Summit CKPUMPKIT Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Summit CKPUMPKIT (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
CKPUMPKIT
Assembly Instructions for Your Kitchenette Water Pump
MODELS:
C48ELPUMP
C48ELGLASSPUMP
Write Serial Number (on lower left corner of
inside cabinet) here:
Serial No.: _______________________
Felix Storch, Inc.
An ISO 9001:2015 registered company
770 Garrison Avenue
The Bronx, NY 10474
www.summitappliance.com
Summit Appliance Division · Felix Storch, Inc. · www.summitappliance.com · 718- -3900 · info@summitappliance.com893
Pump Kit Installation CKPUMPKIT –
Component
Quantity
Bottled Water Dispenser Pump System,
20ft 110V AC US Plug Water Dispensing
Pump
1
5 Gallon Freshwater Container
1
6 Gallon Waste Container
1
3/8 in. Brass Water Cut-o Valve
1
1/4" Acetal Copolymer Compression
Sleeve
1
20 in. Length Braided Stainless Steel
Faucet Connector
2
1- -in Flexible Plastic Drainage Pipe 1/2
1
Summit Appliance Division · Felix Storch, Inc. · www.summitappliance.com · 718- -3900 · info@summitappliance.com893
1/2 in. x 520 in. White Teon Tape
1
Mounting Template (18x12)
1
10-32 x 1 1/4" Phillips Head Truss Screw
Stainless Steel
4
10-32 Nylon Lock Nut Stainless Steel
4
10 x 5/8" Fender Washer Stainless Steel
4
Installation Instructions
1) Open the cabinet of your combo kitchen. Move the wire shelf to the oor of the cabinet. This is to
ensure nothing sits directly on the floor, keeping any cords or wires dry.
2) To install the faucet, set the gasket on top of the pre-drilled holes of the combo kitchen.
3) Insert the water faucet thought the gasket and secure the faucet with the provided nuts on the
underside of the sink.
4) The pump will be secured to the outer wall of the combo kitchen, using four machine screws and
nuts.
5) Place the provided template on the left side of the combo kitchen, in the top-right corner. It should
align to the front edge and along the bottom edge of the stainless steel top.
6) Using a drill bit, drill the four template holes. ¼”
7) Secure the pump to the interior wall of the cabinet, using the four provided screws, washers, and
nuts. Be sure the screw heads are on the outside of the cabinet.
NOTE: If mounting is not possible for your particular set-up, the pump can be placed on the oor of the
cabinet. It is recommended to place it, so the ON/OFF switch is accessible.


Product specificaties

Merk: Summit
Categorie: Niet gecategoriseerd
Model: CKPUMPKIT

Heb je hulp nodig?

Als je hulp nodig hebt met Summit CKPUMPKIT stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Summit

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd