Tesy CN 051 150 EI CLOUD AS W Handleiding

Tesy Niet gecategoriseerd CN 051 150 EI CLOUD AS W

Lees hieronder de 📖 handleiding in het Nederlandse voor Tesy CN 051 150 EI CLOUD AS W (64 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 212 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/64
www.tesy.com
is a registered trade mark of Tesy ltd.
CN 051 EI [CLOUD] [AS] W
230V~ 50Hz 500/1000/1500/2000/2500/3000W
206429-v1.0
ENELECTRIC PANEL HEATER 2-11
Operation and Storage Manual of Panel Heater
BGЕЛЕКТРИЧЕСКИ КОНВЕКТОР 12-22
Инструкция за експлоатация и съхранение на панелен конвектор
ROCONVECTOR ELECTRIC 23-32
Instrucţiuni de utilizare şi depozitare а convectorului de panou
RSЕЛЕКТРИЧНИ КОНВЕКТОР 33-41
Упутства за употребу и складиштење панелног конвектора
GRΗΛΕΚΤΡΙΚΟΣ ΘΕΡΜΟΠΟΜΠΟΣ/CONVECTOR 42-52
Οδηγίες χρήσης και αποθήκευσης Πάνελ - Θερμοπομπού
HRELEKTRIČNI KONVEKTOR 53-62
Upute za uporabu i pohranu panelnog konvektora
EN
2 Operation and Storage Manual of Panel Heater
IMPORTANT SAFETY MEASURES AND INSTRUCTIONS:
WARNING!
• Please read this manual before operating the appliance and keep it at a
safe place for future reference. In case the appliance is obtained by a new
owner, it should be transferred together with its manual.
• Children under 3 years of age should be kept away from the CAUTION:
appliance unless they are under constant supervision.
Children from 3 to 8 years of age are allowed to operate the on/off button
ONLY, provided that the appliance is installed and ready for operation and
such children have been supervised and instructed in safe operation of the
appliance and they understand all related risks.
Children from 3 to 8 years of age MUST NOT: connect the plug to power
sockets, make adjustments, clean it or carry out user maintenance
operations.
This appliance can be used by children older than 8 years of age and
by people with reduced physical, sensor and mental capabilities, as well
as by people with insufficient experience and knowledge provided they
are supervised or instructed in safe operation of the appliance and
understand the related risks. Children should not be allowed to play with
the appliance. Cleaning and user maintenance operations must not be
carried out by children without supervision.
• Some of the appliance parts may get very hot during operation CAUTION:
and thus cause burns to users. In case there are children and vulnerable
people in the room, special attention should be paid.
•WARNING: Do not cover the appliance in order to
prevent overheating!
• The appliance must not be placed right under a socket box!
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• Before connecting the appliance to the mains, check if the voltage
indicated on its technical plate corresponds to the voltage of the
electricity, supplied to your house.
• This appliance shall be used only for the purpose it has been designed
and intended for, i.e. heating of domestic premises. The appliance is not
intended for commercial/industrial application. Every other use is to be
considered improper, and therefore dangerous. The manufacturer doesn’t
bear responsibility for damages arising from improper and irrational use.
Non-adherence to these instructions would render the warranty invalid!
• Do not leave your home while the heater is operating: make sure that the
power switch is in OFF position (panel heaters with mechanical control).
• Keep inflammable objects, such as furniture, pillows, bedding, paper,
clothes, curtains etc. at a safe distance of at least 100 cm away from the
panel heater.
• Do not operate the appliance in areas of use or storage of combustible
substances. Do not operate the appliance in areas of combustible media
(for example in close proximity to inflammable gases or aerosols) – there is
great risk of explosion and fire!
• Do not insert and do not allow foreign objects to enter the ventilation
openings (inlet and outlet) because this will cause electric shock, fire or will
damage the appliance.
• The appliance is not suitable for animal breeding. The panel heater is
intended for domestic/indoor operation only.
• When positioning the appliance, do not cover the safety grilles; do not
hamper the incoming and outgoing air flow. All objects must be at a safe
distance of at least 1 meter away from the appliance front and sides.
• The most common reason for overheating is dust and fluff deposits in the
appliance. Clean the ventilation openings on a regular basis with a vacuum
cleaner, but before that it is very important to disconnect the heater from
the mains.
• Never touch the appliance with wet or moist hands – there is risk for your life!
• The power socket should be accessible all the time in order to disconnect
the power plug when needed as fast as possible! Never pull the power
cord or the appliance itself in order to disconnect it from the mains.
• PAY ATTENTION! Outgoing air gets heated during appliance operation (up
to more than 100°С).
• If you decide to stop using an appliance of this kind, it is recommended to make
it unusable by cutting its power cord after you have disconnected it from the
mains. It is advisable all possible risks related to the appliance to be secured,
especially in relation to children that may play with out-of-use appliances.
• Warning: Do not use this appliance with a programmer, counter or any
other mechanism which could automatically turn on the heater – if the
appliance is covered or positioned incorrectly there is a risk of fire.
• Position the power cord in such a way that it does not obstruct the free
movement of people and cannot be stepped on! Use only approved extension
cords, which are suitable for this appliance, i.e. they have a compliance sign!
• Never move the appliance by pulling its power cord; do not use the power
cord for carrying other objects!
• Do not bend the power cord and do not pull it against sharp edges; do not
place the power cord on hot surfaces or open fire!
• The scattered UVA light emitted by the device is harmless to the eyes.
Looking directly at UVA light is not recommended.
PACKING
• After unpacking the appliance, check if its contents are intact and if it has
not been damaged during transportation! In case a damage or incomplete
delivery is found, contact your authorized retailer!
• Do not dispose of the original packing box! It could be used for
storage and transportation purposes in order to avoid damages during
transportation!
• Disposal of packing material should be done in the appropriate way!
Children must be prevented from playing with polyethylene bags!
INSTALLATION INSTRUCTIONS
• This panel heater is designed to be used indoors, mounted on a wall.
Important: In premises bigger than 45 m
3, it is recommended to use a
combination of 2 or more panel heaters.
• Do not position the panel heater under a power socket or electricity
connection box.
• DO NOT install/operate the panel heater:
1. in places where a draught is present, which could influence the
control settings;
2. right under a power socket;
3. in “Volume 1” for bathrooms;
4. in “Volume 2” if the control board can be reached by a person who is in
a shower or in a bathtub;
• for the wall-mounting of the panel heater, only the wall braces must be
used which are delivered together with the appliance. When installing the
panel heater, minimum safe distances must be observed
• First of all, remove the wall braces from the back of the appliance body.
Unscrew the two screws which are positioned at the upper part of the two
vertical bars of the wall braces. Then pull the upper part of the bar by pressing
strongly the two upper parts which are inserted in the back of the body.
EN
Operation and Storage Manual of Panel Heater 3English
• Slide down the wall brace in order to detach it from the back of the body.
• Attach firmly the wall brace onto a wall through the four screw holes.
• Lift the panel heater up to almost vertical position and insert the two lower
protruding parts of the braces into the two lower openings of the back
cover of the panel heater. Then lift the panel heater and insert the two upper
protruding parts of the wall braces into the two upper openings of the back
cover of the heater. Finally, put the two screws back to their places and
tighten them in order to install the panel heater firmly to the wall.
BATHROOM OPERATION
• The panel heater must be installed in accordance with the normal trade
practices and in compliance with the national legislation (EU electricity
directives and regulations concerning special installations and places
of operation including bathrooms, shower cabins HD60364-7-701(IEC
60364-7-701:2006)).
• In case this panel heater is to be used in a bathroom or other similar room,
the following installation requirements must be observed: the panel
heater is with IP24 protection (water drops protection). Hence it can be
installed in “Volume 2” (see the diagram below) in order to avoid the risk of
the control board (power switch and thermo regulator) being reached by
a person who is in a shower or a bathtub. The minimum distance between
the appliance and a water source should be not less than 1 meter and it
is compulsory the appliance to be wall-mounted! If you do not feel sure
about the installation of this panel heater in a bathroom, we recommend
you to consult a professional electrician.
Note: If the above-mentioned instructions cannot be implemented, it is
recommended to install the appliance in “VOLUME 3”.
• In wet premises the power source must be installed at a height of at least
25 cm above the floor (bathrooms and kitchens).
• The installation must be equipped with a safety fuse, and the distance
between the fuse contacts in disconnected condition should be at least 3 mm.
Thank you for choosing CN051 panel heater. This is a product providing
heating in winter depending on the consumers’ needs for comfortable
room temperature. If operated and taken care of properly in accordance
with these instructions, the appliance will provide you with many years of
useful operation.
OPERATION INSTRUCTIONS
• Hold for 1.5 sec button for OFF or ON the heater.ON/OFF
• – push the ON/OFF button until 1 secondsStep back
• - push the Mode button until 1 secondsQuick menu/Confirmation
• - hold the Mode button over 3 secondsFull menu
1. Predefined functions:
Comfort mode ; Eco mode ; Sleep mode
1.1. Comfort mode - with On/Off option - allows the user to set a desired
temperature when being at home. After once set it and the function is
switched On, the appliance will keep the same room temperature each time of
usage. This temperature to be set at 23°C by default.
Activation of „Comfort mode“ :
- Push the button “Mode” for 3 sec and select “Comfort mode” by
pushing any of the buttons: and and confirm with “Mode” button
. After that you should set the comfort temperature
– by pushing any of the buttons or set the desired temperature.
Confirm with “Mode” button .
- The “Comfort” mode is activated.
Deactivation of „Comfort mode“ :
- To deactivate the “Comfort” mode press “On/Off” button for 1.5 sec. Then
the heater turns off. The display will continue showing the set temperature. Or
press “Mode” button to choose different mode.
Visualization on Display in “Comfort” mode settings :
- Set temperature
The display shows “Comfort” in the top and the set temperature
When the convector is in „Heating mode„ ,sign „sun„ appears on the
display.
1.2. Eco mode - with On/Off option - allows the user to set a desired
temperature when being out of home. After once set it and the function is
switched On, the appliance will keep the same room temperature each time of
usage. This temperature will be set at 18°C by default. User could also set the
time when the appliance to switch to Comfort mode.
Activation of „Eco„ mode
Push the button “Mode” for 3 sec and select “Eco” mode by pushing
any of the buttons: or and confirm with “Mode” button . After
that you should set the temperature – by pushing any of the buttons or
set the desired temperature. Confirm with “Mode” button .
If you want you can set the clock time:
-Select by pushing any of the buttons: or reach actual hour time.
Confirm with “Mode” button .
- The minute icon is flashing and by pushing any of the buttons: or
reach actual minute time. Confirm with “Mode” button (range 00.00-
24.00).

Product specificaties

Merk: Tesy
Categorie: Niet gecategoriseerd
Model: CN 051 150 EI CLOUD AS W

Heb je hulp nodig?

Als je hulp nodig hebt met Tesy CN 051 150 EI CLOUD AS W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Tesy

Tesy

Tesy AC 16 EHCI Handleiding

22 Mei 2023
Tesy

Tesy CN 051 200 EI CLOUD AS W Handleiding

20 Mei 2023
Tesy

Tesy CN 202 ZF Handleiding

7 Mei 2023
Tesy

Tesy CN 051 150 EI CLOUD AS W Handleiding

6 Mei 2023
Tesy

Tesy CN 051 050 EI CLOUD W Handleiding

2 Mei 2023
Tesy

Tesy CC 2510 E05R Handleiding

28 April 2023
Tesy

Tesy CN04 100 MIS F Handleiding

22 April 2023
Tesy

Tesy CN 051 300 EI CLOUD W Handleiding

20 April 2023
Tesy

Tesy CN 06 200 EА CLOUD AS W Handleiding

16 April 2023
Tesy

Tesy CN03 100 MIS F Handleiding

14 April 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Westfalia

Westfalia WT18 Handleiding

16 November 2024
Martin Audio

Martin Audio FlexPoint FP8 Handleiding

16 November 2024
Martin Audio

Martin Audio XE300 Handleiding

16 November 2024
Martin Audio

Martin Audio Blackline X218 Handleiding

16 November 2024
Martin Audio

Martin Audio Blackline X10 Handleiding

16 November 2024
Martin Audio

Martin Audio Blackline X15 Handleiding

16 November 2024
Martin Audio

Martin Audio LE200 Handleiding

16 November 2024
Martin Audio

Martin Audio Adorn A55 Handleiding

16 November 2024
Martin Audio

Martin Audio VU-NET 2.2.0 Handleiding

16 November 2024
Martin Audio

Martin Audio DDX12 Handleiding

16 November 2024