Trek Rail 5 Gen 3 Handleiding

Trek Fiets Rail 5 Gen 3

Lees hieronder de 📖 handleiding in het Nederlandse voor Trek Rail 5 Gen 3 (15 pagina's) in de categorie Fiets. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/15
2023 Alloy Rail
5, 7, and 9 Gen 3
SERVICE MANUAL
2023 Alloy Rail
1
Safety
WARNING
Properly tighten hardware
Always tighten hardware to the specied torque.
Over-tightening hardware could deform or break the
hardware or components. Under-tightening hardware
could cause hardware or components to become loose.
Either situation could damage the bicycle and result in
injury to the rider.
WARNING
Reapply threadlocker
All reused-fasteners with pre-applied threadlocker must
be cleaned with isopropyl alcohol and have new thread-
locker applied before re-assembly. If threadlocker is not
applied, the fasteners may loosen which could damage
the bicycle and result in injury to the rider.
Legend
Apply grease
Do not apply grease
Apply threadlocker
Nm Torque
Hex tool size
Torx tool
Drift size
ï‚«
ï‚«
ï‚«
ï‚«ï‚«Zip tie
Contents
52mm
• Boost hub with offset chainring.
Cha inring (1x only)
• 34T
Rear bra ke mount
Minimum Maximum
180mm, direct mount Adaptable to 203mm
Maximu m tire size
Notice: Measurements of actual tires may vary. Always
verify there is sufcient clearance between the tire and
the frame. Improper tire size could damage the bicycle
frame. Trek recommends 6mm clearance above and on
the sides of the tire.
Wheel set Maximum tire size
29" 29" x 2.6"
Water bottle t
Small: Compatible only with the Bontrager Voda 15 bottle.
Requires the cage spacer included with the bike.
Medium: Requires the bottle cage spacer included with
the bike.
Seat post
WARNING
Always follow the seatpost manufacturer’s minimum
insertion recommendation. Failure to follow the recom-
mendation could cause damage to the seatpost and
result in injury to the rider.
Measurement
Maximum insertion Frame
S220mm
M230mm
L260mm
XL 310m m
Seat tube inside diameter 31.6mm
two M6x1.0x25mm bolts
18mmM6x1.0x25
W581379
Fork
Refer to the suspension setup card included with your bike
or the suspension calculator at
Trekbikes.com/suspension-calculator.
WARNING
Exceeding the recommended maximum fork length could
damage the bicycle and result in injury to the rider.
Travel
Axle to Race
Frame size Axle to Race
(mm)
Travel
(mm)
S M ML L XL Recommended 570 160
Safety Rocker pivot and
seatstay and seat
stay
Shock mounts RIB — battery
assembly
Drive unit and
mounting bolts
Specications
0.5°
Headset with Knock
Block
Adjust the geom-
etry
Cable routing RIB — docking
assembly
Battery charge
port cover
Active Braking Pivot
(ABP)
Main pivot and
chainstay and
chainstay
Cable routing Remote Speed sensor
Copyright 2022 Trek Bicycle Corporation All Rights Reserved
2023 Alloy Rail
2
Headset with Knock Block
1
4
5
6
7
3
2
2.5
2Nm
1Upper bearing cover
— 5252157
2Chip bolt — W532763
3Knock Block chip
4Compression ring — W532842
5Upper bearing — W531676
6Lower bearing, 1.5" diameter — W532843
7Crown race, for 1.5" diameter lower bearing —
W532844
Tools
• 2.5mm hex tool
• Grease


Product specificaties

Merk: Trek
Categorie: Fiets
Model: Rail 5 Gen 3

Heb je hulp nodig?

Als je hulp nodig hebt met Trek Rail 5 Gen 3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Fiets Trek

Handleiding Fiets

Nieuwste handleidingen voor Fiets