Russell Hobbs Carving Knife 13892 Handleiding

Russell Hobbs Mes Carving Knife 13892

Lees hieronder de šŸ“– handleiding in het Nederlandse voor Russell Hobbs Carving Knife 13892 (8 pagina's) in de categorie Mes. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
instructions
Read the instructions and keep them safe. If you pass the appliance on, pass on the
instructions too. Remove all packaging, but keep it till you know the appliance works.
important safeguards
Follow basic safety precautions, including:
1 This appliance must only be used by a responsible adult.
2 Donā€™t put the handle in liquid, donā€™t use it in a bathroom, near water,
3 Donā€™t use the knife in the presence of children. Their movements are
unpredictable, they may jog your arm or bump into you inadvertently.
4 Unplug the knife from the power socket before attaching or removing
blades and before cleaning.
5 After use, clean the blades, replace them in their protective sleeve, and store them
out of the reach of children.
6 The blades are extremely sharp, donā€™t leave them lying around where they may be
touched accidentally by you or anyone else.
7 Donā€™t try to cut bone or frozen food. The blades may slip and cause serious injury. It
may also damage the blades.
8 Donā€™t use the other hand to steady the food being cut. Use a carving fork.
9 Route the cable so that it canā€™t catch on anything or get in the way of the blades
while in use.
10 Donā€™t apply pressure to the knife and donā€™t use a sawing action. Simply guide it
through the food, letting the motor do all the work.
11 When you ļ¬nish, unplug the knife ļ¬rst, then remove the blades.
12 Donā€™t leave the knife unattended, especially where children may reach it.
13 Donā€™t use the same set of blades on raw and cooked meat without washing them
thoroughly between uses.
14 Use a cutting board to avoid damage to the blades and to the work surface.
15 Donā€™t use the knife for any purpose other than cutting food.
16 Donā€™t let the cable touch hot surfaces.
17 Donā€™t run the knife continuously for more than 5 minutes, to avoid overheating.
18 Donā€™t use the knife after it malfunctions or has been damaged in any way.
19 If the cable is damaged, return the knife, in order to avoid hazard.
household use only
2
3
preparation
1 Clear a space on your worktop or table so that the knife canā€™t hit anything and the
cable canā€™t catch on anything while youā€™re using it.
2 Put the cutting board on the worktop and have the carving fork within easy reach.
3 Remove all packaging from the food. Donā€™t use the knife to cut the packaging, you
may damage the blades.
4 Position the food on the cutting board.
ļ¬tting the blades
5 Keep the protective sleeve on the blades.
6 Hold the blades by the ļ¬nger grips.
7 Insert the free ends of the blades into the slots on the front of the body
and push gently till they click into place.
8 Lay the knife down on or near the cutting board.
9 Remove the protective sleeve from the blades.
10 Plug the knife into the power socket. If necessary,
switch the socket on.
11 Steady the joint with the carving fork.
cutting
12 Hold the knife as shown here.
13 Press the operating switch to set the blades
in motion. The switch is spring-loaded, the
knife will operate only while you hold the
switch down.
14 Cut away from your body.
15 Use a carving fork to steady the joint being cut ā€“ donā€™t use your other hand.
16 Donā€™t try to reposition the joint without putting the knife down ļ¬rst.
17 If the joint needs repositioning, release the switch, set the knife down, move the
joint, steady it with the carving fork ā€“ then pick the knife up again.
18 When you ļ¬nish, or if you need to stop cutting to do anything else, release the
switch, set the knife down, and unplug it.
19 Donā€™t use the knife for more than 15 minutes in any one session.
removing the blades
20 Release the switch, set the knife down, and unplug it.
21 Keep your hand away from the operating switch.
22 Press the blade release button.
23 Hold the blades by the ļ¬nger grips and
gently pull them out of their slots.
23 Keep your ļ¬ngers away from the edges of the blades.
cleaning the blades
25 One of the blades has a ā€œkeyholeā€ slot, the other has a rivet. To separate the blades,
slide the rivet along the slot to the large hole.
26 Wash the blades in hot soapy water, rinse, dry
thoroughly, then rejoin them and replace them in
their protective sleeve.


Product specificaties

Merk: Russell Hobbs
Categorie: Mes
Model: Carving Knife 13892

Heb je hulp nodig?

Als je hulp nodig hebt met Russell Hobbs Carving Knife 13892 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden