Viper AS5160T Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Viper AS5160T (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 156 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Use and maintenance
Operating guidelines AS5160 series
July 2018
Turn on the key and verify
there is enough battery power
to complete the work. Charge
batteries if required.
Install the squeegee using
the thumb nuts. Attach
squeegee hose.
Remove the red cover and fill
the tank. Add appropriate low
foaming detergent. Maximum
tank capacity 16 Gallons / 61
liter.
Check the level of water with
the red ball on the left side of
the machine.
Disc version: place the brush/pad holder under the scrub deck then use the pedal to lower the deck over the
brush. Press the OneTouchTM scrub button to enable scrubbing.
The vacuum will start. Push on one of the two switches ½ second to install the brush.
Boost version: attach a pad to the fixed pad holder, press the OneTouch TM scrub button and the deck will
lower auto matically.
Use the handle to lower or
raise the squeegee to the
floor. Adjust the squeegee
angle with the knob to adjust
suction performance if
needed.
Place the machine in working mode and
press any of the two red safety switches to
activate the machine.
Press the + or – solution buttons to
increase / decrease the water flow rate
or to turn solution off.
For wheel traction version: use the rabbit /
turtle knob to control the speed of the
machine.
BOOST version: Adjust scrub pressure when
needed.
For wheel traction version: pressing either
of the red safety switches and the black
reverse button together will put the
machine into reverse.
On disc version, the brush/pad holder can
be removed automatically by raising the
deck with the pedal and then press the click
off button.
Push
on the
button
Maintenance
Operating guidelines AS5160 series
July 2018
When scrubbing is complete,
turn off the key to perform
the following maintenance.
Daily: Empty the clean water
tank using the solution tank
drain knob under the
machine.
Daily: Empty the recovery
tank using the recovery
empty hose. Bend the soft part
before removing the cap to
control the flow.
Daily: Inspect and rinse the
float ball cage and inspect
and clean the lid gasket if
required.
Local Viper dealer:
Phone number:
SN:
Daily: Remove the squeegee, and clean.
Inspect the blades and flip them or replace
them if required.
Daily: to charge the battery, use the sup-
plied AC cord to the on board charger and
connect it to the machine and wall socket.
Weekly: Inspect the solution filter and
clean if required.
Daily: if the battery indicator shows red, put the machine on charge. Battery should
be on charge if empty, not in use or if not being used for coming 8-10 hours.
Daily: Leave the recovery tank lid open
after it’s been cleaned to avoid bad odor.


Product specificaties

Merk: Viper
Categorie: Niet gecategoriseerd
Model: AS5160T

Heb je hulp nodig?

Als je hulp nodig hebt met Viper AS5160T stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Viper

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd