Toa ER-604W Handleiding

Toa Niet gecategoriseerd ER-604W

Lees hieronder de 📖 handleiding in het Nederlandse voor Toa ER-604W (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 11 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

Please follow the instructions in this manual to obtain the optimum results from this unit.

We also recommend that you keep this manual handy for future reference.

ER-604WCOMPACT MEGAPHONE

INSTRUCTION MANUAL

1. SAFETY PRECAUTIONS

• Be sure to read the instructions in this section carefully before use.

• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages

regarded as very important precautions are included.

• We also recommend you keep this instruction manual handy for future reference.

Indicates a potentially hazardous situation which, if mishandled, could

result in moderate or minor personal injury, and/or property damage.

CAUTION

• Make sure that the volume control is set to minimum position before use. Loud noise produced when using

the unit at high volume can impair hearing.

• Make sure to observe the following handling precautions so that a fire or personal injury does not result from

leakage or explosion of the battery.

· Do not short, disassemble, heat nor put the battery into a fire.

· Avoid using both new and old batteries together.

· Do not solder a battery directly.

· Note correct polarity (positive and negative orientation) when inserting a battery in the unit.

· Avoid locations exposed to the direct sunlight, high temperature and high humidity when storing batteries.

2. GENERAL DESCRIPTION

TOA's ER-604W megaphone is a small, lightweight shoulder-held megaphone that is also supplied with a

whistle. Its close-talking microphone features a press-to-talk switch and a volume control, which can be easily

operated by hand. The ER-604W's External input terminals can also be connected to an optional wired

microphone, headset microphone, CD player, MD player or cassette player to make public address

announcements or play music.

3. HANDLING PRECAUTIONS

• The ER-604W megaphone is not waterproof. Avoid exposure to rain or environments where it may be

splashed by water or other liquids.

• When the batteries are left loaded for long periods of time, be sure to check the batteries periodically for

discharge and leakage.

• Immediately contact your TOA dealer if the following irregularities should occur.

· Smoke coming from the unit or a strange smell detected.

· Water or other foreign objects get inside the unit.

· No sound heard (after checking to be sure that the batteries are loaded in correct orientation, and

satisfactorily charged).

To avoid catastrophic failure, make no further attempt to use the unit in these conditions.

• Avoid storing the unit in humid or dusty locations, in locations exposed to direct sunlight, near heaters, or

exposed to sooty smoke, as these conditions may result in unit failure.

• Do not use the unit for extended periods of time with a distorted sound output. This could cause the speaker

to become hot and possibly result in unit failure.

• Noise may be produced when a mobile phone is used in close proximity of the unit. However, this is not a

failure. Use the mobile phone as far as possible from the unit.

• Use a tightly wrung-out damp cloth to clean the unit. If the unit becomes extremely dirty, use a cloth

moistened in a neutral detergent and tightly wrung-out. Never use volatile liquids such as benzene or thinner

to clean the unit, as these may deform or discolor its case.

4. NOMENCLATURE AND FUNCTIONS

1. Speaker

2. Shoulder strap

Use this strap to hang the unit from the shoulder for transport or use.

3. Microphone hanger

Hook the microphone onto this hanger when not used.

4. Talk switch

Press to talk (power turns ON). Release to turn the power OFF.

5. Volume control

Rotate upward to increase output volume.

6. Stand socket

The megaphone can be mounted on the optionally available ST-16

Speaker Stand using the screw mount located on its bottom surface.

Mounting details are described in the ST-16 instruction manual.

7. External input volume control [VOLUME]

Adjusts the volume of external equipment connected to the rear-

mounted external input terminals (13) – (15).

8. Battery indicator LED [BATTERY CHECK]

To check the battery voltage, switch the External input power

switch (9) to the ON position.

• Steadily lit: Sufficient battery voltage available.

• Flashing: Replace batteries.

9. External input power switch [POWER]

Press to turn the power ON for use with connected external

equipment. Press again to turn the external power OFF.

Note: Power is constantly used while this switch is in the ON

position. When not using external equipment, be sure to set

this switch to the OFF position to prevent battery discharge.

10. Signal tone switch [WHISTLE]

A whistle tone sounds while this switch is pressed, and stops

when released.

Note: Output volume is fixed, and cannot be adjusted with the

volume control.

11. Voice switch [VOICE SWITCH]

Set this switch to the ON position when using connected external

equipment to prevent battery discharge. (Normally set this switch

to the OFF position.)

12. External power input terminal [EXT. POWER]

Use the supplied plug cord for external power supply.

13. General microphone input terminal [MIC 1]

A 6.3 mm phone jack. Unbalanced input.

14. Electret condenser microphone input terminal [MIC 2]

A 3.5 mm mini jack.

15. Auxiliary input terminal [AUX]

A 3.5 mm mini jack.

16. Battery cover

Install 8 R6 (C-cell) batteries. Remove the batteries from the unit

when not used for extended periods of time.

Volume

High

[Top (Operation Area)]

[Rear]

[Microphone]

Never use the megaphone pointed directly at a person's ears,

as permanent hearing impairment could result. When testing,

make sure that the speaker is pointed toward the ground.

CAUTION

EXT. MIC/AUX

BATTERY

CHECK

POWER

VOLUME OFFON

87 9 10

DC12 V

0.8 A

MOVING COIL

MIC.

ELECTRET

CONDENSER

MIC.

PUSH

ON OFF

VOICE

SWITCH

BATTERY

ORIENTATION R6P, SIZE "AA"

8 PCS

MIC 1 MIC 2 AUXEXT.

POWER

EXTERNAL INPUT

11 13 14 1512

4 5

Talk area

About the Voice switch (11) (normally set to the OFF position).

When using equipment connected to External input terminals (13) (15), battery discharge can be–

prevented by setting the Voice switch to the ON position, thus allowing the unit to be used for longer

periods of time. This is especially convenient when intermittently using an external microphone, since it

can be used freely with no need to constantly turn its power switch ON and OFF.

When the Voice switch is in the ON position, the unit automatically switches to operation mode at the

first detection of external input, and switches to Standby mode if no signal is received from the

connected external equipment for a period of 2 3 seconds.–

Notes

•Immediately after the Voice switch is turned ON, there may be a momentary loss of initial output,

however this is not a failure. If this is not acceptable, leave the switch OFF.

•The Voice switch function cannot be used with the attached hand-held microphone.

Battery cover

5. BATTERY INSTALLATION

Step 1. Remove the battery cover (16) by unscrewing its knob counterclockwise.

Step 2. Insert 8 batteries, noting the battery polarity markings provided inside the

receptacle.

Step 3. Correctly replace the cover, then secure with its screw knob slightly

holding the battery cover.

6. USING THE SUPPLIED MICROPHONE

Step 1. Detach the microphone from the microphone hanger (3).

Step 2. Using the volume control (5), adjust the volume to an appropriate level that does not generate

feedback when holding down the microphone talk switch (4).

Step 3. Speak into the microphone while holding it about 1 cm away from the mouth.

Notes

•Take care not to block the holes in the microphone's rear panel, as output volume could be

drastically reduced.

•The microphone features an anti-bacterial treatment which helps keep it clean and sanitary.

7. USING EXTERNAL EQUIPMENT

Step 1. Connect the external equipment.

1-1. When using a general-purpose microphone

Connect the moving coil-type microphone to the General microphone input terminal [MIC 1] (13).

1-2. When using a headset microphone

Connect the headset microphone to the Electret condenser microphone input terminal [MIC 2] (14).

Notes

•To avoid megaphone failures, do not connect any other equipment than an electret condenser

microphone to these inputs.

•When using TOA's optional WH-4000A Headset Microphone, speak into the microphone while

keeping it about 1 cm away from the mouth. Although the WH4000A Microphone has a lock knob for

securing the plug, this lock knob is not used with the ER-604W Megaphone.

1-3. When using a CD, MD or cassette player

Connect the CD, MD or cassette player to the Auxiliary input terminal [AUX] (15) using the supplied

3.5 mm mini plug.

Note: When using the supplied mini plug, the connection cord and external equipment-side plug must

be prepared separately.

Step 2. Set the External input power switch [POWER] (9) to the ON position.

Step 3. Adjust the volume with the External input volume control [VOLUME] (7).

Note: Connected external equipment can be used simultaneously. However, since the volume of

each component cannot be individually adjusted by the megaphone, use each component's

volume control for individual volume adjustment.

Notes on Microphone Storage

Set the volume control (5) to the minimum position, and insert the microphone into the microphone hanger (3).

If the microphone is inserted with the volume control set to the high volume position, when it is inserted into

or detached from the hanger, the talk switch (4) could be accidentally pressed, causing feedback.

Product specificaties

Merk:	Toa
Categorie:	Niet gecategoriseerd
Model:	ER-604W

Heb je hulp nodig?

Als je hulp nodig hebt met Toa ER-604W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Toa

Toa ST-34B Handleiding

18 September 2024

Toa PJ-304 Handleiding

3 September 2024

Toa PE-604 Handleiding

3 September 2024

Toa SC-630TU Handleiding

9 Juli 2024

Toa SR-SA4 Handleiding

9 Juli 2024

Toa ST-800 Handleiding

9 Juli 2024

Toa HY-C0801W Handleiding

22 Juni 2024

Toa SR-RF12 Handleiding

13 Maart 2024

Toa HY-C0801 Handleiding

13 Maart 2024

Toa HY-TM7B-WP Handleiding

12 Maart 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Taga Harmony TOS-600 v.2 Handleiding

26 November 2024

Trace Elliot Pro 2x12 Cabinet Handleiding

26 November 2024

Kramer K-Bar Camera Bracket Handleiding

26 November 2024

Kramer RK-19 Handleiding

26 November 2024

Kramer OSP-MM1 Handleiding

26 November 2024

Kramer ASPEN-1616UX Handleiding

26 November 2024

Korg Pitchstrap Handleiding

26 November 2024

NeoMounts WL70-450BL11 Handleiding

26 November 2024

Kramer CLS-AOCH/60 Handleiding

26 November 2024

Klauke EKM 6022ISM Handleiding

26 November 2024