Westland SW 12 Handleiding

Westland Niet gecategoriseerd SW 12

Lees hieronder de 📖 handleiding in het Nederlandse voor Westland SW 12 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 13 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

Step 1: Push Bar

• Fit the push rods into the spreader tank (Fig.2)

• Fit the push bar on to the push rods (Fig.3)

Step 2: Adjustment lever

• Fit the adjustment lever grip (Fig.1/ Item 2)

to the adjustment lever (Fig.4/ Item A).

Setup Guide:

Lawn Spreader Instructions

Layout

1. Push bar

2. Adjustment lever for setting the spreading volume

3. Spreader tank

4. Wheel

5. Stand

6. Push rods

Step 4: Wheels

• Take the wheel caps off the wheels (Fig.7)

• Remove the screws (Fig.8/ Item E) (on

both sides).

• Attach the wheels (Fig.9/ Item D) and

secure them.

• Fit the wheel caps.

Step 3: Foot

• Remove the screw (Fig.5/ Item B)

• Insert the foot (Fig.6/ Item 5) and secure it.

2 3

7 8

44 5

6 1

C D

E E D

102077 A4 Lawn Spreader 20/2/09 09:54 Page 1

1. MEASURE YOUR LAWN AREA

Measure the length and breadth of the lawn. Multiply the measurements together to get the area you need to

treat (For example 10 metres x 10 metres = 100m

2).

2. PREPARING YOUR SPREADER FOR USE

• Always read the product label before use.

• DO NOT fill the Lawn Spreader on the lawn.

• Ensure hopper is dry and applicator outlets are clear of obstruction.

• Set the distribution lever to zero.

• Carefully pour product into Lawn Spreader ensuring an even spread across the hopper.

• To ensure that the Lawn Spreader distributes the lawn treatment product at the recommended rate it is

essential that the hopper is filled above the black plastic plate at all times.

• DO NOT apply if grass is wet/damp and longer than 60-70mm as lawn treatment product may become damp,

blocking the Lawn Spreader and may result in over or under-dosing of product.

3. USING YOUR SPREADER

1. Before inserting the appropriate Westland lawn product, always set the adjustable lever to zero.

2. Do not fill the spreader on the lawn. Place the spreader on a sheet of newspaper or plastic to avoid spillage on

paths/patios.

3. Set calibration lever on top of the hopper to appropriate setting to start applying the

product. It is important to start walking immediately after the lever is set as the product

will start discharging from the spreader. The recommended settings for Westland product

with an application rate of 35g/m2

0 =Off

3 =Aftercut Lawn Feed & Conditioner, Lawn Feed Weed Moss Killer*,

Autumn Lawn Feed & Moss Killer**

4. It is recommended to treat 2/3 stripes of lawn alongside fences and hedges to avoid

having to make difficult manoeuvres along these perimeters. This will allow you to treat

the rest of the lawn in stripes (Fig.1).

5. Walk at a steady pace up and down the lawn, slightly overlapping the edges to prevent

stripes until you have covered the required distance (Fig.2).

6. If rain does not fall within 48 hours, it is best to water the lawn thoroughly.

7. The lawn is safe for use by children and pets once the product has been watered in.

4. AFTER USE

• NEVER leave product sitting in the hopper. Move the spreader off the lawn and pour

leftover product back into the original container, seal tightly and store in a safe, dry place.

• Clean hopper thoroughly using a stiff bristled brush. Open the distribution lever to setting

10 and remove all residues, particularly around the axle.

• DO NOT allow any cleanings to enter drains. Clean up residues and dispose of safely.

• Store the clean, dry Lawn Spreader under cover ready for next use.

*Westland Lawn Feed Weed & Moss Killer MAPP 10794 contains 2,4-D, mecoprop-P and ferrous sulphate.

**Westland Autumn Lawn Feed & Moss Killer MAPP 11023 contains ferrous sulphate. Always read the label. Use pesticides safely.

Application Advice

For further information on the Westland range of products please contact our Customer Care Department or visit www.gardenhealth.com

Customer Care Department, Westland Horticulture Limited, 14 Granville Industrial Estate, Granville Road, Dungannon, Co. Tyrone, BT70 1NJ.

UK Tel: 08700 663 566 ROI Tel: 1800 927 927

Guide To Using Lawn Spreader

To get the best results from your Lawn Spreader

read all instructions and advice before use

Complete two circuits of the

lawn. Continue treating

remaining lawn in straight strips

off the longest side.

For correct bout spacing line up

arrow on hopper with previous

wheeling mark.

Fig.1

Fig.2

102077 A4 Lawn Spreader 20/2/09 09:54 Page 2

Product specificaties

Merk:	Westland
Categorie:	Niet gecategoriseerd
Model:	SW 12

Heb je hulp nodig?

Als je hulp nodig hebt met Westland SW 12 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Westland

Westland SW 12 Handleiding

4 Mei 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Axler Hammerhead Pro Follow Focus Handleiding

19 December 2024

Axler Hammerhead Follow Focus Handleiding

19 December 2024

Cosatto Giggle 4 Handleiding

19 December 2024

Yamazen LCR-80-FSET Handleiding

19 December 2024

Asus EBS-P300 Handleiding

18 December 2024

QSC AcousticDesign AD-C245C Handleiding

18 December 2024

Asus ZenWiFi ET9 Handleiding

18 December 2024

Asus NUC 12 Extreme Compute Element Handleiding

18 December 2024

Asus NUC 11 Extreme Kit Handleiding

18 December 2024

Asus NUC 12 Pro X Kit Handleiding

18 December 2024