Speco Technologies O4P25X Handleiding

Speco Technologies Bewakingscamera O4P25X

Lees hieronder de 📖 handleiding in het Nederlandse voor Speco Technologies O4P25X (64 pagina's) in de categorie Bewakingscamera. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/64

User Manual

4MP PTZ Network Camera

O4P25X

Please read this instruction carefully before operating the unit keep it for further reference and

1. Electrical safety

All stallation and operation in here should conform o cal electrical t lo safety codes.

Us a e certified/list 12VDC/DC24V/AC24 power upply onl . ed V s y

Please note: Do not connect two powe supplyi sour to the devi at the same time; it may result i devi damage! The r ng ces ce n ce

product must grounde to be d reduce the isk r of electri shock. c

Improper dling /or stallation could run han and in th risk o fir or electrical hock. e f e s

2. Environment

Heavy exposure stress, violent vibration or to water storage, and is not allowed during transportation, installation.

Do product extreme temperature conditions. not install the in

Do expose the not camera to electromagnetic sensor radiation. Otherwise, it may result in CMOS failure.

Do openings. not block any ventilation

Do the camera. not allow water and liquid intrusion into

3. Operation and Daily Maintenance

Please shut the device down and then unplug any the power cable before you begin maintenance work.

Do touch the CMOS not sensor optic component. You can a blower the dust lens use to clean on the surface.

Always use the dry soft cloth to clean the device. there is too much dust, use cloth dampened with small quantity of If a a

neutral detergent. Finally the use dry cloth to device. clean the

Please use professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) a

may result functionality and/or in poor IR IR reflection.

The grounding the recommended to be grounded to holes of product are further enhance the reliability of camera. the

Dome cover is an optical device, please do not touch or wipe cover surface directly during installation and use, please refer to

the following methods if dirt is found.

Stained with dirt:

Use oil-free soft to remove it brush or hair dryer gently.

Stained with grease or fingerprint.

Use oil-free cotton cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change the cloth

and wipe several times if it is not clean enough.

Warning

This camera should be installed by qualified personnel only.

All the examination and repair work should be done by qualified personnel.

Any unauthorized changes or modifications could void the warranty.

Statement

This guide is for reference only.

Product, manuals, and specifications may be modified without prior notice. Speco Technologies reserves the right to modify these

without notice and without incurring any obligation.

Speco Technologies is not liable for any loss caused by improper operation.

Regulatory Information

FCC conditions:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

⚫ This device may not cause harmful interference.

⚫ This device must accept any interference received, including interference that may cause undesired operation.

FCC compliance:

This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

⚫ Reorient or relocate the receiving antenna.

⚫ Increase the separation between the equipment and receiver.

⚫ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Note:

Before installation, check the package and make sure that all components are included.

Contact your rep or Speco customer service department immediately if something is broken or missing in the package.

Product specificaties

Merk:	Speco Technologies
Categorie:	Bewakingscamera
Model:	O4P25X

Heb je hulp nodig?

Als je hulp nodig hebt met Speco Technologies O4P25X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Bewakingscamera Speco Technologies

Speco Technologies O2VLB7 Handleiding

27 Mei 2024

Speco Technologies VLDT3GM Handleiding

6 Juli 2023

Speco Technologies CVC624WDR Handleiding

1 Juli 2023

Speco Technologies O4iB2M Handleiding

30 Juni 2023

Speco Technologies ZIPTW4B1 Handleiding

27 Juni 2023

Speco Technologies O2ID21M Handleiding

26 Juni 2023

Speco Technologies Intensifier 2 CVC6246iHR Handleiding

26 Juni 2023

Speco Technologies O4DT1 Handleiding

25 Juni 2023

Speco Technologies O4iB2 Handleiding

25 Juni 2023

Speco Technologies O8D8M Handleiding

22 Juni 2023

Handleiding Bewakingscamera

Nieuwste handleidingen voor Bewakingscamera

Honeywell HC35WE5R3 Handleiding

20 December 2024

Honeywell Performance H4W8PER2V Handleiding

20 December 2024

Hikvision DS-2CE12KF3T-LS Handleiding

18 December 2024

Hikvision DS-2CE78D0T-LXTS/A Handleiding

18 December 2024

TP Link VIGI C450 Handleiding

18 December 2024

Hikvision DS-2CE76U0T-LPF Handleiding

18 December 2024

Hikvision DS-2CE78U0T-LF Handleiding

18 December 2024

Hikvision DS-2CE16U0T-LPF Handleiding

18 December 2024

Hikvision DS-2CE72KF3T-LSYE Handleiding

18 December 2024

Hikvision DS-2CE17U0T-LF Handleiding

18 December 2024