Sharp XV-Z20000 Handleiding
Lees hieronder de š handleiding in het Nederlandse voor Sharp XV-Z20000 (69 pagina's) in de categorie Beamers. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/69
XV-Z20000/
DT-5000
OPERATION MANUAL
MODE DāEMPLOI
MANUAL DE MANEJO
MANUAL DE OPERAĆĆO
PROJECTOR
PROJECTEUR
PROYECTOR
PROJETOR
ENGLISH FRANĆAIS ESPAĆOL PORTUGUĆS
ENGLISH
-1
Before using the projector, please read this operation manual carefully.
WARNING: High brightness light source. Do not stare into the beam of light, or view directly. Be especially
careful that children do not stare directly into the beam of light.
WARNING: To reduce the risk of ļ¬ re or electric shock, do not expose this product to rain
or mois ture.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER.
NO USER-SERVICEABLE PARTS EXCEPT LAMP UNIT.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning ļ¬ ash with arrowhead sym bol,
within an equilateral triangle, is in tended to
alert the user to the presence of uninsulated
ādangerous voltageā within the productās
enclosure that may be of sufļ¬ cient magnitude
to constitute a risk or electric shock to
persons.
The exclamation point within a triangle is
intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
product.
Introduction
CAUTION
See bottom of projector.
IMPORTANT
ā¢ For your assistance in reporting the loss or theft of
your Projector, please record the Serial Number lo-
cated on the bottom of the projector and retain this
information.
ā¢ Before recycling the packag ing, please ensure that
you have checked the con tents of the carton thor-
oughly against the list of āSupplied accessoriesā on
page .4
Model No.: XV-Z20000/DT-5000
Serial No.:
WARNING: FCC Regulations state that any unauthorized changes or modiļ¬ cations to this equipment not ex-
pressly approved by the manufacturer could void the userās authority to operate this equip ment.
U.S.A. ONLY
RISK OF ELECTRIC SHOCK.
DO NOT REMOVE SCREWS
EXCEPT SPECIFIED USER
SERVICE SCREW.
WARNING:
The cooling fan in this projector continues to run for about 90 seconds after the projector enters standby mode. Dur-
ing normal operation, when putting the projector into standby mode always use the STANDBY button on the pro-
jector or the STANDBY button on the remote control. Ensure the cooling fan has stopped before disconnecting the
power cord.
DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD.
FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE.
-2
Caution Concerning Lamp Replacement
See āRegarding the Lampā on page .48
PRODUCT DISPOSAL
This projector utilizes tin-lead solder, and a pressurized lamp containing a small amount of mercury. Disposal of
these materials may be regulated due to environmental considerations. For disposal or recycling information, please
contact your local authorities or, if you are located in the United States of America, the Electronic Industries Alliance:
www.eiae.org.
This SHARP projector uses a DLPĀ® chip. This very sophisticated panel contains 2,073,600 pixels (micromirrors). As
with any high technology electronic equipment such as large screen TVs, video systems and video cameras, there
are certain acceptable tolerances that the equipment must conform to.
This unit has some inactive pixels within acceptable tolerances which may result in inactive dots on the picture
screen. This will not affect the picture quality or the life expectancy of the unit.
INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the operation manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
ā¢ Reorient or relocate the receiving antenna.
ā¢ Increase the separation between the equipment and the receiver.
ā¢ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
ā¢ Consult the dealer or an experienced radio/TV technician for help.
Declaration of conformity
SHARP PROJECTOR, MODEL XV-Z20000/DT-5000
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Responsible Party:
SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430-2135
TEL: 1-800-BE-SHARP (1-800-237-4277)
U.S.A. ONLY
U.S.A. ONLY
ā¢ The DLPĀ® logo, the DLPĀ® medallion and BrilliantColorā¢ are trade marks of Texas Instruments.
ā¢ MicrosoftĀ®
and WindowsĀ® are registered trade marks of Microsoft Corporation in the Unit ed States and/or other
countries.
ā¢ PC/AT is a registered trademark of In ter national Business Ma chines Cor poration in the United States.
ā¢ MacintoshĀ® is a registered trademark of Apple Computer, Inc. in the United States and/or other countries.
ā¢ HDMI, the HDMI logo and High-Deļ¬ nition Multimedia Interface are trademarks or reg istered trademarks of
HDMI Licensing LLC.
ā¢ All other company or product names are trademarks or registered trademarks of their re spective companies.
ā¢ Some IC chips in this product include conļ¬ dential and/or trade secret property belonging to Texas Instru-
ments. Therefore you may not copy, modify, adapt, translate, distribute, reverse engineer, reverse assemble or
discompile the contents thereof.
Product specificaties
| Merk: | Sharp |
| Categorie: | Beamers |
| Model: | XV-Z20000 |
Heb je hulp nodig?
Als je hulp nodig hebt met Sharp XV-Z20000 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Beamers Sharp
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
Handleiding Beamers
- Beamers Philips
- Beamers Sony
- Beamers Samsung
- Beamers Panasonic
- Beamers Epson
- Beamers Asus
- Beamers JVC
- Beamers Toshiba
- Beamers Acer
- Beamers Barco
- Beamers Bauer
- Beamers BenQ
- Beamers Dell
- Beamers Eiki
- Beamers Hitachi
- Beamers InFocus
- Beamers Klarstein
- Beamers Kodak
- Beamers Mitsubishi
- Beamers Nec
- Beamers Pyle
- Beamers Ricoh
- Beamers Salora
- Beamers Sanyo
- Beamers Viewsonic
- Beamers Optoma
- Beamers 3M
- Beamers Planar
Nieuwste handleidingen voor Beamers
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022