Apc Smart-UPS SRT012 Handleiding

Apc UPS Smart-UPS SRT012

Lees hieronder de 📖 handleiding in het Nederlandse voor Apc Smart-UPS SRT012 (10 pagina's) in de categorie UPS. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/10
Installation Guide Smart-UPSâ„¢On-Line
SRT011/SRT012
Important Safety Information
Read the instructions carefully to become familiar with the equipment before trying to install, operate,
service or maintain it. The following special messages may appear throughout this manual or on the
equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a
procedure.
The addition of this symbol to a Danger or Warning safety label indicates that an electrical hazard
exists which will result in personal injury if the instructions are not followed.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey
all safety messages that follow this symbol to avoid possible injury or death.
Safety and General Information
Inspect the package contents upon receipt. Notify the carrier and dealer if there is any
damage.
Adhere to all local and national electrical codes.
Recycle the packaging.
Deenergizing safety
The UPS contains internal batteries and may present a shock hazard even when disconnected from the
branch circuit (mains). Before installing or servicing the equipment, check that the internal batteries are
removed, that external extended run batteries are disconnected and the branch circuit (mains) is
disconnected.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in minor or
moderate injury.
NOTICE
NOTICE used to address practices not related to physical injury. The safety alert symbol is not
used with this signal word.
Smart-UPS On-Line SRT011/SRT0122
Hardwire safety
• Verify that all branch circuit (mains) and low voltage (control) circuits are deenergized, and locked out
before installing cables or making connections, whether in the junction box or to the UPS.
• Wiring by a qualified electrician is required.
• Adhere to all national and local codes.
• Select wire size and connectors according to national and local codes.
• Strain relief is required for all hardwiring.
• All openings allowing access to UPS hardwiring terminals must be covered. Failure to do so may
result in personal injury or equipment damage.
Smart-UPS On-Line SRT011/SRT012 3
Package Contents
Required tools
Disconnect PDU Connectors
SRT011 - APC Smart-UPS SRT3000 VA PDU, 208 V (3) L6 - 30
PDU 4 Torx screws
1 ground screw
SRT012 - APC Smart-UPS SRT 2200/3000 VA Output HW Kit
Output module Input module 4 Torx screws
1 ground screw
All Models SRT012
Phillips screw driver T20 Torx screw driver Flat head screw driver Wire cutter Wire striper
s uo110 7a
x4
suo1108a
suo1109b
x4


Product specificaties

Merk: Apc
Categorie: UPS
Model: Smart-UPS SRT012

Heb je hulp nodig?

Als je hulp nodig hebt met Apc Smart-UPS SRT012 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding UPS Apc

Handleiding UPS

Nieuwste handleidingen voor UPS