Zanussi ZAF20GX Handleiding

Zanussi Fornuis ZAF20GX

Lees hieronder de 📖 handleiding in het Nederlandse voor Zanussi ZAF20GX (10 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 69 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/10
31
• This appliance has been designed to be operated by
adults and children under supervision. Young children
MUST NOT be allowed to tamper with the controls or
play near or with the oven.
• This appliance has been designed for cooking
edible foodstuff and to be used for domestic non-
professional purposes only. It must not be used for
any other purpose.
• It is dangerous to alter the specification in any way.
• For hygiene and safety reasons, this appliance should
be kept clean at all times. A build-up of fats or other
foodstuff could result in a fire.
• Accessible parts of this appliance may become hot
when it is in use. Children should be KEPT AWAY until
it has cooled.
• Under no circumstances should you attempt to repair
the appliance yourself. Repairs carried out by
unexperienced persons may cause injury or serious
malfunctioning. Refer to your local Zanussi Service
Centre. Always insist on genuine Zanussi spare
parts.
• Ensure that all control knobs are in the OFF position
when not in use.
• Should you connect any electrical tool to a plug near
this cooking appliance, ensure that electric cables
are not in contact with it and keep them far enough
from the heated parts of this appliance.
•If the appliance is out of order, disconnect it from the
electric supply.
These instructions are only for the countries stated by the symbol
printed on the front cover of this instruction book.
This appliance complies with the following
E.E.C. Directives:
- 73/23 - 90/683 (Low Voltage Directive);
- 89/336
(Electromagnetical Compatibility Directive);
-90/396 (Gas Appliances)
- 93/68 (General Directives)
and subsequent modifications.
During Operation About Installation, Cleaning
and Manteinance
• It is mandatory that all operations required for the
installation are carried out by a qualified or competent
person, in accordance with existing rules and
regulations.
• Disconnect the appliance from the electrical supply,
before carrying out any cleaning or manteinance
work.
• Ensure a good ventilation around the appliance. A
poor air supply could cause lack of oxygen.
• Ensure that the gas supply complies with the gas
type stated on the identification label, placed near
the gas supply pipe.
•Using a gas cooking appliance will produce heat
and moisture in the room which it has been
installed in. Ensure a continuous air supply,
keeping the air vents in good conditions or
installing a cooker hood with discharge tube.
•In case of intensive or long time use of the
appliance, make the ventilation more efficient,
by opening a window or increasing the electric
exhaust fan power.
• Once you removed all packaging from the appliance,
ensure that it is not damaged and the electric cable
is in perfect conditions. Otherwise, contact your
dealer before proceeding with the installation.
• The manufacturer disclaims any responsability
should all the safety measures not be carried
out.
ENGLISH
MANUFACTURER:
ELECTROLUX HOME PRODUCTS ITALY S.p.A.
Viale Bologna 298 - 47100 FORLI’ (Italy)
For Your Safety
These warnings are provided in the interest of safety. You MUST read them carefully before
installing or using the appliance.
It is most important that this instruction book should be retained with the appliance for future
reference. Should the appliance be sold or transferred, always ensure that the book is left with
the appliance in order that the new owner can get to know the functions of the appliance and
the relevant warnings.
!
32
1. Instruction for the User
HOB BURNERS CONTROL KNOBS
The hob burners control knobs are situated on the hob
front panel. The symbols on the knobs mean that :
• •
• •
• there is no gas supply
there is maximum gas supply
there is minimum gas supply
LIGHTING THE BURNERS
• For easier lighting, proceed before putting a pan
on the pan support.
Depress the relevant switch marked with a small spark.
Then, push the relevant knob down and turn it anti-
clockwise until it reaches the "maximum" position.
Check the flame is regular and adjust it as required.
If you cannot light the flame even after several attempts,
check the "cap" (Fig. 1, lett. A) and the "crown" (Fig. 1,
lett. B) are in the correct position.
To put the flame out, turn the knob to the symbol ••••
•.
• Always turn the flame down or put it out before
taking the pans off the burner.
USING THE HOB CORRECTLY
To ensure maximum burner efficiency, it is strongly
recommended that you use only pots and pans with a
bottom fitting the size of the burner used, so that flame
will not spread beyond the bottom of the vessel (see the
table beside).
It is also advisable, as soon as a liquid starts boiling, to
turn down the flame so that it will barely keep the liquid
simmering.
• Use only pans or pots with flat bottom.
Carefully supervise cookings with fats or oil,
since these types of foodstuff can result in a fire,
if over-heated.
Burner minimum maximum
diameter diameter
Big (rapid) 160 mm. 240 mm.
Small (Auxiliary) 80 mm. 160 mm.
Fig. 1
Contents
1. Instruction for the User ............ Pag. 32
2. Cleaning and Maintenance ....... Pag. 33
3. Technical Data ........................... Pag. 33
4. Instruction for the Installer ....... Pag. 34
5. Electrical Connection ................ Pag. 35
6. Adaptation to different
types of gas ............................... Pag. 36
7. Building In .................................. Pag. 37
Guarantee................................... Pag. 39
FO 0204
Table of minimum and maximum diameters of
pots which can be placed on the burners
33
3. Technical Data
Gas Burners Rating
Rapid Burner (big) 3 kW (G20-G25) - 2,8 kW (G30-31)
Auxiliary Burner (small) 1 kW
Category II 2E+3+
Setting Natural Gas 20 mbar / G25 25 mbar
Gas connection G 1/2"
Electric Supply 230 V 50 Hz
HOB RECESS DIMENSIONS
Length 270 mm.
Width 490 mm.
2. Cleaning and Maintenance
• Disconnect the appliance from the electrical
supply, before carrying out any cleaning or
manteinance work.
Wash the enamelled components with warm soapy
water. Never use abrasive cleaners
Frequently wash the "caps" and the "crowns" with hot
soapy water, carefully taking away any built-up of food.
Carefully wash the stainless steel components with
water, then wipe them dry with a soft cloth.
The pan supports are dishwasher proof.
If the marks are particularly difficult to remove, use
common non-abrasive cleaners or specific products.
Never use steel wool pads or acids.
In models provided with electric ignition, this feature is
obtained through a ceramic "candle" and a metal
electrode (fig. 1 lett. C). Keep these components well
clean, to avoid difficult lighting, and check that the
burner crown holes (lett. B) are not obstructed.
PERIODIC MAINTENANCE
Periodically ask your local Service Centre to check the
conditions of the gas supply pipe and the pressure
adjuster, if fitted.
To ensure the good operation of the hob and its safety
features, it is necessary that the taps are periodically
lubricated.
• The periodic lubrication of the taps must be
carried out by qualified personnel, which you
must refer to also in case of malfunctioning.
Fig. 2
FO 2110


Product specificaties

Merk: Zanussi
Categorie: Fornuis
Model: ZAF20GX

Heb je hulp nodig?

Als je hulp nodig hebt met Zanussi ZAF20GX stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Fornuis Zanussi

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis