Yamaha AI8 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Yamaha AI8 (8 pagina's) in de categorie Geluid. Deze handleiding was nuttig voor 67 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8
MIC/LINE INPUT UNIT
ANALOG INPUT BOX
-ML8AB
MIC/LINE INPUT UNIT -ML8F
AD UNIT -AD8
Owner’s Manual
E
U.R.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation
© 2003 Yamaha Corporation
WC62520 707IPAPx.x-0xB0
Printed in Japan
2
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC
requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST
be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with
these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with
other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may
cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all
installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the
problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on
different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in
is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer
authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service
Division, 6600 Orangethorpe Ave, Buena Park, CA 90620
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
WARNING: THIS APPARATUS MUST BE EARTHED
IMPORTANT
THE WIRES IN THIS MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
GREEN-AND-YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN and YELLOW must be
connected to the terminal in the plug which is marked by the letter E
or by the safety earth symbol or coloured GREEN and YELLOW.
The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the
terminal which is marked with the letter L or coloured RED.
* This applies only to products distributed by YAMAHA KEMBLE
MUSIC (U.K.) LTD.
3
■ Precautions
• Do not place a container with liquid or small metal
objects on top of this unit. Liquid or metal objects
inside this unit are a fire and electrical shock hazard.
• Do not allow water to enter this unit or allow the unit
to become wet. Fire or electrical shock may result.
• Connect this unit’s power cord only to an AC outlet of
the type stated in this Owner’s Manual or as marked
on the unit. Failure to do so is a fire and electrical
shock hazard.
• Be sure to connect to an appropriate outlet with a pro-
tective grounding connection. Improper grounding
can result in electrical shock.
• Do not scratch, bend, twist, pull, or heat the power
cord. A damaged power cord is a fire and electrical
shock hazard.
• Do not place heavy objects, including this unit, on top
of the power cord. A damaged power cord is a fire and
electrical shock hazard. In particular, be careful not to
place heavy objects on a power cord covered by a car-
pet.
• If you notice any abnormality, such as smoke, odor, or
noise, or if a foreign object or liquid gets inside the
unit, turn it off immediately. Remove the power cord
from the AC outlet. Consult your dealer for repair.
Using the unit in this condition is a fire and electrical
shock hazard.
• Should this unit/AC adapter/power supply be
dropped or the cabinet be damaged, turn the power
switch off, remove the power plug from the AC outlet,
and contact your dealer. If you continue using the unit
without heeding this instruction, fire or electrical
shock may result.
• If the power cord is damaged (i.e., cut or a bare wire is
exposed), ask your dealer for a replacement. Using the
unit with a damaged power cord is a fire and electrical
shock hazard.
• Do not remove the unit’s cover. You could receive an
electrical shock. If you think internal inspection,
maintenance, or repair is necessary, contact your
dealer.
• Do not modify the unit. Doing so is a fire and electri-
cal shock hazard.
• When setting up the product, make sure that the AC
outlet you are using is easily accessible. If some trou-
ble or malfunction occurs, immediately turn off the
power switch and disconnect the plug from the outlet.
Even when the power switch is turned off, electricity is
still flowing to the product at the minimum level.
When you are not using the product for a long time,
make sure to unplug the power cord from the wall AC
outlet.
• When rack-mounting the unit, allow enough free
space around the unit for normal ventilation. This
should be: 10 cm at the sides, 15 cm behind, and 30
cm above.
• For normal ventilation during use, remove the rear of
the rack or open a ventilation hole.
• If the airflow is not adequate, the unit will heat up
inside and may cause a fire.
• This unit has ventilation holes at the top, bottom, and
rear to prevent the internal temperature rising too
high. Do not block them. Blocked ventilation holes
are a fire hazard.
• Hold the power cord plug when disconnecting it from
an AC outlet. Never pull the cord. A damaged power
cord is a potential fire and electrical shock hazard.
• Do not touch the power plug with wet hands. Doing
so is a potential electrical shock hazard.
• The digital circuits of this unit may induce a slight
noise into nearby radios and TVs. If noise occurs,
relocate the affected equipment.
• XLR-type connectors are wired as follows: pin 1:
ground, pin 2: hot (+), and pin 3: cold (–).
Rack Mounting Caution
If the unit is rack mounted and transported regularly,
for example, when on a tour, we recommend that the
rear of the unit be supported by fitting a pair metal
brackets, one each side. The following drawing pro-
vides the information necessary to make such brack-
ets.
Note that only one bracket is shown here and the
bracket for the other side must be bent in the opposite
direction.
86.5
20.5
3.1
4- ø6.5
2-R2
R2
2-R2
R5
t = 1.6
(82.1)
76.2
44.45
31.75
5.9
0
36.5
14.5
7.5
8
0
12
134
200
0
Product specificaties
| Merk: | Yamaha |
| Categorie: | Geluid |
| Model: | AI8 |
Heb je hulp nodig?
Als je hulp nodig hebt met Yamaha AI8 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Geluid Yamaha
16 Augustus 2022
16 Augustus 2022
22 November 2021
15 Augustus 2022
2 Mei 2022
16 Augustus 2022
17 Augustus 2022
16 Augustus 2022
17 Augustus 2022
3 April 2022
Handleiding Geluid
- Geluid Philips
- Geluid Sony
- Geluid JBL
- Geluid Kenwood
- Geluid Motorola
- Geluid Nokia
- Geluid Olympus
- Geluid Onkyo
- Geluid Siemens
- Geluid Topcom
- Geluid Advance Acoustic
- Geluid Advanced Bionics
- Geluid Akg
- Geluid Aliph
- Geluid Alto Professional
- Geluid Amplicom
- Geluid Bang Olufsen
- Geluid Behringer
- Geluid Bellman
- Geluid Bellman Symfon
- Geluid Bluetrek
- Geluid Bose
- Geluid DAP Audio
- Geluid Datel
- Geluid Envivo
- Geluid Fender
- Geluid Fiio
- Geluid Focusrite
- Geluid Gear4
- Geluid Geemarc
- Geluid Gigabyte
- Geluid Gioteck
- Geluid Griffin
- Geluid HUMANTECHNIK
- Geluid Inakustik
- Geluid Ion
- Geluid Iqua
- Geluid Konig Electronic
- Geluid Korg
- Geluid Logitech
- Geluid MCS
- Geluid Mr Handsfree
- Geluid Native
- Geluid Nec
- Geluid Nxzen
- Geluid Phonak
- Geluid Plawa
- Geluid Plextor
- Geluid Power Dynamics
- Geluid Profoon
- Geluid Reflecta
- Geluid Roland
- Geluid Samson
- Geluid Sennheiser
- Geluid Sony Ericsson
- Geluid Speedlink
- Geluid Starkey
- Geluid Sweex
- Geluid T-Mobile
- Geluid TC Helicon
- Geluid Timewave
- Geluid Trust
- Geluid Velleman
- Geluid Velodyne
- Geluid Xqisit
- Geluid Zoom
- Geluid Jabra
- Geluid Cardo
Nieuwste handleidingen voor Geluid
2 Oktober 2023
2 Oktober 2023
2 Oktober 2023
2 Oktober 2023
2 Oktober 2023
2 Oktober 2023
2 Oktober 2023
2 Oktober 2023
2 Oktober 2023
2 Oktober 2023