Techno Line WS 9116 Handleiding

Techno Line WS 9116

Lees hieronder de 📖 handleiding in het Nederlandse voor Techno Line WS 9116 (2 pagina's) in de categorie . Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

INTRODUCTION WS 9116

FEATURES:

• Four digit time display

• 12-hour or 24-hour selectable time

• Indoor temperature (°C or °F)

• Outdoor temperature (°C or °F)

• Minimum and Maximum temperature

• Four level RF strength indicator

• Wall hanging or free standing

• Low battery indicator for receiver and transmitter

SET UP:

NOTE: This temperature station can receive one transmitter only.

• First, insert batteries into the transmitter, observing the correct polarity (see

marking inside battery compartment). Keep transmitter 5-10 feet from the

temperature station.

• Within 30 seconds of powering up the transmitter, insert batteries into the

Temperature Station, observing the correct polarity (see marking inside battery

compartment). Once the batteries are in place, all segments of the LCD will

light up brieﬂy.

Following the indoor temperature will be displayed. If the indoor temperature is

not shown in the LCD after 60 seconds, remove the batteries and wait for at

least 60 seconds before reinserting them. Once the indoor data is displayed

you may proceed to the next step.

• After the batteries are inserted, the Temperature Station will start receiving

outdoor temp data from the transmitter. The outdoor temperature should then

be displayed on the Temperature station. If this does not happen after 2

minutes, remove the batteries from both units and start again from the

beginning.

• In order to ensure suﬃcient 433 MHz transmission, the outdoor transmitter

should be placed a distance of no more than 100 feet (30 meters) from the

Temperature Station and the transmitter.

TEMPERATURE SELECTION:

FAHRENHEIT/CELSIUS: Press the CF/SET button once to switch from

Celsius to Fahrenheit.

FOUR LEVEL RF INDICATOR: The temperature station will indicate strength

of signal reception from the outdoor transmitter by the number of bars on the

RF indicator icon.

4-bars: Shows after initial set up and stays when reception is at full strength.

3-bars: Indicates one reception failure from the outdoor transmitter.

2-bars: Indicates two reception failures from the outdoor transmitter.

1-bar: Indicates three reception failures from the outdoor transmitter.

0-bars: Indicates four reception failures from the outdoor transmitter.

The antenna symbol will ﬂash on initial set while searching for the signal. If it

fails to receive a signal after 63 minutes the temperature station will display

dashes (“--.-“). The temperature station will search again for a signal for 3

minutes every next hour.

SET TIME:

• 12/24-HOUR TIME: Hold the CF/SET button until

12hr or 24hr ﬂashes.

Press the MIX/MAX/+ button to switch between 12-hour and 24-hour time.

Press the CF/SET button once to continue.

• HOUR: The Hour will ﬂash. Press the MIX/MAX/+ button to change the hour.

Press the CF/SET button once to continue.

• MINUTES: The minutes will ﬂash. Press the MIX/MAX/+ button to change the

minutes.

• NOTE: Hold the MIX/MAX/+ button to move quickly through the numbers.

Press CF/SET once and you are done.

MIN/MAX RECORDING:

• VIEW MIN/MAX: Press the MIN/MAX/+ button to view indoor and outdoor

MAX, MIN and Current temperature.

• RESET MIN/MAX: Hold the MIN/MAX/+ button for 3 seconds to reset all

MIN/MAX readings to current temperatures.

RESET BUTTON:

The Temperature Transmitter has a RESET button. Use a small pointed object

to gently press and release to send a signal. Follow the instructions for in SET

UP regarding the display.

NOTE: Removing power from the transmitter and display negates the need for

the RESET button.

SPECIFICATIONS:

Indoor Temperature:

Range: 0° C to 50° C (32° F to 122° F)

Resolution: 1°C /°F

Outdoor Temperature:

Range: -30° C to -60° C (-22° F to 140° F)

Resolution: 1°C /°F

Power:

Receiver: 2-AAA

Transmitter: 2-AA

Dimensions:

Receiver: 65x30x95.7mm

Transmitter:47x28.2x104mm

Product specificaties

Merk:	Techno Line
Categorie:
Model:	WS 9116
Kleur van het product:	Zilver
Ingebouwd display:	Ja
Breedte:	30 mm
Diepte:	65 mm
Hoogte:	96 mm
Materiaal behuizing:	Kunststof
Meeteenheid temperatuur:	F, °C
Alarm functie:	Nee
Klok functie:	Ja
Meetfuncties:	Indoor thermometer, Outdoor thermometer
Meetfuncties trend display:	Thermometer
weerstation extremum data:	Thermometer
Weersvoorspelling:	Nee
Receiver afmetingen (B x D x H):	28 x 47 x 104 mm
Type batterij:	AAA Micro LR 03, AAMignon LR 06
Aantal batterijen (receiver):	2
Min/Max temperatuur geheugen:	Ja
Temperature measurement range (outside) (T-T):	-30 - 60 °C
Aantal batterijen (sensor):	2
Temperature measurement range (inside) (T-T):	0 - 50 °C
Oudoor sensorbereik:	30 m