Serge Ring Handleiding


Lees hieronder de šŸ“– handleiding in het Nederlandse voor Serge Ring (6 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/6
RANDOM*SOURCE
RANDOMSOURCE.NET 1
Serge RING
SERGE
Ring Modulator 2017
(RING) for Eurorack
The 2017 RING is an improved version of the late Serge
Ring Modulator (R9), designed by Serge himself for
Random*Source in 2017, more than 40 years after the
launch of the Serge Modular system.
To quote the Serge 1983 catalogue:
ā€œOur new RING MODULATOR (RING) is a brand
new design which incorporates greatly improved
speciī˜Ÿcations . Features include the following:
ā€¢ī˜ A VERY CLEAN SOUND down to very low
signal levels (unlike conventional modulators where distortion increases at low levels) .
ā€¢ī˜ 80 dbs OF CARRIER SIGNAL REJECTION.
ā€¢ī˜ INAUDIBLE NOISE OUTPUT .
ā€¢ī˜ NO SQUELCH CIRCUIT IS REQUIRED due to the low noise therefore annoying signal dropouts
and ā€œpumpingā€ effects are totally absent.
ā€¢ī˜ INTERNAL WAVESHAPING OF CARRIER to add to modulation effects.
ā€¢ī˜ The sum total of these design improvements is a Ring Modulator capable of treating the most subtle
acoustical signals, without the coloration typically associated with even the best previously available
ring modulators.
The versatility of the Serge Ring Modulator is enhanced by the added feature of voltage and manual control
of the entire spectrum of modulation possible: from zero modulation (i.e. the original, un-treated input
signal) through amplitude modulation to full ring modulation. This allows many shadings of effect, manual or
automatic with voltage controls. The ability to control the Carrier level manually and through voltage control
allows the output to be level controlled, as well. -Through the use of an internal signal processor for the
Carrier, additional effects can be produced by waveform modiī˜Ÿcation of the carrier signal. When the module
is set to full Ring Modulation from the lower knob or voltage control, the output signal contains the sum and
RANDOM*SOURCE
RANDOMSOURCE.NET 2
Serge RING
difference frequencies of the Signal Input and the Carrier Input. If both signals are pure sine waves (only
one frequency component), the output will be a composite signal consisting two frequency components:
the sum and the difference frequency of the Signal and Carrier. If the Carrier level is increased beyond the
mid-position, then the carrier waveform will become slightly rounded, and new frequency components will
be produced. Each of these new components will also modulate with the Signal input to produce a sum
and difference frequency, and the output signal will become richer in harmonics. This effect. is unique to the
Serge Ring Modulator, and allows another dimension in timbral modiī˜Ÿcation.
The Random*Source version of the RING for Euro is a licensed and authorized implementation of the new origi-
nal Serge design.
The Random*Source RING kit consists of a front panel and a pcb set with all SMT parts preinstalled. A couple of
through-hole parts (mostly capacitors) have to be installed (1uF caps only if not already installed in SMT!).
RANDOM*SOURCE
RANDOMSOURCE.NET 3
Serge RING
Pleaseī˜note:
ā€¢ī˜ Theī˜RINGī˜requiresī˜carefulī˜calibrationī˜forī˜bestī˜results.ī˜Aī˜2-channelī˜oscilloscopeī˜isī˜higlyī˜recommended,ī˜
ifī˜notī˜required.ī˜ī˜
ā€¢ī˜ Theī˜moduleī˜requiresī˜aī˜coupleī˜ofī˜largerī˜capacitorsī˜(10uFī˜andī˜4.7uF)ī˜andī˜providesī˜footprintsī˜forī˜WIMAī˜
ī›½lmī˜caps.ī˜Youī˜shouldī˜beī˜ableī˜toī˜substituteī˜otherī˜typesī˜(e.g.ī˜bipolarī˜electrolyticsī˜forī˜audioī˜use),ī˜however,ī˜
theseī˜areī˜untested.
ā€¢ī˜ ī˜inī˜(1uF,ī˜blackī˜andī˜silverī˜cubes)ī˜-ī˜If the main pcb already includes 3 large SMT capacitors
mostī˜likelyī˜thisī˜isī˜theī˜caseī˜-,ī˜youī˜doī˜notī˜needī˜toī˜installī˜anyī˜1uFī˜capacitorsī˜inī˜through-holeī˜-ī˜i.e.ī˜you
can leave the corresponding 1uF through-hole footprints empty.
ā€¢ī˜ Useī˜antistaticī˜precautionī˜-ī˜tryī˜toī˜avoidī˜touchingī˜theī˜SMTī˜parts.
ā€¢ī˜ Boardī˜isī˜designedī˜toī˜beī˜poweredī˜byī˜aī˜+/-12Vī˜stabilizedī˜PSUī˜only.ī˜(+/-15Vī˜isī˜untested).
Billī˜ofī˜Materials
Capacitors (min. 35V, 5mm lead spacing)
310uF FILMī˜/ī˜PET,ī˜5mm WIMAī˜MKS2B051001N00JSSDī˜(5%ī˜recommended)ī˜
14.7uF FILMī˜/ī˜PET,ī˜5mm WIMAī˜MKS2ī˜orī˜similar,ī˜5%ī˜recommended
3ī˜1uF FILMī˜/ī˜PET,ī˜5mm WIMAī˜MKS2ī˜orī˜similarī˜-ī˜ONLYī˜IFī˜NOTī˜ALREADYī˜INSTALLEDī˜
INī˜SMT!
Trimmpots
11k Multiturn e.g.ī˜Bournsī˜3296Y-1-102LFī˜orī˜Vishayī˜T93YB102KT20
1100k Multiturn e.g.ī˜Bournsī˜3296Y-1-104LFī˜orī˜Vishayī˜
1100k Single-Turn e.g.ī˜Bournsī˜3362P-1-104LFī˜orī˜whateverī˜ī›½ts)ī˜
Misc
1Euroī˜Powerī˜
headerī˜
MTA-100ī˜powerī˜connector,ī˜Reichelt:ī˜WSLī˜10G
5 Thonkiconnī˜
Jacks
3.5mmī˜Jackī˜Socketsī˜(PJ301M-12)ī˜fromī˜Thonk
4ī˜ Potentionmeterī˜
50k
linearī˜(B50K) Alphaī˜9mmī˜verticalī˜pcbī˜mountī˜
availableī˜fromī˜Thonk,ī˜Tayda,ī˜Mouserī˜...ī˜
B100Kī˜shouldī˜alsoī˜work
1Resistorī˜22kī˜orī˜
24k
OPTIONALī˜toī˜adjustī˜theī˜taperī˜ofī˜theī˜
MODEī˜potī˜
Canī˜beī˜eitherī˜THī˜(0207)ī˜orī˜SMTī˜(0805,ī˜1206)
1ī˜
1ī˜
SILī˜headerī˜6polī˜
SILī˜headerī˜5polī˜orī˜4polī˜(checkī˜markingsī˜ifī˜usingī˜4pol)
pinī˜connectors,ī˜linkingī˜mainī˜pcbī˜toī˜componentī˜
pcbī˜-ī˜usingī˜precisionī˜stripsī˜allowsī˜toī˜breakī˜offī˜
piecesī˜asī˜needed
4 Spacersī˜+ī˜8ī˜matchingī˜screwsī˜(M3) 10mmī˜orī˜whateverī˜matchesī˜theī˜SILī˜headersī˜/ī˜
connectors


Product specificaties

Merk: Serge
Categorie: Niet gecategoriseerd
Model: Ring

Heb je hulp nodig?

Als je hulp nodig hebt met Serge Ring stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Serge

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd