Yamaha NS-10MMF Handleiding

Yamaha Speakers NS-10MMF

Lees hieronder de đź“– handleiding in het Nederlandse voor Yamaha NS-10MMF (5 pagina's) in de categorie Speakers. Deze handleiding was nuttig voor 51 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/5
NS-10MMF
SPEAKER SYSTEM
SYSTEME D’ENCEINTES
OWNER’S MANUAL
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
G R
NS-10MMT PRE(02.8.20)a 02.8.28, 11:39 AM1
E-2
Read this before using the speaker.
â—Ź
To assure the finest performance, please read this manual
carefully. Keep it in a safe place for future reference.
â—Ź
Install the speaker in a cool, dry, clean place – away from
windows, heat sources, sources of excessive vibration,
dust, moisture and cold. Avoid sources of humming
(transformers, motors). To prevent fire or electrical shock,
do not expose the speaker to rain or water.
â—ŹTo prevent the enclosure from warping or discoloring, do
not place the speaker where it will be exposed to direct
sunlight or excessive humidity.
â—ŹDo not place the following objects on the speaker:
Glass, china, etc.
If glass etc. falls by vibrations and breaks, it may cause
personal injury.
A burning candle etc.
If the candle falls by vibrations, it may cause fire and
personal injury.
A vessel with water in it
If the vessel falls by vibrations and water spills, it may
cause damage to the speaker, and/or you may get an
electric shock.
â—ŹDo not place the speaker where foreign objects such as
water drips might fall. It might cause a fire, damage to
the speaker, and/or personal injury.
â—ŹDo not place the speaker where it is liable to be knocked
over or struck by falling objects. Stable placement will
also ensure better sound performance.
PRECAUTIONS
The speaker is constructed with the majority of the weight
located in its upper portion, and is thus susceptible to falling
over if proper care is not taken to insure its stability. If the
speaker falls over, it may damage the speaker or be the
cause of injury (or even death) to persons and/or damage to
personal property.
For safe and proper use of the speaker:
• Position the speaker in a location that is solid, level,
smooth, and low (with respect to the floor).
• Do not push or apply pressure to the side of the speaker
when moving, or lean objects against the side of the
speaker.
• Do not sit on or set objects on top of the speaker.
Vibrations or jolts associated with earthquakes and other
phenomena or activities may cause the speaker to fall over.
For safety reasons, using commercially available products
that increase stability in the speaker is recommended
(metal fittings or chains, etc.).
PRECAUTIONS WHEN POSITIONING THE SPEAKERS
Thank you for selecting this YAMAHA NS-10MMF speaker system.
â—ŹPlacing the speaker on the same shelf or rack as the
turntable can result in feedback.
â—ŹNever put a hand or a foreign object into the port located
on the rear of the speaker as this might cause personal
injury and/or damage to the speaker.
â—ŹWhen moving the speaker, do not hold the port as it
might cause personal injury and/or damage to the
speaker.
â—ŹAny time you note distortion, reduce the volume control
on your amplifier to a lower setting. Never allow your
amplifier to be driven into “clipping”. Otherwise the
speaker may be damaged.
â—Ź
When using an amplifier with a rated output power higher
than the nominal input power of the speaker, care should
be taken never to exceed the speaker’s maximum input.
â—Ź
Do not attempt to clean the speaker with chemical solvents
as this might damage the finish. Use a clean, dry cloth.
â—ŹDo not attempt to modify or fix the speaker. Contact
qualified YAMAHA service personnel when any service
is needed. The cabinet should never be opened for any
reasons.
●Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused
by improper placement or installation of the speaker.
E-1
NS-10MMF-Eng-B 02.8.28, 11:39 AM2
English
E-3
SPEAKERS
L
R
+
+
––
1
3
4
Before making connections, make sure that the
amplifier is switched off.
â– CONNECTIONS
•Connect the screw-type input terminals at the rear of the
speakers to the speaker output terminals of the amplifier
(or receiver) with the speaker cable.
•One side of the speaker cable is red and the other side is
black. Connect the (+) terminals on the amplifier (or
receiver) and speakers using the red side. Connect the
(–) terminals on both components using the black side of
the cable.
•Connect one speaker to the left (marked L) terminals of
your amplifier, and another speaker to the right (marked
R) terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed polarity,
the sound will be unnatural and lack bass.
How to Connect:
1Loosen the knob.
2Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
3Insert the bare wire.
4Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Speaker (R) Speaker (L)
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
When using a banana plug
<General model only>
1Remove the cover by pulling it toward you.
2Tighten the terminal knob.
3Simply insert the banana plug into the terminal.
â–  Using the non-skid pads
Put the provided non-skid pads at the four corners on the
bottom of speaker to prevent the speaker from moving by
vibrations etc.
Black
Red Red
Speaker output
terminals of the
amplifier (or
receiver)
CONNECTIONS TO YOUR AMPLIFIER
Non-skid
pad
2
3
Banana plug
1
Amplifier or
Receiver
Black Black
E-2
NS-10MMF-Eng-B 02.8.28, 11:39 AM3


Product specificaties

Merk: Yamaha
Categorie: Speakers
Model: NS-10MMF

Heb je hulp nodig?

Als je hulp nodig hebt met Yamaha NS-10MMF stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speakers Yamaha

Handleiding Speakers

Nieuwste handleidingen voor Speakers