Stokke Tripp Trapp Handleiding

Stokke Kinderstoelen Tripp Trapp

Lees hieronder de 📖 handleiding in het Nederlandse voor Stokke Tripp Trapp (20 pagina's) in de categorie Kinderstoelen. Deze handleiding was nuttig voor 77 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/20

US/CA

USER GUIDE

NOTICE D’UTILISATION

USER GUIDE

INSTRUCCIONES DE USO US

AU/NZ

Tripp Trapp®

2US/CA

• Never leave child unattended

• The Tripp Trapp® Baby Set™ should only be used with the

seat plate in the rst groove from the top of the chair.

• Always use the restraint system when the seat is in one

of the top 3 grooves.

• Always keep child in view.

• Stay in reach of your child.

• Do not use the chair unless all components are correctly

tted and adjusted. Pay special attention to the seat

and foot plate – make sure these are properly fastened

before you put your child into the chair.

• Do not place the chair near an open re or other sources

of strong heat, such as electric bar res, gas res etc due

to the risk of re.

• Do not use the chair if any part is broken, torn or missing.

• Do not use the chair before the child can sit up by itself.

• Always place the chair on a level stable surface and

make sure that the chair has space to slide backwards.

• Be careful not to place small items, toxic substances, hot

objects, and electrical exes etc near the chair where

your child can reach them, as they may cause choking,

poisoning or other injuries.

• Remember to retighten all screws 2-3 weeks after

asembly of the chair. After that you should check on and

retighten the screws if necessary on a regular basis, e.g.

every second month. Keep the Allen key for future use,

but out of the childs reach.

• Do not use any accessories or replacement parts not

manufactured by STOKKE®; this may aect your child’s

safety.

• Do not use the chair as a step stool.

• Do not use with a booster seat

• The child should be secured in the chair at all times by

the restraining system

• TRIPP TRAPP® is intended for use when your child is capa-

ble of sitting upright unassisted (approximately 6 months)

• Front of footrest not to exceed front legs of chair at oor

level

• NEVER use the Tripp Trapp® chair without any glider.

• Do not use the harness if it shows any signs of deteriora-

tion or excessive wear and tear, such as fraying of the

straps or cracks in the plastic. If any such deterioration

or excessive wear and tear is observed, please contact

Stokke Customer service to order a replacement.

• If the chair is used with a tray, the tray is not designed to

hold the child in the chair.

Rough surfaces (uneven oors ), for instance rugs and tiles

To prevent the Tripp Trapp® chair from tilting when pushed backwards,

it has plastic gliders underneath the legs. Their function is to enable

the chair to slide backwards and return to an upright position when

pushed backwards. To make sure that the gliders function as intended,

the chair should be placed on a surface enabling the chair to slide

backwards. Thus, the surface should be level, stable and with a certain

hardness. Uneven and/or rough surfaces, for instance some tiled oors,

and rugs/carpets that are soft or with long loose ends, are generally

unsuitable for chairs used by toddlers. Although the Tripp Trapp® chair

is recognized for its stability, these conditions also apply here.

The gliders as well as the oor must be kept clean.

To further increase the backward stability of the Tripp Trapp® highchair,

a replaceable, extended rear glider (“Extended Glider”) has been devel-

oped for the Tripp Trapp® highchair. For the period when the chair

is used with a harness or the Tripp Trapp® Baby Set, we recommend

that you always use it with the Tripp Trapp® Extended Glider. This is

especially important if the chair is placed on a soft carpet and/or at a

table where the child can push against a frame underneath the table-

top with its feet.

Warning

NEVER let your child

play around the

Tripp Trapp® chair

if it is not in the

intended position

for use.

Table

Be aware of the risk that a big frame under

the table top makes it easier for children

to push their legs against the table and tilt

backwards. Also note that Tripp Trapp® is

designed for dining tables

28-30” (72-76cm) high.

Warning

When the footrest

is positioned close

to the metal rod,

there will be a small

gap between the

inside of the chair

legs and the metal

rod. This is perfectly

normal. Never try to

use excessive force to make the metal rod

touch the side legs of the chair as this can

cause damage to the chair and/or make it

unstable.

Footrest

Make sure the forward edge of the footrest

NEVER exceeds the front tip of the chair legs

at oor level. This may cause the chair to be

unstable when a child climbs in and out of

the Tripp Trapp® chair.

WARNING!

Prevent serious injury or death from falls or sliding out

US/CA

READ CAREFULLY BEFORE ASSEMBLING

YOUR TRIPP TRAPP® CHAIR.

On the fold out page of this user guide you will nd

pictures that describe the assembly of your Tripp Trapp®

chair and Tripp Trapp® Baby Set. The Baby Set should only

be used with the seat plate in the rst groove from top

of the chair.

Parts

10 Metal screws • 6 Metal nuts • 1 Allen Key • 2 Curved backrests

2 Metal cross bars • 1 Wooden base cross bar • 1 Seat • 1 Foot-

rest • 2 Legs

1. Attach the base cross bar to the legs (grooves face

inside). Important to insert the shallow end of nut rst!

2. Insert screws and tighten rmly.

3. Attach the two metal crossbars and tighten loosely

4. Attach the two curved back rests. Insert metal nut with

shallow end rst and tighten loosely. NOTE: Backrest

with strap goes into bottom slots.

5. Slide seat and footrest into slots, with straight edge

facing forward. Make sure the height and depth of the

seat and footrest suit the size of your child (see instruc

tions for seat and footrest adjustments in this user

guide).

6. Place the chair on a level surface. Finally tighten

all screws rmly in the order given.

SEAT AND FOOTREST ADJUSTMENT

It is important to adjust the depth and height of the seat

and footrest to t the size of your child. See illustrations

on the fold out page, and description below. The settings

of the seat and footrest should be checked as the child

grows – at least once a year!

The seat plate and the footrest must be supported by

the full length of the grooves on the sides (not half way

supported).

Seat placement

Height – The seat is set at the correct height when your

child’s elbows are level with the table top.

Depth – For correct depth of the seat, position the child’s

back against the backrest with the seat supporting ¾

of the thighs. For the child’s best comfort it is important

that the seat depth is not too deep. Leave comfortable

space between the front edge of the seat and back of the

child’s knee.

For a child 6-8 months it may amaze you how small seat

they actually need! The seat plate should not protrude

more than 1½-2” (4-5cm) in front of the chair side legs.

Footrest placement

Height – The footrest is set at the correct height when

the sole of the child’s foot can rest at on the footrest,

while the thighs are touching the seat.

Depth – Make sure the forward edge of the footrest

NEVER exceeds the front tip of the chair legs at oor level

Table of age and approxmate adjustment

This table is a rough guide for the height adjustment of

seat and footrest according to the age of you child. Child

dier in size according to age, so always make sure that

your child is seated correctly according to the instruc-

tions given in this user guide.

*) Use footrest as seat. Therefore seat is not applicable.

RESTRAINT SYSTEM OPERATION

Always use the restraint system when the seat is in the

1st, 2nd or 3rd grooves from the top. Place child in seat.

Pull each arm through the loop formed by the shoulder

and waist strap, and place in child’s lap. Crotch strap

comes up between child’s legs. Attach each shoulder

strap to the crotch strap. Adjust length of shoulder, waist

and crotch strap to restrain child in seat. Crotch strap

length should be adjusted so that connector is at waist

height.

The restraint system can be removed when your child has

reached the age of 36 months AND is able to sit safely

on TRIPP TRAPP®. Use a tool to remove the clip under the

seat plate to detach the crotch strap. Use a screwdriver to

detach the rest of the harness from the backrest.

Product information: The chair is made of cultivated

beech wood. The varnish contains no harmful sub-

stances, and the liberation of formaldehyde from the

varnish complies with E1 requirements.

Safety approval: Tripp Trapp® chair complies with AS

4684:2009 in combination with Tripp Trapp® Baby Set™/

Tripp Trapp® Newborn Set™ and ASTM F404-14.

CLEANING AND MAINTENANCE

Wipe with a clean damp cloth, wipe o excess of water

with a dry cloth. Moisture will crack stain. We do not rec-

ommend the use of any detergent or micro bre cloth.

Colours may change if the chair is exposed to the sun.

AGE SEAT FOOTREST

6 months 1 5

1 1/2 year 2 6

3 year 2 8

7 year 3 11

10 year 4 14

Teen/ Adult n.a. 4-5*

Tripp Trapp® Cushion

Comes in several colours

and designs. It ts your Tripp

Trapp® chair both with and

without Tripp Trapp® Baby

Set.

Tripp Trapp® Babyset

Babyset intended for

children from 6 months

and up to 36 months.

Accessories

Product specificaties

Merk:	Stokke
Categorie:	Kinderstoelen
Model:	Tripp Trapp
Kleur van het product:	Wit
Gewicht:	7000 g
Breedte:	460 mm
Diepte:	490 mm
Hoogte:	790 mm
Makkelijk schoon te maken:	Ja
Aanbevolen leeftijd (max):	36 maand(en)
Aanbevolen leeftijd (min):	0 maand(en)
Riem vastmaak systeem:	3 punten
Voetensteun:	Ja
Aantal voetsteunen:	5