Speco Technologies O2D3 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Speco Technologies O2D3 (39 pagina's) in de categorie Bewakingscamera. Deze handleiding was nuttig voor 68 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/39
ONSIP 02P3
O
ON
NS
SI
IP
P
O
O2
2D
D3
3
O
Ow
wn
ne
er
r
s
s
M
Ma
an
nu
ua
al
l
Rev.1 (Nov., 2011) .0
2
Note
This equipment has been tested and found to comply with the limits for a Class a digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generate, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into and outlet on a circuit dierent from that to which the receiver is
connected
Consult the dealer or an experienced radio/TV technician for help.
Dire
Dire
Dire
DireDirections
ctions
ctions
ctionsctions
Be careful not to cause any physical damage by dropping or throwing ONSIP O2D3. Especially keep the
device out of reach from children.
Do not disassemble ONSIP O2D3. No After Service is assumed when disassembled.
Use only the power adapter provided with ONSIP O2D3.
Be careful to prevent moisture or water penetration into the unit. Particular attention is needed when
installing ONSIP O2D3. The screw holes for the installation screws and pipe should be maintained water
tight during the whole life time of the product.
All the electrical connection wires running into the unit should be prepared so that water from the outside
cannot ow into the unit through the surface of the wires. Penetration of the moisture through the wire for
extended period can cause malfunction of the unit or deteriorated image.
O
ON
NS
SI
IP
P
O
O2
2D
D3
3
O
Ow
wn
ne
er
r
s
s
M
Ma
an
nu
ua
al
l
Rev.1 (Nov., 2011) .0
3
Revision History
Date
Revision
20 0111 11- -
1.0
Caution
Any changes or modications in construction of this device which are not explicitly approved by the party
responsible for compliance could void the users authority to operate the equipment.


Product specificaties

Merk: Speco Technologies
Categorie: Bewakingscamera
Model: O2D3

Heb je hulp nodig?

Als je hulp nodig hebt met Speco Technologies O2D3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Bewakingscamera Speco Technologies

Handleiding Bewakingscamera

Nieuwste handleidingen voor Bewakingscamera