar INPUT jack

This jack accepts signals coming from

a guitar or other musical instrument, or

another eects unit.

* The INPUT jack doubles as the power switch. Power

to the unit is turned on when you plug into the

INPUT jack; the power is turned o when the cable

is unplugged. To prevent unnecessary battery

consumption, be sure to disconnect the plug from

the INPUT jack when not using the eects unit.

Product specificaties

Merk:	Boss
Categorie:	Compressor
Model:	CP-1X
Kleur van het product:	Blauw
Gewicht:	450 g
Breedte:	73 mm
Diepte:	129 mm
Hoogte:	59 mm
Gebruikershandleiding:	Ja
Type stroombron:	AC, Battery
Accu/Batterij voltage:	18 V
Aansluiting voor netstroomadapter:	Ja
Stroomverbruik:	90 mA
Beste gebruik:	Gitaar
Batterijen inbegrepen:	Ja
Type product:	Expressiepedaal
Synchronisatie ingangsimpedantie:	1000000 Ohm
Output impedance:	1000 Ohm