3M PX5 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor 3M PX5 (95 pagina's) in de categorie Beamers. Deze handleiding was nuttig voor 90 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/95
E-1
IMPORTANT
Digital Light Processing, DLPâ„¢, Digital Micromirror Device and DMD are all trademarks of Texas
Instruments.
Other names of companies and products mentioned are trademarks and registered trade-marks of
the respective companies. ™, ® and © marks are not used in this document.
Introduction
Congratulations on your purchase of the Projector.3Mâ„¢ Digital
Please read the USER’S MANUAL (Simplified Edition) and the USER’S MANUAL (CD-
ROM Edition) carefully and use the projector properly. After reading, please store in a safe
place.
Digital Projector
PX5
USER’S MANUAL (Simplified Edition)
E-2
IMPORTANT SAFETY INFORMATION
DECLARATION OF CONFORMITY
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
U.S. Responsible Party:
Address:
Tel. No.:
3M Austin Center
Building A145-5N-01 6801 River Place Blvd.
Austin, TX 78726-9000
800-328-1371
Type of Product:
Equipment Classification:
Models:
Projector
Class B Peripheral
PX5
We hereby declare that the equipment specified above
conforms to the technical standards as specified in the FCC Rules.
DOC compliance Notice
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equip-
ment Regulations.
RF Interference
WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorientate or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
E-3
IMPORTANT SAFETY INFORMATION
This symbol warns the user that uninsulated voltage within the unit may have sufficient
magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact
with any part inside of this unit.
This symbol alerts the user that important literature concerning the operation and mainte-
nance of this unit has been included. Therefore, it should be read carefully in order to avoid
ony problems.
The above cautions are given on the bottom of the product.
CAUTION
TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED 3Mâ„¢ SERVICE PERSONNEL.
Hg: Lamp in This Product Contains Mercury. Dispose of Lamp According to Local, State or Federal Law.
Important Safeguards
These safety instructions are to ensure the long life of the unit and to prevent fire and
shock. Please read them carefully and heed all warnings.
Installation
• For best results, use the unit in a darkened room.
• Place the unit on a flat, level surface in a dry area away from dust and moisture.
• Do not place the unit in direct sunlight, near heaters or heat radiating appliances.
• Exposure to direct sunlight, smoke or steam can harm internal components.
• Handle the unit carefully. Dropping or jarring can damage internal components.
• Do not place heavy objects on top of the unit.
Power Supply
• The unit is designed to operate on a power supply of 100-240 V 50/60 Hz AC. Ensure that your
power supply fits these requirements before attempting to use the unit.
• Handle the power cable carefully and avoid excessive bending. A damaged cord can cause electric
shock or fire.
• Disconnect the power cable (main’s lead) from the power outlet after using the unit.
Before disconnecting the power cable, make sure that the STANDBY indicator lights in amber (not
blinking or in green).
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. DO
NOT USE THIS UNIT’S GROUNDED PLUG WITH AN EXTENSION CORD OR IN AN OUTLET
UNLESS ALL THREE PRONGS CAN BE FULLY INSERTED. DO NOT OPEN THE CABINET.
THERE ARE HIGH-VOLTAGE COMPONENTS INSIDE. ALL SERVICING MUST BE DONE BY
QUALIFIED 3M SERVICE PERSONNEL.
Product specificaties
| Merk: | 3M |
| Categorie: | Beamers |
| Model: | PX5 |
Heb je hulp nodig?
Als je hulp nodig hebt met 3M PX5 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Beamers 3M
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
Handleiding Beamers
- Beamers Philips
- Beamers Sony
- Beamers Samsung
- Beamers Panasonic
- Beamers Epson
- Beamers Asus
- Beamers JVC
- Beamers Toshiba
- Beamers Acer
- Beamers Barco
- Beamers Bauer
- Beamers BenQ
- Beamers Dell
- Beamers Eiki
- Beamers Hitachi
- Beamers InFocus
- Beamers Klarstein
- Beamers Kodak
- Beamers Mitsubishi
- Beamers Nec
- Beamers Pyle
- Beamers Ricoh
- Beamers Salora
- Beamers Sanyo
- Beamers Sharp
- Beamers Viewsonic
- Beamers Optoma
- Beamers Planar
Nieuwste handleidingen voor Beamers
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022
4 Oktober 2022