Satel ASP-105 Handleiding

Satel Beveiliging ASP-105

Lees hieronder de 📖 handleiding in het Nederlandse voor Satel ASP-105 (4 pagina's) in de categorie Beveiliging. Deze handleiding was nuttig voor 55 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
ASP-100
WIRELESS OUTDOOR SIREN
asp-100_en 03/18
The ASP-100 wireless siren provides information about alarm situations by means of optical and
acoustic signaling. The siren is designed for operation within the ABAX two-way wireless system. This
manual applies to the siren with firmware version 1.00, which is supported by ACU-120 and ACU-270
controllers with firmware version 5.02.
Notes:
ï‚· Up to 8 ASP-100 sirens can be registered in the controller.
ï‚· The siren is not supported by the ACU-100 and ACU-250 controllers, ARU-100 radio signal
repeater and INTEGRA 128-WRL control panel.
1. Features
ï‚· Acoustic signaling by means of piezoelectric transducer.
ï‚· Optical signaling by means of LEDs.
ï‚· Remote configuration.
ï‚· Power supply from 3.6 V lithium thionyl chloride battery.
ï‚· Battery status control.
ï‚· Weatherproofed electronic circuit.
ï‚· Tamper protection against cover removal and tearing enclosure from the wall.
ï‚· High-impact polycarbonate enclosure, featuring a very high mechanical strength.
2. Specifications
Operating frequency band ................................................................................ 868.0 MHz ÷ 868.6 MHz
Radio communication range (in open area).......................................................................... up to 500 m
Battery................................................................................................................. ER34615 3.6 V / 13 Ah
Battery life expectancy..................................................................................................... up to 2.5 years
Standby current consumption ..........................................................................................................2 mA
Maximum current consumption......................................................................................................65 mA
Sound pressure level (at 1 m distance) ...............................................................................up to 105 dB
Environmental class according to EN50130-5 ....................................................................................IIIA
Operating temperature range........................................................................................... -40C …+55C
Maximum humidity ........................................................................................................................ 93±3%
Dimensions ................................................................................................................148 x 254 x 64 mm
Weight............................................................................................................................................. 860 g
Hereby, SATEL sp. z o.o., declares that this siren is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU. The declaration of
conformity may be consulted at www.satel.eu/ce
2 ASP-100 SATEL
3. Description
Explanations for Fig. 1:
enclosure cover.
enclosure base.
battery cover.
piezoelectric transducer.
antenna.
Never shorten or deform the antenna.
tamper switch (tamper alarm triggered if open).
battery connector.
electronics module.
cover locking screws.
Triggering the alarm signaling
The alarm signaling is triggered:
 on receiving a radio command from the controller – optical and acoustic signaling are controlled
independently,
 on opening the tamper switch – both optical and acoustic signaling is triggered. Opening the
tamper switch will not trigger the alarm in the following cases:
 for 10 minutes after connecting the battery,
 when the control panel is running in service mode (a few seconds delay may occur between
entering the service mode and blocking the tamper signaling)
When the tamper signaling is blocked, the leftmost LED is blinking every 3 seconds.
Duration of the signaling and type of the acoustic signaling are remotely programmable.
SATEL ASP-100 3
1 Two sound frequencies (1450 Hz/2000 Hz) alternating within 1 second
2 Sound with rising frequency (from 1450 Hz to 2000 Hz) within 1 second
3 Sound with smoothly rising and falling frequency (1450 Hz – 2000 Hz –
1450 Hz) within 1 second
4 Sound with falling frequency (from 2000 Hz to 1450 Hz) within 1 second
Table 1. Tone types for acoustic signaling.
Power supply
The siren is powered from a 3.6 V lithium thionyl chloride battery. It is a high-current battery,
characterized by high capacity. The battery is offered by SATEL.
Given the specific nature of the battery, it must be properly initialized to reach the required
performance. The battery initialization procedure starts automatically after first-time
connection of the battery. During battery replacement, follow the procedure described at the
end of this manual to initialize a new battery.
When initializing a battery, the leftmost LED on the siren is blinking every second. The siren will not
be ready for operation until the battery initialization procedure is completed.
The siren informs about low battery.
Periodic transmissions
Every 15 minutes, the siren sends a transmission with information on the current status of the tamper
switch and battery. Periodic transmissions are used to monitor presence and operation of the siren.
Note: If any value different from 0 is programmed for the
F
ILTER
parameter for the ASP-100 siren,
the lack of presence will be reported if no transmission from the detector is received within one
hour.
Enclosure base
Explanations for Fig. 2:
mounting hole.
tamper mounting hole.


Product specificaties

Merk: Satel
Categorie: Beveiliging
Model: ASP-105

Heb je hulp nodig?

Als je hulp nodig hebt met Satel ASP-105 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Beveiliging Satel

Handleiding Beveiliging

Nieuwste handleidingen voor Beveiliging