WestBend 72002 Handleiding

WestBend Niet gecategoriseerd 72002

Lees hieronder de 📖 handleiding in het Nederlandse voor WestBend 72002 (13 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/13

WEST BEND®

ELECTRICAL SKILLET

Model No. 72000 through 72700

RECIPES AND INSTRUCTIONS

TO PREVENT PERSONAL INJURY OR PROPERTY DAMAGE, READ AND FOLLOW THE

INSTRUCTIONS AND WARNINGS IN THIS CARE AND USE INSTRUCTION MANUAL.

IMPORTANT SAFEGUARDS

Use electricity safely and wisely! Observe safety precautions when using your skillet including the following:

• Read all instructions before using.

• If the skillet features unassembled cover rest, knob or handle/legs, be sure they are assembled and fastened properly. See assembly

instructions later in this booklet.

• Always attach heat control to skillet first, then plug cord into wall outlet. After cooking and serving, turn heat control to “off” and

unplug from wall outlet. Let skillet cool before removing heat control. Do not leave skillet plugged in when not being used.

• Skillet should always be unplugged before cleaning.

• Do not let cord touch hot surfaces or hang over the edge of counter, table or other surface area.

• Your skillet and its heat control should not be used outdoors, placed near a hot gas or electric burner or placed in a heated oven.

• Do not immerse heat control, its cord and plug in water or other liquid.

• Do not touch skillet or its cover when they are hot. Use handles and knobs for lifting and carrying. Be very careful when moving skillet

if it contains hot liquid. Let cool before pouring out.

• Supervise closely when skillet is being used by or near children.

• Use your skillet only for cooking tasks described in this booklet. Do not use attachments with your skillet unless recommended by The

West Bend Company.

• Do not use your skillet if it or its cord or heat control has been damaged or if it is not working properly. Return your skillet, if it is

within the warranty period, to the West Bend Company for examination and/or repair.

SAVE THESE INSTRUCTIONS

Your skillet needs no special care other than cleaning. If servicing becomes necessary, within the warranty period, return your skillet to The

West Bend Company. See Warranty information for details. Do not attempt to repair it yourself.

WARNING: To prevent personal injury or property damage caused by fire, always unplug this and other appliances when not in use.

WARNING: This appliance may contain substances know to the State of California to cause cancer, birth defects or other reproductive

harm. FOR HOUSEHOLD USE ONLY

This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one

way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to

defeat this safety feature.

SPECIAL NOTE: This booklet contains instructions for electric skillets with different styles of covers and made of different materials such

as metal or glass. These different covers require special care and handling. Be sure to follow the correct care and handling instructions for

your particular skillet cover.

INSTRUCTIONS FOR CARE AND USE

• Clean Before Using

CAUTION: To prevent personal injury or electric shock, always remove heat control before immersing this product in water. Do not

immerse the heat control, its cord and plug in water or other liquid.

Wash skillet, cover, rack if included, in hot soapy water with a sponge or dishcloth to remove any manufacturing oils. Rinse thoroughly and

dry.

• Condition the Non-Stick Interior Surface

The non-stick surface must be conditioned to ensure stick-free cooking. Lightly wipe a teaspoon of cooking oil with paper toweling or

soft cloth over the entire surface. The skillet is now ready to use.

• Assemble Cover Knob or Strap Handle on Metal Cover.

Metal skillet cover will feature a knob or strap type handle which must be assembled before use. Follow directions below for assembly:

• Assemble Cover Knob

Parts Included: Tools Required:

Cover Knob Common Phillips Screwdriver

Phillips Screw

1. Remove screw form bottom of cover knob. Attach knob to cover with screw as shown in Diagram 1. Tighten with screwdriver

until secured, but do not over-tighten to prevent stripping of threads. Do not use cover without cover knob attached. See Diagram

below.

• Assemble Strap Handle

Parts Included: Tools Required:

Strap Handle Common Slotted Screwdriver

2 Slotted Screws

1. Remove handle and screws for plastic bag. Attached handle to cover with screws as shown in Diagram 2. Tighten with

screwdriver until secured, but do not over-tighten to prevent stripping of threads. Do not use cover without handles attached. See

Diagram 2.

• Assemble Handle/Leg Before Using (unassembled models only).

CAUTION: To prevent personal injury or property damage, be sure handles are securely attached before use. Never use skillet without

attached handle/legs. Make sure that screws are inserted straight into skillet mounting projections for proper assembly. To prevent stripping

of threads, do not over-tighten.

Parts Included:

2 Handle/Legs

4 Long Handle/Leg Screws

2 Leveling Washers

Tools Required:

Common Slotted Screwdriver

Handle/Leg Assembly:

1. Place the skillet upside down on tabletop or countertop.

2. Position one handle/leg on side of skillet with socket, lining up holes in handle with mounting projections on skillet. See Diagram

below.

3. Using appropriate screwdriver, securely attach handle with the screws provided (2 long screws per handle). See Diagram above.

Repeat steps 1 and 2 to assemble the second handle on the opposite side of the skillet.

4. To assure proper installation of skillet handles, place assembled unit right side up on a flat surface and lift item with handles.

Handles should feel tightly secured.

5. If the skillet rocks when place on a flat surface, remove screw on the leg which is not resting on the surface. Install one of the

enclosed washers between the skillet mounting projection and the handle. Replace the screw following the instructions 3 and 4

above. If the skillet is not level after the addition of the washer, add the second leveling washer in the same manner as the first.

