Viking K-1270-EWP Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Viking K-1270-EWP (12 pagina's) in de categorie Toegangscontrolesysteem. Deze handleiding was nuttig voor 16 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
PRODUCT MANUAL
Designed, Manufactured and Supported in the USA
S E C U R I T Y & C O M M U N I C A T I O N
Features
The Entry Phone is a two-way, handsfree K-1270
telephone with 12 buttons for calling individual
residences in an apartment building with an
integrated 125 KHz Proximity Card Reader. The
rugged stainless steel faceplate has a printed
directory housed in a waterproof, scratch-resistant
lens. Each button is beside the tenants name in the
directory so there are no confusing codes to deal
with. Calling a particular tenant is as easy as
pressing a single button. The K-1270 has a built in
speed dialer that can handle up to 12 primary
phone numbers, each with 22 digits. If there is no
answer at the first number, a second number can
be called automatically. Once the tenant answers
their phone, a single touch tone command can
activate the door strike relay. For “no phone line”
applications, the is compatible with theK-1270
C-3000 no CO (phone line) controller.
The K-1270-EWP shares all of the features of the
K-1270 in addition to Enhanced Weather
Protection (EWP) for outdoor installations where
the unit is exposed to precipitation or
condensation. EWP products feature foam rubber
• Built-in 125KHz 26-bit Wiegand proximity card reader with LED,
beep card read confirmation, and EWP board protection
• Compatible with the following Viking Proximity Cards and Fobs:
PRX-C PRX-C-ISO PRX-FOB (DOD# 198) , and
• Vandal Resistant Features: 14 gauge louvered 316 stainless
steel faceplate with permanent laser etched graphics, heavy duty
metal keypad and T-10 Torx Security mounting screws.
• Marine grade 316 stainless steel Weather Resistant Features:
faceplate and screws. Internally sealed keypad. Mylar speaker.
Self-draining mic mount. Faceplate, keypad, mic and speaker
gaskets.
• Designed to meet IP66 Ingress Protection Rating (see ) DOD 859
• Operates on 12 to 24 volts AC/DC
• 12 speed dial buttons (22 digits each)
• 12 alternate number positions (22 digits each)
• One button operation (no call button)
• Hang up on CPC, busy, silence, time-out or dial tone
• Touch tone restriction from microphone
• Integral relays for camera control and door strike
• Works with for increased security C-1000B
• Works with for “No CO” (phone line) operation C-3000
• 50 keyless entry codes
• See model for integral camera K-1205
• Postal lock input
• Optional surface mount box, sold separately ( )VE-5x10 DOD 424
• Small apartment buildings
• Professional buildings
• Gated communities
Power: 12 to 24 Volts AC or DC, 12VDC adapter provided
Proximity Card Reader Power: 5 to 14V DC @ 60mA maximum
Note: To assure operation during a power outage, a UPS
should be used.
Dimensions: 127mm x 254mm x 63.5mm (5" x 10" x 2.5")
Shipping weight: 2.2 kg (4.8 lbs.)
Standard K-1270 Environment: -34° C to 65° C (-30° F
to 150° F) with 5% to 95% non-condensing humidity
K-1270-EWP Environment: -34° C to 65° C (-30° F to
150° F) with up to 100% condensing humidity
Relay Contact Rating:
Door Strike: 5A @ 30VDC/250VAC maximum
Camera: 0.5A @ 125 VAC, 1.0A @ 30VDC
Connections: (16) gel-filled butt connectors (3M
Scotchlok UR2)
Applications
Specifications
www.vikingelectronics.com
Information: (715) 386-8861
VIKING
gaskets and boots, sealed connections, gel-filled
butt connectors, as well as urethane or thermal
plastic potted circuit boards with internally sealed,
field-adjustable trim pots and DIP switches for easy
on-site programming.
12 Button Apartment Entry Phone with Built-In
Door Strike Relay and Proximity Card Reader
“Brushed 316 Stainless Steel”
(similar to brushed nickel)
K-1270 Series
Entry Phones with Keypads
and Proximity Card Readers
July 5, 2017
(shown in optional
VE-5x10-SS, not included)
Power: 5 to 14V DC @ 60mA maximum
Maximum Cable Length: 500 ft 24 Awg stranded shielded
(Belden 9537)
Frequency: 125KHz
Format: 26 bit Wiegand
Read Range: 1.25” to 2.0”
Technologies Supported: PRX-C PRX-C-ISOViking , ,
PRX-FOB LRT-4, , certain legacy HID® proximity protocols*
and certain AWID 125Khz proximity protocols**
Transducer: Beeps during card read
LED: Red, turns off during card read
Humidity: Up to 100% (fully potted EWP)
Operating Temperature: -34° C to 65° C (-30° F to 150° F)
* HID and the HID logo are registered trademarks of HID
Global Corporation, an ASSA ABLOY company. All other
trademarks are the property of their respective owners.
** AWID is a trademark of Applied Wireless Identification Group.
Proximity Card Reader Specifications
Fea tures Overview
Keypad: Push to initiate call,
push again to disconnect. Zinc
Die cast with Satin Chrome
Finish, internally sealed per
IP67.
Speaker Screen: Speaker
screen with 0.018" wide slots
to prevent punctures from
paperclips, etc.
Faceplate Material: 14 gauge
316 stainless steel with #4
brushed finish.
Speaker: Mylar speaker with
rubber gasket to maintain
water-tight seal and eliminate
water deterioration.
Blue Call LED: Lights steady
to help locate the button in low
light.
Microphone: Omni-directional
microphone with protective
water-resistant cloth.
Front View of the
K-1270 Entry Phone
Condensation Drain Hole
Mounting Screws: (8) 6-32 X
3/4” Marine grade 316
stainless steel, flat head, T-10
Torx security screws and drive
bit (included).
Laser Etched Graphics: For
long lasting easy to read
graphics.
VIKING ©
#
*
0
9
8
7
6
5
4
3
2
1 2
3 4
5
6
7 8
90
#
*
Proximity Card Reader:
26-bit Wiegand, 125KHz, red
LED turns off and transducer
will beep during card read.
Fully potted EWP. Read range
1.25" to 2.0". Impact resistant
polycarbonate lens with
water-tight gasket.
2
Installation
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC
outlet and the telephone line. It is recommended that a surge protector be installed to protect against such surges.
A. Mounting
VIKING
©
9
0
#
*
8
7
6
5
4
3
2
Optional VE-5x10 Surface Mount
Box (not included), see DOD# 424
10.0"
9.5"
4.50"
2.596"
5.00"
8.65"
0.425"0.952"
Front View
of the K-1270
9.12"
2.5"
4.5"
Zinc-Plated Steel
Rough-In Box
(included)
Side View
of the K-1270
(8) #6-32 x 1/2" Stainless
Steel, 5/64" T-10 Torx
Security Screws
(included)
14 Gauge Marine
Grade 316 Stainless
Steel Faceplate
10.14"
3.69"
5.22"
- OR -
B. Changing the Directory
Paper Directory
Directory
Lens
C. Wiring
Color Function
Black Power In
Black Power In
Green Phone Line In
Red Phone Line In
Brown Door Strike Relay common
Orange Door Strike Relay NC
Yellow Door Strike Relay NO
Blue Camera Relay common
Violet Camera Relay NC
White Camera Relay NO
The is designed to be installed in a sheltered location, and is not meant to be used outdoors. For outdoor K-1270
applications use the . The can either be installed as a flush mount unit using the included K-1270-EWP K-1270
rough in box, or as a surface mount unit using an optional . The rough in box uses the inner set of four VE-5x10
holes on the face plate while the uses the outside set of holes. A set of dummy screws and nuts are VE-5x10
provided to fill the unused mounting holes.
To install a directory, remove the four screws that mount
the directory lens to the front of the using theK-1270
included Allen wrench. Insert a paper directory behind the
lens and secure the two back onto the front panel being
careful to align the names with the front panel graphics.
For your convenience, the back of this document has pre-
printed directory forms.
Note: To print directory forms for the , go toK-1270
www.vikingelectronics.com and enter “930” in the DOD
field at the top of the page for a direct link to the PDF.
The can be powered from any source supplying 12 K-1270
to 24 volts, AC or DC. A 12 volt DC adapter is supplied with
the product. When using the included adapter, the plug on
the adapter cord will have to be removed. The power
connections to the (black wires) are not polarityK-1270
sensitive.
There are also 8 more wires connected to the K-1270
controller board. Two wires are for the incoming phone line,
three are from the high current door strike relay and the last
three are from the camera relay. Gel filled butt connectors
are provided for easier connection to building wiring. The
table at the right describes each wire’s function.
3


Product specificaties

Merk: Viking
Categorie: Toegangscontrolesysteem
Model: K-1270-EWP
Kleur van het product: Roestvrijstaal
Ingebouwd display: Nee
Gewicht: 2200 g
Breedte: 127 mm
Diepte: 63.5 mm
Hoogte: 254 mm
Materiaal behuizing: Roestvrijstaal
LED-indicatoren: Status
Ingebouwde luidsprekers: Ja
Certificering: EWP\nIP66\nFCC Part 68\nFCC Part 15
Ingangsspanning: 250 V
Bedrijfstemperatuur (T-T): -34 - 65 °C
GeĂŻntegreerd Keypad: Ja
Authenticatie type: Access chip/card, Password
Toegangcode lezer: Ja
Toegangchip/kaart lezer: Ja

Heb je hulp nodig?

Als je hulp nodig hebt met Viking K-1270-EWP stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Toegangscontrolesysteem Viking

Handleiding Toegangscontrolesysteem

Nieuwste handleidingen voor Toegangscontrolesysteem