Yamaha Ténéré 700 (2024) Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Yamaha Ténéré 700 (2024) (8 pagina's) in de categorie Motor. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8
C-VS-1600-EXPL-1_INST_7-12.docx
INSTALL INSTRUCTIONS C-VS-1600-EXPL-1
16” VEHICLE SPECIFIC CONSOLE for
2011 - 2015 Retail Model FORD EXPLORER with OEM Center Shifter
TOOLS NEEDED:
Phillips Screw Driver
Standard Socket set
Metric Socket set
Power Drill with Drill Bits
Wire Cutters Wire Crimping tool
T-20 Torx Bit Adjustable Wrench
90° Scribe Small Screw Drivers
QTY DESCRIPTION PART #
1 Main Console Housing
1 Front hump bracket CM004244
1 Front shifter platform (attaches to hump bracket) CM004246
1 Rear mount bracket CM004239
1 Driver side trim panel CM004237
1 Passenger side trim panel CM004236
1 Top / Forward trim bezel CM004248
1 Rear control cover plate CM004317
1 Cup Holder CM001407
2 12 volt sockets CM216560
1 Aux panel adaptor plate (New for 2014) CM005898
1 Hardware kit C-HK-176
C-HK-176 Hardware Kit includes the following
10 1/4” Flat washer GSM31005
6 1/4 x 3/4” Hex head bolt GSM33001
4 1/4 x 1” Hex head bolt GSM33002
8 1/4” serrated nut GSM30023
10 # 8 x 3/8” Torx head screw CM86508
4 8/32 x 1/2” Phillips pan head machine screw GSM33110
2 # 10 x 3/4” Phillips pan sheet metal screw GSM34170
2 # 10 Speed nut GSM30199
4 Female spade connector GSM20224
2 7/8” Plug CM86430
1 3.5” (3-1/2”) diameter O-Ring GSM31331
2 1.875” (1- 7/8”) diameter O-Ring GSM31335
2 #8 X 1/4" Phillips flat sheet metal screw GSM33178
NOTES!
Read all instructions before installing any Havis, Inc. products.
Use hardware provided with install kit.
Console housing is shipped partially pre-assembled to the CM004244 front hump
bracket. Bracket must be unbolted from housing prior to installation.
C-VS-1600-EXPL-1_INST_7-12.docx
C-VS-1600-EXPL-1
(Main Housing Assembly)
CM004239
Rear mount bracket (inside console)
CM004236
Passenger side trim panel
CM004248
Top / Forward Trim Bezel
CM004237 Driver side cover panel
CM004246 Front shifter platform
CM004244 Front hump bracket
CM004317
Rear control cover plate
(not shown)
Main Console Housing
Optional #
CM005159
(Sold
separately)
Top / Forward Trim Bezel
-Allows C-VS-1600-EXPL-1 console to fit into Ford
Interceptor Utility with Standard or Upgrade Interior.
-Converts 16” inches of usable space into 24” inches of
usable space. If using this part, a C-CUP2-I cup holder will
be required if desired. **See Photos on last page**
Also see complete console # C-VS-2400-INUT-1
Adaptor plate for 2014 Ford Retail Explorer.
Adapts the smaller (2014) OEM aux input panel to
fit console forward plate. Adaptor plate with “O”
ring and mount screws included with consoles
MFG after 9/1/13.
Retrofit / Adaptor kit can be purchased separately
if needed. Part # CM005919
CM005919 kit includes – 1 – CM005898, 1 -
GSM31335 and 2 - GSM33178
C-VS-1600-EXPL-1_INST_7-12.docx
Remove one (1) screw holding
top / forward trim bezel.
(7mm socket)
Carefully remove / unsnap trim
bezel and remove terrain
management switch or accessory
pocket. It helps to turn ignition on
and move shift lever knob rearward.
Carefully unsnap shifter boot from
underside of trim bezel.
Unplug Aux input jack and 12 volt
socket. O.E.M. plugs and wiring
will be reused later.
O.E.M. console prior to removal
Lift arm rest and remove (unsnap)
trim piece with 12 volt socket.
Unplug socket.
Carefully unsnap and remove
console side panels
Remove Aux input jack from trim
bezel assembly.
To be reused later.
Remove two (2) screws for rear
storage pocket latch bracket.
(7mm socket)
Remove storage pocket.
Note: There is a sensor attached
to the bottom of pocket that must
be unplugged.
Product specificaties
| Merk: | Yamaha |
| Categorie: | Motor |
| Model: | Ténéré 700 (2024) |
Heb je hulp nodig?
Als je hulp nodig hebt met Yamaha Ténéré 700 (2024) stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Motor Yamaha
26 November 2024
16 November 2024
5 November 2024
5 November 2024
27 Mei 2024
27 Mei 2024
27 Mei 2024
25 Maart 2024
18 Juni 2023
16 Juni 2023
Handleiding Motor
- Motor Aprilia
- Motor Benelli
- Motor BMW
- Motor BodyCraft
- Motor Danfoss
- Motor Derbi
- Motor Ducati
- Motor Elac
- Motor Emco
- Motor Harley Davidson
- Motor Honda
- Motor Husqvarna
- Motor Kawasaki
- Motor Kettler
- Motor KTM
- Motor Mercedes-Benz
- Motor Metabo
- Motor Milwaukee
- Motor Mitsubishi
- Motor Moto Guzzi
- Motor MV Agusta
- Motor Nautilus
- Motor Piaggio
- Motor Reebok
- Motor SMC
- Motor Suzuki
- Motor Texas
- Motor Victory
- Motor Zero
- Motor Joy-it
- Motor Juki
- Motor Mahindra
- Motor Beta
- Motor Triumph
- Motor Hyosung
- Motor TVS
- Motor GasGas
- Motor Indian
- Motor Bajaj
- Motor Mash
- Motor Hero
- Motor Cagiva
- Motor Chang Jiang
- Motor Ridley
- Motor Sherco
- Motor Royal Enfield
- Motor Anova
- Motor CRRCpro
Nieuwste handleidingen voor Motor
2 Februari 2025
8 Januari 2025
8 Januari 2025
27 December 2024
14 December 2024
14 December 2024
14 December 2024
3 December 2024
16 November 2024
15 November 2024