SPECIAL SAFEGUARDS FOR GLASS COVER

CAUTION: Failure to follow these instructions may cause immediate or later breakage of glass cover, which can result in personal injury or

property damage. Carefully read and follow the safeguards below:

CAUTION: Glass cover can shatter from direct heat.

• DO NOT place cover under broiler, microwave browning element or in a toaster oven.

• DO NOT set glass cover on hot burner or on oven heat vent

• DO NOT use cover if it has been used in the above manners even if it does not look damaged. See warranty section in this booklet on

how to obtain a replacement cover.

•

CAUTION: Glass cover can shatter if cooled suddenly. Avoid sever temperature change.

• DO NOT take cover directly from freezer to oven.

• DO NOT set hot glass cover on cold wet surface; let cover cool before placing in water.

• ALWAYS handle hot cover with dry pot holders or oven mitts; do not use wet cloths.

• ALWAYS set hot glass cover on dry, heat-protective surface for gradual cooling.

CAUTION: Chips, cracks or deep scratches weaken the glass cover. Weakened glass can shatter during use.

• DO NOT use cover if chipped, cracked or scratched. Discard immediately. See Warranty section in this booklet on how to obtain a

replacement cover.

• ALWAYS follow care and use instructions in this booklet to avoid chip, cracks and scratches due to hitting rims, using metal utensils,

using abrasive scouring pads or cleaners or accidental impact.

CAUTION: To prevent personal injury or steam burns when removing cover from skillet base:

• ALWAYS use both hands when removing or replacing the glass cover.

• ALWAYS use pot holders or oven mitts when removing glass cover from skillet or when replacing it.

• ALWAYS tilt cover toward you to prevent steam burns. See Diagram 4.

COOKING INSTRUCTIONS

• Operating the Skillet

1. Always use skillet on a dry, level, heat resistant surface. Be sure your hands are dry.

2. Attach heat control to skillet, making sure it is sat at “OFF”. Plug cord into 120 volt, AC electrical outlet ONLY.

CAUTION: To prevent personal injury or property damage, inspect cordset for damage or wear before each use. Do not use your product if

it or its cord has been damaged or if it is not working properly.

CAUTION: Your skillet has a short cord as a safety precaution to prevent personal injury or property damage resulting from pulling,

tripping or becoming entangled with the cord. Do not allow children to be near or use this skillet without close adult supervision. If you must

use a longer cordset or an extension cord when using your skillet, the cord must be arranged so it will not drape or hang over the edge of a

countertop, tabletop or surface area where it can be pulled on by children or tripped over. To prevent electric shock, personal injury or fire,

the electrical rating of the extension cord you use must be the same or more than the wattage of the skillet (wattage is stamped on the

underside of skillet).

3. Preheat skillet, uncovered, for 2 to 4 minutes until desired temperature is reached, unless recipe states not to preheat. Signal light

on heat control will be on while skillet is heating.

4. Refer to the Temperature Guide in this booklet for selecting the correct heat setting. (If food is frozen, use heat setting as indicated

but allow longer cooking time.)

5. When signal light on the heat control goes out indicating that the cooking temperature was reached, add the food. Heat may be

increased or decreased, depending on personal preference and type or amount of food being prepared. The signal light will go on

and off during cooking to indicate that proper temperature is being maintained.

ALWAYS USE POT HOLDER OR OVEN MITTS WHEN HANDLING COVER AS HANDLES BECOME HOT.

6. At the end of the cooking period, set the heat control to WARM for serving or at OFF if food is to be removed immediately from

skillet. After dial is set at OFF, unplug cord from wall outlet. Invert glass cover and use as a serving dish if desired.

Product specificaties

Merk:	WestBend
Categorie:	Niet gecategoriseerd
Model:	72002

Heb je hulp nodig?

Als je hulp nodig hebt met WestBend 72002 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd WestBend

WestBend Hershey's S'mores Maker 6203 Handleiding

13 Maart 2024

WestBend Cocoa Grande CL400BG Handleiding

13 Maart 2024

WestBend Food Strainer & Sauce Maker 220 Handleiding

13 Maart 2024

WestBend Stir Crazy Deluxe 82310CF Handleiding

12 Maart 2024

WestBend Waterbath Canner 35C Handleiding

12 Maart 2024

WestBend Hot Pot 53015 Handleiding

12 Maart 2024

WestBend Cocoa Latte 65032 Handleiding

12 Maart 2024

WestBend Grain Mill 555 Handleiding

12 Maart 2024

WestBend Cherry Stoner 63 Handleiding

12 Maart 2024

WestBend New Stir Crazy 82505 Handleiding

12 Maart 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Panasonic NB-W250 Handleiding

25 November 2024

Alpine CHM-S611 Handleiding

25 November 2024

AOpen DE3650-C Handleiding

25 November 2024

Lazer Urbanize MIPS Handleiding

25 November 2024

Symmons Dia 353GB-24 Handleiding

25 November 2024

SoundTube IPD-RS62-EZ Handleiding

25 November 2024

Moen Camerist 4905 Handleiding

25 November 2024

Lazer Cameleon DLX Handleiding

25 November 2024

DMT DLD-85 Handleiding

25 November 2024

AOpen AM1120T Handleiding

25 November 2024