Ventev VenVolt 802.3at Handleiding

Ventev Accu VenVolt 802.3at

Lees hieronder de 📖 handleiding in het Nederlandse voor Ventev VenVolt 802.3at (2 pagina's) in de categorie Accu. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

www.ventevinfra.com sales@ventev.com 800-851-4965

VenVolt™ 802.3at PoE+ Site Survey Battery Pack

Charging and Operations Guide

The VenVolt™ is an 802.3af/at compliant during Site Surveys. It can be battery for powering WiFi Access Points

operated either on its back (with the ethernet ports facing the right side of the unit) or on its side (with the ethernet

ports facing up). It supports ethernet pass-through for conguring devices or other ethernet IP connectivity

requirements you may think of (Meraki Cloud, gateway checking, iPerf, etc.). This Charging and Operations Guide will

familiarize you with the VenVolt’s features so you can be up-and-running in no time.

Performance: The VenVolt delivers over 6 hours of continuous run time using a fully powered Cisco 3802, with both

radios turned up to the max, 1 client associated to each radio, both sending trac to each other and to the AP. This is

expected to be a ‘worst case’ scenario, and any deviation from this is likely to produce run time improvements.

Display Gauge: The gauge on front the front cap is not a ‘battery charge’ gauge, but rather a ‘power output’ gauge.

Ventev recommends using the Voltage display when charging your VenVolt. Use the ‘Display Cycle’ button below

the gauge to change the display from Percentage to Voltage numbers for a better understanding of the charge

status.

Note: The gauge has three positions: Voltage, Percentage, and Blank. Simply press the ‘Display Cycle’ button

repeatedly to cycle through the various displays.



Charging: Charge your VenVolt before use. Charging typically takes 4-5 hours to recharge a fully discharged

battery. Ensure the wall charger is fully and securely plugged into the VenVolt’s charge port. When plugged in, and

at full capacity, the gauge should reect the maximum voltage of your AC adapter, indicating that the battery has

completed charging and the voltage from the charger is being fully passed through. Full charge capacity is either

just over 15V (for 15V chargers) or just over 18V (for 18V chargers). Both AC chargers/adapters are functionally

equivalent and fully interchangeable. The 15V or 18V readings indicate that the battery is ‘topped o’ and at 100%

capacity. When the charger is disconnected, the gauge will immediately drop to 13.4V (or so) to show available

voltage. 



Operation: The voltage gauge will oat around 12V-13V during most of the day while in use. VenVolt follows a very

long discharge curve, then drops o dramatically (as indicated by the chart on the back of the unit). This rapid drop-

o is simply a characteristic of the LiFePo4 battery chemistry.

 Normally, no more than a half-hour of useful power remains when volts start to fall o below 11V or so. This

should happen very late in the day during site surveys.

 The VenVolt supports charging while being used. This means that you can simply roll up to an AC outlet, plug the

VenVolt in while it’s being used and it will take a trickle charge to keep your battery up!

 At full capacity (noted above at a jump to 18.6V (or so), the VenVolt will shut o the injector to protect itself from

overcharging. Stated dierently, if you run the VenVolt plugged in, and powering an AP at the tippy-top of its

voltage curve, you run the risk of powering o your AP. If your battery discharge indicator is at 13.4V (or so), don’t

bother plugging it in to keep it topped o.

www.ventevinfra.com sales@ventev.com 800-851-4965

VenVolt™ 802.3at PoE+ Site Survey Battery Pack

Charging and Operations Guide

Additional Information:

 The VenVolt is rated at 84WH and should be safe for carry-on and checked bags. If in doubt, carry the VenVolt with

you if you’re traveling on an airplane. The TSA recommends that the Master Power Switch be taped to the o

position during air travel.

 Do not open/modify the VenVolt. This will void its warranty and you can compromise the power integrity (and

various discharge benets, longevity awesomeness, etc.) of the unit.

 The USB port on the front will charge cell phones, etc. - and if you have a USB-C laptop/tablet, VenVolt can keep

your laptop/tablet charged during the day too!

Product specificaties

Merk:	Ventev
Categorie:	Accu
Model:	VenVolt 802.3at
Kleur van het product:	Oranje
Gewicht:	2050 g
Breedte:	229 mm
Diepte:	127 mm
Hoogte:	89 mm
Capaciteit van de accu/batterij:	7000 mAh
Inclusief AC-adapter:	Ja
Accu/Batterij voltage:	- V
Levensduur accu/batterij:	21 uur
Accu/Batterij oplaadtijd:	7 uur
Compatibele producten:	Cisco 3802
Aantal inbegrepen batterijen:	1 stuk(s)
Technische details:	2 x RJ-45, 1 x USB
Batterijtechnologie:	Lithium-ijzerfosfaat (LiFePo4)
Herlaadbare cycli (max):	2000
Batterijcapaciteit:	84 Wh